Jump to content
SAU Community

Recommended Posts

-$350 complete aircon system from firewall

-$400 Heater box & aircon box

I just have a few questions:

1. Is a Compressor part of the "complete aircon system from firewall"?

2. If so, would the compressor suit my '90 R32 gts-t Type M?

3. Would you be willing to sell the compressor by itself?

Thanks.

  • 2 weeks later...
  • Replies 86
  • Created
  • Last Reply

Top Posters In This Topic

parts still there guys but please be reasonable with offers and if keen please call me during the day as i dont get enough time to spend on the forum as i would like to..

Jamie 0415 405 487

  • 3 weeks later...
Parts updated

R32 GTR parts for sale,

My car is being stripped for race preparation and the following parts are to be sold

P.M's only guys or call my mobile 0415 405 487

-$300 side mirrors (black in colour)

-$150 power window motors

-$150 bosch 044 done 3 dyno runs only

-$100 std front door trims insert in maroon leather

-$350 Sard fuel pump 4.6L/min brand new

-$250 Rear wiper motor assembly

-$550 r32 fuel tank & straps etc

-$950 bare engine block .020 over SOLD

-$400 manley forged pistons on std rods used only 1000k(both have been balanced)

-$800ea GT2860R-5 x2 only 1000k old-$150ea HKS actuators x2 SOLD

-$390 near new s/s xforce dump pipes (with O2 sensors) SOLD

-$250 s/s jasma front pipe

-$120 oil lines and water lines + banjo bolts SOLD

-$280 std airbox and plumbing Sold

-$300 std airflow meters

-$400 std injectors and fuel rail

-$150 cooler pipe from turbos

-$350 complete aircon system from firewall

-$300 Heater box & aircon box

-$350 Abs unit

-$350 Full set of Genuine Nismo floor mats for r32 SOLD

-$120 Parcel tray

-$250 Rooflining

-$350 floor carpet

-$150 Kick panels & scuff plates

-$100 Rear door trims

-$100 A pillar trims

-$250 centre guage cluster

-$250 Aircon dash control unit

- seats sold

-$150 std Blow off valves and pipe

-$250 chipped r32-33 gtr ecu (made 230kw 17psi, std gear)

-

Pickup from sydney 0415 405 487

updated

Parts updated

R32 GTR parts for sale,

My car is being stripped for race preparation and the following parts are to be sold

P.M's only guys or call my mobile 0415 405 487

-$300 side mirrors (black in colour)

-$150 power window motors

-$150 bosch 044 done 3 dyno runs only

-$100 std front door trims insert in maroon leather

-$300 Sard fuel pump 4.6L/min brand new

-$200 Rear wiper motor assembly

-$350 r32 fuel tank & straps etc

-$950 bare engine block .020 over SOLD

-$350 manley forged pistons on std rods used only 1000k(both have been balanced)

-$800ea GT2860R-5 x2 only 1000k old-$150ea HKS actuators x2 SOLD

-$390 near new s/s xforce dump pipes (with O2 sensors) SOLD

-$150 s/s jasma front pipe

-$120 oil lines and water lines + banjo bolts SOLD

-$280 std airbox and plumbing Sold

-$250 std airflow meters

-$300 std injectors and fuel rail

-$150 cooler pipe from turbos

-$350 complete aircon system from firewall

-$250 Heater box & aircon box

-$350 Abs unit

-$350 Full set of Genuine Nismo floor mats for r32 SOLD

-$100 Parcel tray

-$150 Rooflining

-$250 floor carpet

-$100 Kick panels & scuff plates

-$100 Rear door trims

-$100 A pillar trims

-$250 centre guage cluster

-$250 Aircon dash control unit

- seats sold

-$150 std Blow off valves and pipe

-$250 chipped r32-33 gtr ecu (made 230kw 17psi, std gear)

-

Pickup from sydney 0415 405 487

prices updated parts gotta go!!!!!

Parts updated

R32 GTR parts for sale,

My car is being stripped for race preparation and the following parts are to be sold

P.M's only guys or call my mobile 0415 405 487

-$220 centre console

-$120 bonnet lining

-$350 bootlid with std gtr wing (black)

-$300 side mirrors (black in colour)

-$150 power window motors

-$150 bosch 044 done 3 dyno runs only

-$100 std front door trims insert in maroon leather

-$300 Sard fuel pump 4.6L/min brand new

-$200 Rear wiper motor assembly

-$350 r32 fuel tank & straps etc

-$950 bare engine block .020 over SOLD

-$350 manley forged pistons on std rods used only 1000k(both have been balanced)

