Jump to content
SAU Community

Recommended Posts

I'm going to be installing a Sard (Single Pump) Surge Tank into my car (S13 Silvia), but I'm wanting to confirm the legalities of running this setup without sealing off the boot area. Is anyone able to point me to, or quote on the ADR's or NCOP's for this particular subject? I've looked in the NCOP Modifications for Light Vehicles Fuel Systems bulletin, and it mentions surge tanks, but nothing much else.

The reason for not wanting to seal the boot off is mainly because I'd like a little bit of doof in the form of a sub woofer. For this I can either drop the rear seats down (they fold down in an S13 Silvia) or just use the speaker holes in the rear parcel shelf as ports. If I have to seal the boot off, I would need to make a ported enclosure which keeps the sub box sealed off from the boot space completely.

I've been told that it's possible to have the surge tank in the boot, and not seal the boot as long as I run solid fuel lines...anyone know if this is actually true.

Any assistance would be greatly appreciated.

Cheers

Brendan

I doubt it, im pretty sure you arent allowed any fuel(or oil) system in the passenger compartment, by sealing off the boot, you stop it being part of the passenger compartment. You could put the surge tank/pump in a sealed box and vent it to the outside. The same rule excludes the use of mechanical oil pressure/fuel pressure gauges.

silvia isn't a hatch back though...

as long as the boot compartment is seperate from the passenger compartment (ie, like an R32 skyline and from memory silvia has a rear metal divider too) you should be fine. the type of line little to do with it, though solid lines or teflon lines are a good idea as they breathe less (less fumes wafting around).

I would consult an engineer in your state to be sure.

FYI, S13 Silvia, although not a hatchback (it's a coupe), it does has fold down seats with a hole from the boot through to the cabin - there's no steel divider there at all.

MANWHORE

Do you have any references about a fuel cell of any kind being in the passenger compartment.

Beer Baron

I will get to an engineer, but before having to part with the fold, I wanted to know if anyone else here had any experience.

Thanks

Brendan

Beer Baron

I will get to an engineer, but before having to part with the fold, I wanted to know if anyone else here had any experience.

Thanks

Brendan

Just phone an engineer and ask, much easier then having them go "No, I won't engineer this car because"

They're more then happy to answer a question or two if you ring them.

no lines in an r33 boot either, although the r33 and gtrs have the little hatch to access them.

i am running a surge tank in the boot of my 33 and am in the process of making a Alloy box to totally enclose the tank, pump and all lines so as to have them sealed to reduce fumes, and in the case of something failing, to have it drain to outside the car rather than inside.

I don't have those specific sections of legislation/adr on hand. I'm a bit busy atm, so don't have time to research it for you, but with a little bit of legal research skills, you'll be able to find it easily. I'm sure if you pay a lawyer they'll do it for you

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Well, yes, every CU on the bus is available via the Consult port, but whether the scanner you are using is capable of talking to the TCU, the ABS/TCS modules, etc etc, is what is at question here. Many of them are only for engine codes. So, if you have one of those, you won't know if the ABS is having a bitch.
    • That's now. R chassis Skylines come from a time when the tolerance in the ADRs was a bit more....slack. My car, on 235/35-17, which is damn near the exact same size as the original 205/55-16, is pretty much bang on correct indicated speed across the whole legal range. That's demonstrated with constant speed run over 5km, and GPS speed. It's just the luck of the draw. My particular speedo head has to be the thing that is "calibrated" that way, because everything else (the diff ratio, the gearbox and the speedo drive**) are all same same as most other Skylines. **OK, so the speedo drive is a Navara unit to drive the R32's cable, not the electronic unit than an R33/4 would normally have with teh same gear on it. Otherwise, I applaud your OCD tendencies, and I would do the same if I needed to.
    • Not too sure, I believe the Nissan consult port does everything? Also just filled up the reservoir to full and the light is still on. The float seems to move up and down fine.
    • The speedo's can be very conservative, when my Mazda NC MX5 speedo is showing 118kph, the GPS, and a calibrated radar.... cop mate.....hits me at around 110kph +/- 1 or 2 kph, and that is on a 215/45 17, stock tyres size is 205/45 17 as well, so weirdly conservative with stock tyre size When my Commodore speedo red 116kph GPS had me at 110kph on 255/40 17, so again conservative Google says manufacturers need to set the speedo from 4 to 10% slower than actual road speed.....for safety.....and compliance  After doing some offset and clearance measurements to see what can fit the NC on 17x8 +40, without guard rolling or rubbing anything at my current ride height, I've decided that when my tyres are toast, I'm going to fit 225/45 17 and see where that gets me IRT actual speed of my speedo and GPS/radar From the online calculator I should be still be doing around 5kph under an actual 110kph when the speedo is showing 110kph My ADHD requires that when I'm doing 110kph on the speedo, that the actual road speed is actually really close to that, and not alot slower And going from 205 to 225 still keeps the car within the %/mm allowable in the NSW vehicle rules and regulations, which is nice, as long as I'm looking at the latest version that is.....LOL https://www.nsw.gov.au/sites/default/files/2021-02/RMS-13.464-Light-vehicle-modifications-Vehicle-Standards-Information-No-6-November-2013.pdf
    • Take the value it measured as, and pick the closest range available that is above the reading on the screen.   Also, no point just testing the coils. Read what has been said again. You need to test all your wiring, everything.
×
×
  • Create New...