Jump to content
SAU Community

Recommended Posts

its hard to tell the differences between them when the 20 box is in the car but from what i can see the whole speedo system appears to be different? The 33 one looks as though it just slides in there but the 32 one looks as though it screws into the gearbox?

the easiest way to tell if its a 25 box is to pick it up... they are fat and heavy things! rb20 boxes are light as by comparison. both speedo's slot into the hole and are held by a single retainer, but the RB25 box is electric and the rb20 box is cable driven, hence the screw on attachment.

the easiest way to tell if its a 25 box is to pick it up... they are fat and heavy things! rb20 boxes are light as by comparison. both speedo's slot into the hole and are held by a single retainer, but the RB25 box is electric and the rb20 box is cable driven, hence the screw on attachment.

ye, problem is the only 20 box i have access to is in my car, 99% sure this is an rb25 box just looking at the speedo drive area! Hard to tell just by looking at it the size differnces!

pick it up then! lol

seriously. the 20 boxes are long and skinny where the 25 boxes are acctually shorter but MUCH fatter around the mid section

well the 25 box needs 2 people to lift so i'm guessing the 20 box you could lift with one person?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Working through possible solutions of converting my mechanical speedo.    Anyone know what type of speedo sensor the factory r34 gtr getrag has ? what the output is ? I assume its not a VSS and more a voltage like earlier speedo sensors ? Can an ECU read it ?  
    • roof rail delete used to be a thing, they were made locally for a while too
    • I can get more photos of it here soon and I plan to make a thread detailing the process. I received the car this way and it sorely needs refinishing. That is probably the most appealing photo of it. Up close it is fading, cracked, and needs to be re-glued. Depending on their condition I'm on the fence between refinishing or making a new set.  Another angle hiding the pimples and razor pumps  
    • According to this thread the RS4V with build plate RC40 comes with the R200 diff @ 4.083 ratio as well (mine has said RC40 denotation). We may need to check if the axle stubs are the same pattern as well. The auto subframes have longer axles. However I think yours being a later Series 2 as well, we should have the same bolt pattern for the diff stubs. Unless your upgraded rear also has upgraded axles. Either way, I would not be opposed to pulling the covers to check so I can inspect that  fancy rear core  Also I don't have HICAS. I don't believe that should change things but I hope the people here with heaps more experience than me can correct me if I'm wrong   Let me know if you want to attempt to make this work and I can get some pictures of mine from under the car. 
    • It's not that straightforward. For example I have had this code because my ignitor/power transistor wires were unplugged. It knows something is wrong but has no idea what it means. If you want to actually diagnose this I recommend following the service manual flowchart for code 21. Ohm out the harness, coilpacks, inspect the ECU, etc. And again, it's entirely possible for there to be no problem at all but if you're running a different coilpack it'll trigger the code because it doesn't like what it sees.
×
×
  • Create New...