Jump to content
SAU Community

Recommended Posts

Due to unforeseen circumstances, Sarah Biggin has stepped down from the position of SAU-Vic Secretary.

As such, the committee are going to hold an emergency election at the next general meeting scheduled for Tues 17 April.

If you would like to stand for this position, you must have fulfilled the following criteria:

* Be an active member of SAU-Vic

* Must be at least 21 years old as of April 17 2007

We already have 3 runners for the position of Secretary. They are:

Caryn Lacey (Kaz180)

Melinda Blizzard (Min aka Scotsman's better half)

Alan Calleja (Al)

If you wish to stand for the role of Secretary, you will need to be nominated and seconded by 2 active members of SAU-Vic. You will then need to accept the nomination by 12pm Mon 16 April at the latest.

We will be holding a vote for the role of Secretary at the general meeting for all ordinary and life members.

Should you have any questions in regards to this process, please email the committee at [email protected]

Good luck people.

Link to comment
https://www.sau.com.au/forums/topic/164075-position-vacant~-secretary/
Share on other sites

  • Replies 57
  • Created
  • Last Reply

Top Posters In This Topic

As its an Exec position.

Without checking the constitution (cant till friday as i dont have a copy here)...

I would be of the belief it requires an EGM (extraordinary gen meeting) to decide, as it requires a vote.

That is the fair thing to do, being the rules are to be followed.

It isnt about handing stuff out to people just "because"

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...