Jump to content
SAU Community

Recommended Posts

  • Replies 433
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

if enough people go in to make it $229, i'm in

I've added you to the list as a maybe

Come on guys!

Where else are you going to get ADR approved hoses this cheap !!!!!!

Someone with a 32 gtst volunteer their lines damnit! :sleep:

I actually came across this guy on ebay and he said he could copy my R32 gtst ones. My car is off the road at the moment, so im going to send my standard lines down for him to copy.

So he should be able to do r32 gtst lines after next week.

Shaun.

So these come 100% ready to install on the car? No d*cking around at all?

If so i'm in!

All you need to do is take off your old hoses, and put these straight on...

What car you need them for??

Due to increasing pressure from imported braided hoses, BrakeWest have decided to sell their ADR approved hoses for $195 including delivery.

We just need a minimum of 10 people....

Mate my car DOES NOT have abs.

If that makes a difference to my order.

Cheers

BrakeWest are getting samples of abs and non-abs gtst's.

They suspect there will no difference, but when they want samples just to confirm.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • I'm actually not sure - I think it was "Stealth Performance" (It really is near impossible to find a FEMALE 1/8BSPT to 1/8NPT male at ALL) but having the thing leveraged on a 90 degree angle on a small aluminium fitting is not too smart. Also in not too smart, I've drilled out the center of the broken fitting so there's maybe 0.00001mm of thread to bite into, so yeah. I may have to get it drilled/tapped/plugged entirely. Given I could conceivably tap a thread/adapter/pressure line in any point in the oil system I suppose it's feasible to run a line to the Nissan Sensor to keep the dash working. Do these exist in AN fittings and the like? Like an AN fitting that has a NPT (or other?) thread as well for putting a sensor in?
    • I would agree.  There will be an amount of boost you could run safely with an otherwise factory system, but it would be low enough to not be worth the cost.  And if you are reliving your 20s, you know a 'little bit' was never enough. Personally, if I didn't want to spend the money, then stick with NA bolt-ons, and maybe a tune.
    • Fuark, at least the motor survived. What brand was the fitting that snapped?
    • Wrong question. There's no point in spending the rather large sum of cash and effort to add turbo, without taking it to the "sensible" limit of the motor itself. If you have to upgrade injectors, etc, then so be it. That is a tiny fraction of what it will cost you to turbo it.
    • Measure voltage at the starter solenoid terminal when the key is at start and it has clicked. If it is really low, then the suspicion falls on the ignition switch (contacts or wiring thereof) as causing a voltage drop instead of sending enough volts to throw the solenoid all the way to engage the starter itself. If it is a decent voltage, then the suspicion is on the solenoid. Might have s horted coil, or might hva dirty contacts. Rip the starter off, dismantle, clean up contacts and inspect winding. It might not be possible to see if there is a short in the winding though. I have a spare starter here that I could measure the resistance of the coil, as a guide to about what it should be, if you need a comparison. <parts hoarder>No you cannot have it.</parts hoarder>
×
×
  • Create New...