Jump to content
SAU Community

Recommended Posts

  • Replies 518
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

There is a group buy for R33 boots, and it is open at the moment.

Kroozin added you to the group buy, PM with payment information will be sent to everyone when we have enough members

Edited by pablo101
anyone got photos? I'd like to see what it looks like.

Do they do red stitching as well?

Here Ya go

never seen the ebay ones but these are very quality

post-13315-1181520731_thumb.jpg post-13315-1181520744_thumb.jpg post-13315-1181520756_thumb.jpg

click HERE for those attachments

Edited by Madaz

Hey Pabs,

Need new hand brake and gear boots, my new R33 came with torn ones (damn Bitches) if still availible will take one set :blink:

will also PM you ...... Thanks

Edited by immortal^

no worries guys added you all to the list!

once we have atleast 10 members I will PM everyone with bank details and make the right number order.

untill then we must wait for more members to join

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...