Jump to content
SAU Community

Carsales.com.au's Review On The R35 Gtr In Japan.


Recommended Posts

the problem here is weight

as Ferni said, you can't go too far either side of optimal for the damping and have a system that works well

(ie- 'jacking' down or po-go'ing). the engineers have obviously chosen springs that have a huge rate to control the fat body, so that basicaly determines the ride characteristics. the shockies only job is to 'damp' the motion of the springs

also - I hope to god Nissan Australia does ABSOLUTELY NOTHING to suspension settings on account of MOTOR/Wheels magazine and the UK guys whining about comfort

:/

When the 350Z was released, the exact same complaints were made about its ride. So they revised the suspension for the European models, with help from Nissan UK. Guess what happened? Those suspension revisions ended up in later model 350Zs internationally, and everyone concluded the car drove better on the road since it was absorbing bumps. On road loops the Euro-spec setup was quicker and more confidence inspiring, and made the car more enjoyable to drive.

As always, the Japanese can't seem to tune suspension. They always assume "stiffer = better" when its not the case, especially not for a street car driven by ordinary people. A car with progressive handling is always quicker than something super sensitive unless you're a good driver (which most people are not).

Considering the car in question is not the V-Spec or N1, I hope they do something about the suspension if its as bad as they say. If someone complains about a track-focused car being too harsh on the road but great on the track, I'd agree that they're nuts, but if you intend on living the GT-R as a "daily drivable supercar" then I'd rather it absorb bumps and maintain constant tyre contact with the road.

As always, the Japanese can't seem to tune suspension. They always assume "stiffer = better" when its not the case, especially not for a street car driven by ordinary people. A car with progressive handling is always quicker than something super sensitive unless you're a good driver (which most people are not).

I thought the GTR used Bilstein suspension and was tuned by the guys at Bilstein?

Anyway, there is no way the GTR with its weight can lap the Nurg in 7:38 with softer suspension. Nissan engineers knew that and they had to compromise the softer suspension in order to get the lap time they were after.

I think you'll find that the differences between japanese-tuned suspension and australian-tuned suspension has more to do with the roads in each place than the engineers.

I love the term "built for australian roads" - in other words, have the suspension as soft as you can possibly make it so as not to spill your drink every 5m when you hit a pothole or some piece of badly cracked bitumen. Our roads (at least here in SA) are bumpy and extremely crap. On a good quality flat road, my stagea is more comfortable than just about every other car i've been in. It kind of just glides along, no seasickness etc.

But give it your average adelaide road and the suspension is less than perfect :P

As far as the article is concerned. Most of the aussie car reviewers are so brainwashed into aussie cars its no wonder it only scored 3.5/5.0. They were probably just confused because they couldn't work out what model of holden it was...

Correct me if im wrong, but the Aussie guy that test drove the GTR was from MOTOR magazine?

As i can recall, guys at MOTOR magazine have always been biased towards the GTR's - they don't like GTR's. There was one time, they tested the R34 with other cars and complained that it's handling around the track was more annoying than revolutional. Thats because they didn't know that a GTR is meant to be driven hard to bring out the best in it. They were driving it around the track like pussies.

However, WHEELS magazine have always loved GTR's. They were the ones that gave it the nickname 'Godzilla'. Anyway, i remembered an article where they tested an R34 N1 against a Monaro GTS or somethin and they said that the GTR was "the best car they've ever driven - no kidding".

Man these guys dont know how to drive pfft 4.0 wait till people own this car and get familiar with it easy mid 3s and mid to low 11s...

umm, with launch control and DSG what does the driver actually have to do to but hold the right pedal down???

umm, with launch control and DSG what does the driver actually have to do to but hold the right pedal down???

They were testing in slightly damp conditions. Hence there could be a couple of tenths that can be cut from the 0-100kmh time and the 0-400m (also mentioning they hit the 180kmh limiter before they reached the end of the 400m and they still managed a 12.1).

a) GT-R has launch control and b) it works! Using it to good effect on the complex's deserted dragstrip, in the failing light at the end of the Sendai session, MOTOR's David Morley punched out an even 4.0sec for the 0-100km/h sprint and 12.1sec for the standing 400m.

While in 'normal' conditions the 4.0sec will be hard to trim...

nothing about it being damp when they did it. If it was damp I doubt they'd say it would be hard to beat in normal conditions. so my point about knowing how to drive, or getting familiar with the car helping accelleration times significantly still stands.

nothing about it being damp when they did it. If it was damp I doubt they'd say it would be hard to beat in normal conditions. so my point about knowing how to drive, or getting familiar with the car helping accelleration times significantly still stands.

