Jump to content
SAU Community

Recommended Posts

Hey, I've got a basically stock 92 r32 gts-t. Months and months ago i got a manual boost controller and turned the boost up to about 12-13psi and more recently i got a 3 inch exhaust with split dump and high flow cat.

It has always run great and loved to be thrashed. But last week on a f**king cold night, i gave it a hit (once the engine was fully warmed) and as the boost started to build, the engine choked. I lost all power and it felt like i was basically just rolling. I had to come off the accelerator to get the power back. This would happen late at nights and early in the morning when it is incredibly cold, but during the day it runs perfectly.

Me and my friend initially thought this was a matter of the stock fuel pump and injectors not being able to match the colder denser air now going into the engine. But the last few days i haven't been able to replicate the problem. It seems to be running fine even on the coldest nights.

What's going on? Why did i have this problem one week, but not the next?

Link to comment
https://www.sau.com.au/forums/topic/171190-power-cut-on-cold-nights/
Share on other sites

did the power cut happen above 4000rpm and was it a missfiring all the up the rev range?

I had similar problem and mechanic said it was crank angle sensor.

It could also be your coilpacks not handling the higher power from the dense air. Check coilpacks for hairline cracks.

sounds like boost cut to me. just means your hitting a point on your ECU map that it considers dangerous and cuts power to the engine. time for aftermarket management, or just take out ~1 PSI to avoid it. if there are other symptoms (like missfiiring through the rev range) could be the coilpacks.. but from what youve said, its just boost cut.

fuel cut wind down the boost so it doesnt cut under all condition i.e cold nights

12 + psi is alot without a cooler on a cold night it could easily spike to over 1 bar

So if down the track i get a cooler, the problem is gonna happen more often?

Im surprised you are running 12psi with only catback and no fmic.

It's preferred that these 2 are modified before any boost is increased because you may be causing a lot of harm.

I suggest drop it back down to 10psi and get supporting mods before you start increasing boost

Im surprised you are running 12psi with only catback and no fmic.

It's preferred that these 2 are modified before any boost is increased because you may be causing a lot of harm.

I suggest drop it back down to 10psi and get supporting mods before you start increasing boost

Hey, I've got a basically stock 92 r32 gts-t. Months and months ago i got a manual boost controller and turned the boost up to about 12-13psi and more recently i got a 3 inch exhaust with split dump and high flow cat.

I got turbo back exhaust.

Just trying to decide which path to take atm.

I really wanna get an fmic, but if i do that then i definately have to get an ecu. And after that i'm gonna want more and more power because i know i can have it. So it's gonna cost me alot in the long run.

Alternatively i could turn down the boost and save my money. But stock power is sooooo boring.

Getting an fmic does not warrant an ecu...although some sort of ecu will probably be best...if you keep your boost to 12psi...i don't see any problem...provided you are not running mixtures that are too lean...have you got a fuel pump yet? if not...i'd get one asap...even before considering a fmic...fuel pumps on 32s are VERY old now and will most likely be on their way out....

Edited by limpus

Can the power drain on the battery cause this?

I have had this happen to me...twice so far.

On cold nights....my heater,power fc,AVCR ,air purifier..stereo/amp/sub...lights...are all on.....

Can the drain in the power and a bad battery be at fault.

The battery in the boot is tiny and due to workshop downtime has been drained at least 10 times....

The only thing I think that keeps it firing every morning is the turbo timer charging it the night before..lol

It sounds like it is electrical...if you know your battery is good...check your coils....spark plugs.

This can also be a AFM fault.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • A few small updates since the previous post and lessons. I decided to do a little interior light upgrade on the 110. I quite like the iilumo items, even if they're a bit of a premium over other brands. You'll also note the Stedi Fogs, that will go into the S15 fog lights as I needed to match the bulbs since I got the new ones earlier. I hope they fit as the body is quite a bit longer than your normal bulb.  Annoyingly, I managed to trip the fuse, which normally wouldn't be an issue until I located the fuse. I can't say I've ever come across this. I had lucked out that someone nearby had a spare, but oddly enough Toyota dealerships seem to keep this in stock. I ordered some to keep in my stash and as luck would have it, someone else nearby tripped the same fuse so I passed on the favour.  I also did a little service on the 110 ahead of some additional work coming up. It's been annoying that Goleby's stopped carrying this particular HKS filter for the 110, so now I need to keep them on order from Japan. I also took the opportunity to install a bash plate and number plate riser. The plate riser is such a cheap but nice fix to help really tidy up the car. I'm tempted to now also replace my headlights, on this car. Both items were from Project Aero.    I also needed to replace the rear tyres on the 110, and after trying to get it aligned learnt that I need to replace some bushes in the front end, so that's next.  Closing out this update with a nicer picture as always! 
    • Yeah mate, never miss it.
    • Any going to watch World Time Attack at SMSP this year?
    • Appreciate the correction on the "ground", that will make a huge difference to looking at this. That makes complete sense about AF70/AF71 which is what I had come down to being the issue, one of these. I'll have another look in the ignition wiring when I get a chance next week. I'll also make up a jumper wire for running that AF73 test.  ECU is fine, relay itself is fine, pump harness is fine and the pump itself is fine. I am going to upgrade the Walbro 255 anyway with a DW300 I have since I need to replace the fuel sender and I'm going to upgrade the FPR with my chasebays kit ready for new plenum/injectors/dbw, but I'll get this working first. That's why this is so frustrating. 
×
×
  • Create New...