Jump to content
SAU Community

Recommended Posts

Just for your info, the series 2 does not have the sensor in the same spot as the series 1. I did not have to relocate it for the manual conversion.

There are a few cars getting wrecked on the forum, so it should not be too hard to find a cheap one.

Link to comment
https://www.sau.com.au/forums/topic/187818-g-sensor/page/2/#findComment-3392540
Share on other sites

hey guys i may be wrong but every g sensor i have seen in cars under the concole is for the air bags. as i have replaced alot under warranty on new cars . but i may be wrong just putting the thought out there incase it helps.

Link to comment
https://www.sau.com.au/forums/topic/187818-g-sensor/page/2/#findComment-3393117
Share on other sites

Yeah there is an airbag one in the same area with lots of warning signs on it and yellow wiring running out of it. G-sensor would need to be facing in the "factory direction" so that it can tell if the rear of the car is stepping out, not sure what signal it would be getting if it was sitting sideways?

Link to comment
https://www.sau.com.au/forums/topic/187818-g-sensor/page/2/#findComment-3393222
Share on other sites

yeah turning it 90o is not good for it, the lateral and longitudinal g sensors are seperate and it will think you are turning when you are accelerating etc.

Of course it might make the attessa perform better (per the autospeed article years ago) but i doubt it relates to the xfer case dying.

Nick good spot for the sensor I might move mine there....mine is further back between the handbrake and the console bin but it is a very poor fit

Link to comment
https://www.sau.com.au/forums/topic/187818-g-sensor/page/2/#findComment-3393383
Share on other sites

hey guys i may be wrong but every g sensor i have seen in cars under the concole is for the air bags. as i have replaced alot under warranty on new cars . but i may be wrong just putting the thought out there incase it helps.
Yeah there is an airbag one in the same area with lots of warning signs on it and yellow wiring running out of it. G-sensor would need to be facing in the "factory direction" so that it can tell if the rear of the car is stepping out, not sure what signal it would be getting if it was sitting sideways?

As far as I can remember, the airbag one is the one right at the back in the last of those pics I posted. I'm not sure if it's a g-sensor or just the triggering device, or maybe both are in the same unit.

Here's another pic of it:

Stageabits015.jpg

Link to comment
https://www.sau.com.au/forums/topic/187818-g-sensor/page/2/#findComment-3393667
Share on other sites

Yeah lousy torx bolts, had to buy a socket to install the handbrake.

I don't do too much rally driving, so hopefully the G-sensor doesn't take too much of a beating from my turning it 90 degrees. I will endeavour to turn it back now that I understand its purpose better. I'm driving my car full of gear with a trailer to Bathurst tomorrow, so I'll be taking it nice and easy. It's a very easy way to lower your car by loading it with about 500kg of stuff.

When I get to Bathurst I'll turn it around for the homeward journey.

Link to comment
https://www.sau.com.au/forums/topic/187818-g-sensor/page/2/#findComment-3393708
Share on other sites

  • 3 years later...
  • 10 years later...
On 10/5/2007 at 11:39 PM, Terminal said:

Yeah lousy torx bolts, had to buy a socket to install the handbrake.

I don't do too much rally driving, so hopefully the G-sensor doesn't take too much of a beating from my turning it 90 degrees. I will endeavour to turn it back now that I understand its purpose better. I'm driving my car full of gear with a trailer to Bathurst tomorrow, so I'll be taking it nice and easy. It's a very easy way to lower your car by loading it with about 500kg of stuff.

When I get to Bathurst I'll turn it around for the homeward journey.

Did turning g-sensor to factory position help?

Link to comment
https://www.sau.com.au/forums/topic/187818-g-sensor/page/2/#findComment-7968461
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hope you aren't too sore after that one, might take a day or 2 to notice yet and I guess it is a loooooong drive home. On the bright side, tube frame front end is a thing at superlap, right?
    • https://www.facebook.com/share/p/18rmVb1SKB/ 
    • The chart of front pressure to rear pressure (with one being on the x axis and the other being on the y axis) is not a straight line on a typical proportioning valve. At lower pressures there is a straight line with one slope, and at higher pressures that changes to a lower slope. That creates a bend in the line at that pressure, called the knee point. If you do not change the proportionng as the pressure gets higher, you will suffer excessive pressure (at one end of the car or the other, depending on which way you look at the proportioning action) and then get lockups at that end. The HFM BM57, from my memory of previous discussions, is based on the BM57 from a different car (to a Skyline), with a different requirement for the location of the knee point and the distribution of pressure front to rear, and so is not a good choice for an upgrade on a Skyline. Here's a couple of links to some old posts, one from here, one from elsewhere. A lot of it pertains to adjustable prop valves, but the idea is the same. There are plenty of discussions on here about this issue from al the many years of people wanting a cheap/accessible option. https://grassrootsmotorsports.com/forum/grm/learn-me-brake-proportioning-valves/236880/page1/ https://grassrootsmotorsports.com/forum/grm/learn-me-brake-proportioning-valves/236880/page1/  
    • Yeah dunno why johhny posted that here with no context, just post on FB/insta bro where he put it up?  Laine had an off at T4 during Thurs prac, he's ok, car is less than perfect, they are done for the weekend, he can fill in the rest. Bando also binned it like 100m up the road.   
    • I feel there must have been a FB/insta post and the weekend did not start well at all I hope everyone is all okay
×
×
  • Create New...