Jump to content
SAU Community

Recommended Posts

I have for sale two full clusters that were once used in my car (a 1996 series 2 r33 gtst) but have now been removed and replaced with a different cluster.

The first one is a NISMO 300km/h cluster with 58900 on the clock.

The second is a stock one with 94196 on the clock.

They are both in perfect condition and were both running spot on when they were in my car.

Im asking for $600 for the 300km/h cluster and

$200 for the stock one. But i am also open to trade for anything of interest at around the same price.

I am located between geelong and melbourne, victoria. But i am willing to post at buyers expense.

Please post here or p/m me.

Cheers,

Bernard.

I have pictures but this msg keeps coming up when i try to download. "Upload failed. You are not permitted to upload this type of file."

They where taken on my phones camera i don't know if this has something to do with it.

I may be able to email them on request.

Or if someone could sent me a p/m to let me know how to download.

Thankyou.

If you look at the standard cluster picture and the 300km one you will see that the plastic covering around the dials is different. one is a series 1 and the other is a series 2, im not 100% sure which is which but thats the main difference on the front.

On the back with the wiring, the only difference is you have to add two cables for the airbag (series 2) so if you want it in a series 1 with no airbag you remove the cables, that simple. with all this said one of the dials is from a series 2 and the other is from a series 1 so i can mix and match them to fit your car if you like. it is very easily done.

Cheers,

Bernard.

  • 4 months later...
  • 1 year later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...