-$800ea GT2860R-5 x2 only 1000k old-$150ea HKS actuators x2 SOLD

-$390 near new s/s xforce dump pipes (with O2 sensors) SOLD

-$150 s/s jasma front pipe

-$120 oil lines and water lines + banjo bolts SOLD

-$280 std airbox and plumbing Sold

-$250 std airflow meters

-$300 std injectors and fuel rail

-$150 cooler pipe from turbos

-$350 complete aircon system from firewall

-$250 Heater box & aircon box

-$350 Abs unit

-$350 Full set of Genuine Nismo floor mats for r32 SOLD

-$100 Parcel tray

-$150 Rooflining

-$250 floor carpet

-$100 Kick panels & scuff plates

-$100 Rear door trims

-$100 A pillar trims

-$250 centre guage cluster

-$250 Aircon dash control unit

- seats sold

-$150 std Blow off valves and pipe

-$250 chipped r32-33 gtr ecu (made 230kw 17psi, std gear)

-

Pickup from sydney 0415 405 487

Parts updated

R32 GTR parts for sale,

My car is being stripped for race preparation and the following parts are to be sold

P.M's only guys or call my mobile 0415 405 487

-$80 door speaker mounts

-$60 autometer boost guage phantom series with black cup 0-35psi 1"5/8

-$120 bonnet latch assembly and cable

-$110 radiator air direction plate (polished alloy)

-$75 sunvisors

-$450 extruded honed exhaust manifolds (they flow approximately 25% more than std)

-$220 centre console

-$120 bonnet lining

-$350 bootlid with std gtr wing (black)

-$300 side mirrors (black in colour)

-$150 power window motors

-$150 bosch 044 done 3 dyno runs only

-$100 std front door trims insert in maroon leather

-$300 Sard fuel pump 4.6L/min brand new

-$200 Rear wiper motor assembly

-$350 r32 fuel tank & straps etc

-$950 bare engine block .020 over SOLD

-$350 manley forged pistons on std rods used only 1000k(both have been balanced)

-$800ea GT2860R-5 x2 only 1000k old-$150ea HKS actuators x2 SOLD

-$390 near new s/s xforce dump pipes (with O2 sensors) SOLD

-$150 s/s jasma front pipe

-$120 oil lines and water lines + banjo bolts SOLD

-$280 std airbox and plumbing Sold

-$250 std airflow meters

-$300 std injectors and fuel rail

-$150 cooler pipe from turbos

-$350 complete aircon system from firewall

-$250 Heater box & aircon box

-$350 Abs unit

-$350 Full set of Genuine Nismo floor mats for r32 SOLD

-$100 Parcel tray

-$150 Rooflining

-$250 floor carpet

-$100 Kick panels & scuff plates

-$100 Rear door trims

-$100 A pillar trims

-$250 centre guage cluster

-$250 Aircon dash control unit

- seats sold

-$150 std Blow off valves and pipe SOLD

-$250 chipped r32-33 gtr ecu (made 230kw 17psi, std gear)

-

Pickup from sydney 0415 405 487

parts updated, pm's replied thanx

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Sorry to hear your HFM BM57 was faulty,  did you contact HFM I would hope they would be at least grateful for the information if there was some sort of manufacturing fault, you would hope they would be sympathetic even if your item was 2 years old if it had never been fitted. May I ask where it leaked from ?
    • Cats are called Bella, and Donna...  Like that poisonous plant And I remember your 2 monsters, I remember making a little bit of wee when you let them out... LOL I have already installed cat doors into the laundry where their kitty litter is, and the sun room, apart from the cat doors there's not going to be any permanent mounted stuff on the interior walls (interior doors are cheap and easy to replace) I will get a outdoor cat cage thingie once I finish the landscaping out back... https://catnip.com.au/ The only off limit areas are the main bedroom and the gym room....but, currently the cats are curled up in bed, in the main bedroom with the Mrs.....LOL, the off limits for the kittens to the main bedroom lasted about 5 minutes with Jackie I currently only have 1 free standing huge cat tree multiple level scratching post thingie in the lounge room, but, I will be getting another one soon now that I'm happy with the furniture layout in the back room and have a perfect spot for it  
    • All of this is making it seem clear that running the Coppermix twin was definitely the way to go, especially in hindsight with how insane tariffs have gotten and the strength of the USD vs yen at the time.
    • That sounds like no chance of even importing one for road registering then Now I see why Duncan wants to check LHD rules for Targa...   I wonder how "bolt in" the AWD would be if you got one imported from the US and swapped it to an AUD one
    • Not to mention they drive like a bucket of bolts! yuck!
×
×
  • Create New...