Jump to content
SAU Community

Recommended Posts

  • Replies 266
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

The only thing That would come ANYWHERE NEAR the VR is a Z-tune..

Even then, it would still get is arse handed to it..

or.. would it?

Yes the GTR has titanium this.. bollocks that.. electronic jizz control..

But the Z-tune is still pretty hardcore!..

I mean Nimso poured 5mm of Carbon fiber on the floor plan to stiffen it it..

it uses a the GT500 race engine..

Carbon fiber pannels all round..

10.04 or something like that quarter mile..

Same power.. not sure about torque..

I think the Z-tune is ligher..

The gear changes wont be as quick in the Z-tune as in the GTR.. but.. could a Z-tune make up for this?

hmm.. discuss.. im curious..

Edited by GTS4WD
I am almost sure, I think perhaps if the work to upgrade the engine RB26DETT much better than the engine VR38DETT! !

Because LINE ENGINE IS BETTER FROM V ENGINE !!!!!!!!!

In what way?? Have you seen someone modify the VR38 yet??

And what makes you say an inline motor is better than a V engine??

A 'V' engine is much stronger and stiffer than an inline engine...

Can you back up your comments with facts???

It be appreciated muchly from you.... :thumbsup:

In what way?? Have you seen someone modify the VR38 yet??

And what makes you say an inline motor is better than a V engine??

A 'V' engine is much stronger and stiffer than an inline engine...

Can you back up your comments with facts???

It be appreciated muchly from you.... :yes:

The unfortunately reality is that the inline 6 has probably had its day. The packaging benefits of the V6 makes them a better proposition for the run of the mill car companies - particularly those running transverse installations. Even in longitudinal ones the gains are there in making the car easier to engineer for crash worthiness.

But to defend the old inline six (Which I have a soft spot for) they have the following advantages over their bent up brethren:

* Inherent first and second order balance - the V6's either run funny vee angles or need an extra balance shaft.

* Easier packaging when you turbo charge the motor.

* More room on the axhaust side which allows better cooling for the turbo chargers etc.

* Cheaper head castings as you only need two cam shafts & on head.

* They sound much nicer.

how easy would it be to take out the TT setup and throw in a, lets say T51R SPL onto an engine like that (VR)? Maybe compare it to a 300zx engine...I have never had experience with that...is there enough space...how does it all compare to throwing a t51r on a 26 ?

In what way?? Have you seen someone modify the VR38 yet??

And what makes you say an inline motor is better than a V engine??

A 'V' engine is much stronger and stiffer than an inline engine...

Can you back up your comments with facts???

It be appreciated muchly from you.... :(

================================================================

I have no experience with the engine VR38DETT to you that expectation proved largely true! !

Despite the dramatic difference in STROKER! !

But in terms of the experience of the RB20DET and RB25DET and RB26DETT is better in all respects use or promotion or maintenance or endurance is much better too! ! !

There is no engine V6 6 Slander advantage proved successful only relatively Tourqu be a little better and I say this advantage! ! !

But respects mentioned above inline much better health and days will prove myself! ! Despite the size difference stroker !!!!!!!

NOTE: inline engine only for the 6 slander !! V ENGINE GOOD ON THE V8 ONLY !! OR MORE!!!

Thanks ALL .[/b][/size] :yes:

Edited by bkc
The only thing That would come ANYWHERE NEAR the VR is a Z-tune..

Even then, it would still get is arse handed to it..

or.. would it?

Yes the GTR has titanium this.. bollocks that..

But the Z-tune is still pretty hardcore!.. I mean Nimso poured 5mm of Carbon fiber on the floor plan to stiffen it it.. it uses a the 500 race engine.. Carbon fiber pannels all round.. 10.04 or something like that quarter mile..

Same power.. not sure about torque.. I think the Z-tune is ligher..

The gear changes wont be as quick in the Z-tune as in the GTR.. but.. could a Z-tune make up for this?

hmm.. discuss.. im curious..

What race engine are you referring to?

If it's the GT500 from SuperGT, then your probably wrong, cause they have been using a V engine in these for many years in the 350Z and a few seasons in the R34's before that.

If it's the GT500 engine from way back when the R34's first came out( In JGTC), then that's a pretty old engine, and I'd still take the VR over it any day.

The only thing That would come ANYWHERE NEAR the VR is a Z-tune..

Even then, it would still get is arse handed to it..

or.. would it?

Yes the GTR has titanium this.. bollocks that..

But the Z-tune is still pretty hardcore!.. I mean Nimso poured 5mm of Carbon fiber on the floor plan to stiffen it it.. it uses a the 500 race engine.. Carbon fiber pannels all round.. 10.04 or something like that quarter mile..

Same power.. not sure about torque.. I think the Z-tune is ligher..

The gear changes wont be as quick in the Z-tune as in the GTR.. but.. could a Z-tune make up for this?

hmm.. discuss.. im curious..

the z-tune costs a lot more and will be a collectors item. The R35 will be mass produced. If I was to chose b/w to two, Id go the z-tune.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • For these last 7 years of ownership, I've always had to use a small scissor jack under one of the front tow hooks to raise the front just enough so my low-profile jack fits under to reach my subframe jack point. I'm beginning to get annoyed of always having to do this. Are there any lower low-profile jacks that fit under the gtr lip on a dropped car?
    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
×
×
  • Create New...