Jump to content
SAU Community

Recommended Posts

give me a month and i'll post up pics of my car in matte black :thumbsup:

there's a dude in canada who did his in matte black... looks tough as, but he's changed it back to gloss now.

apparently matte's really hard to keep clean, esp if you get oil stains on it.

Link to comment
https://www.sau.com.au/forums/topic/189760-matt-black-r32s/#findComment-3418842
Share on other sites

  • 2 years later...
try to look for a Satin clear coat, than is smooth just not glossy, allows normal cleaning and paint protection without the gloss

def go satin

will be painting my r32 gtr the new lambo matte black very shortly. Been told it doesnt get clear spots like other mattes and is easy enough to maintain. Will post pictures once done :banana:

that is satin black not matte. my wheels r painted lamboghini satin black best color out imo

Link to comment
https://www.sau.com.au/forums/topic/189760-matt-black-r32s/#findComment-5476832
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Did and sync timing with light 
    • Have you done the Ignition Sync Wizard in the AEM software?
    • Find out what RPM it was idling at with the IACV unplugged. It's very weird that the rpm didn't change at all, and then it stalled. When it stalls is it nearly like a switch off, like you've turned the engine off? Or is it more stutters and sputters and coughs to death over a few seconds? Or does the RPM just slowly keep going down and down? Have you done a test of trying to start it with the AFM unplugged? Does it still die?     If you Follow Josh's advice on using Nistune to check the voltages (which is a perfect method!) if you see anything out of wack voltage wise, THEN get the multimeter out and read the voltage directly at the sensor. If the two vary, then you're now looking for a wiring issue vs a sensor issue. So be aware, what the ECU sees, may not be what the sensor is actually saying too...
    • You very likely need to get it on a dyno and tune it. My assumption is, you've got an RB25DET tune in it, which has a different manifold, different injectors, and different cams as a minimum. What O2 sensor are you running?   When you say it runs extremely rich from idle all the way to redline, is this just free revving it you see that?
    • I seem to the be only person that is using a Haltech 2500 on an NA motor, I've installed a Bosch DBW throttle body to the OEM intake manifold and am having problems maintaining AFR even with the wideband o2.  It will run extremely rich at idle and up to redline, but under load it will go extremely lean in the 20s and i'm essentially having to rev it over 4k and feather the clutch to get it up to speed.  I've read a few other threads of about the butterfly, it seems removing the vacuum to it is supposed to have it remain open, i've noticed no difference under 4k with the vacuum line to it plugged.  I'm hoping someone here has had luck using the NA manifold with Haltech, and if they happen to have a tune for it.  
×
×
  • Create New...