It seems you're right. did they mention what revs the launch control takes off? is it a clutch frying redline launch?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • sold listed as a Tomei LSD 1.5 Way For 1998+ Nissan Skyline ER34 25GT RB25DE w/Open R200 https://www.ebay.com/itm/174006114594?campid=5338967980&mkevt=1&mkcid=1&toolid=10050&customid=&mkrid=711-53200-19255-0&loc_physical_ms=108689&loc_interest_ms=&campid=5338967980&mkevt=1&mkcid=1&toolid=10050&customid=71883f2ccc571356e0a757bc7adfdde2&mkrid=710-53481-19255-0&loc_physical_ms=108689&loc_interest_ms= it went in like butter all gears, alignment, back lash etc, rotation and clearances correct, and if rolling all rotates smooth and free when coasting down road , clutch in or out over 10 mph smooth... its the binding, clunking and jerking from a stop that is most concerning, also seems like its going to tear the tires off in 10 miles of normal road driving. 
    • What 1.5 way? There's no such thing really as a 1.5 way, just different ways of explaining 2 ways with different ramp rates. HOWEVER. In any driving in a straight line your 1.5 or 2 or 1.7 way should have no clunking at all. With the clutch fully depressed the diff should be silent (unless it's welded but I'm assuming it's not). Something aint right here.
    • Clutch is a spec brand, new clutch system,( PP, flywheel, friction disc, etc. pull type) installed 100 miles ago, with no problems.
    • looking for some help and maybe some insight on others experience with a new LSD. R34 GT ran and drove beautifully, but always alot of grip loss due to the open R200 rear end, so I just installed a new 1.5 LSD way into the stock open R200 for a ER34. Simple. Everything seemed right. I test drove for the first time this weekend. as I started to back out the garage the first time slowly with tires straight it sounded and felt like I had a loose or half disconnected drive shaft...that was clucking around loose and shaking entire vehicle, and making it feel like the trans clutch was spontaneously slipping then grabbing very roughly while just letting out pedal slowly. I backed it out went to pull forward with the same noise, shake and slip grab feeling with hesitation, I turned the tires to back out more and then pulled ahead some same thing but worst because of added wheel resistance (which that I expected) puzzled … pulling it back in checking everything over and finding nothing wrong, I tried it the next day. same thing, couldn’t believe how it shook everything again making a terrible noise and making it feel like the trans clutch was slipping and grabbing, but I got it out of garage into the driveway, got it straight, drove forward and then reveres a few times in a straight line everything shaking , causing what felt like clutch slip and grab every time, sounded like right behind front driver tire and I could feel it in the floor board with my feet,... worst right when beginning to let clutch pedal out to engage slightly, shuttering and sounding terrible along the way…I managed to slowly get down the road, babying it the whole way, once I was rolling (out of 1st) seemed to be better and between shifts, then clutch felt closer to normal…not slip/ grab etc., but back down to any stop, straight road or turning, same thing. Made no difference if all tires were straight or if I was turning. All other gauge read out correct. with in 2 miles as planned I reached the empty parking lot and performed the break in procedure that came with lsd, essentially to drive in a figure 8 a bunch.  Did this, binding chattering, and shaking the car the whole way. I drove it back home seemed somewhat normal once I was in straight line and past 10 mph or so, and I know it will “bind” on corners and cause some tires squeal when turning especially from a stop, but when I begin to move it still causes what feels like the trans clutch to slip and jerk badly as well as shaking the entire car, and sounds terrible, that I didn’t expect. I used the fluid they supplied with LSD kit and did the breaking, planning to change fluid as they suggest after breaking, but wondering will it get smoother or less aggressive with use? maybe a 1.5 is just too aggressive for normal road driving?   I have a LSD that I put in my 71 cuda when I restored it, with amazing smooth , quite yet effective results. Different style LSD but that ones a joy to drive. maybe expecting too much from this R200?
    • Join SAU NSW for a flame-grilled feed & flame-spitting cruise! Sunday 17th August 2025 3:30PM Meeting Archies Flame Grille Sylvania Waters 4:45PM Cruise Departure 5:15PM Arrival at Cape Solander Kurnell Meet Location: Archies Flame Grille Final Destination: Cape Solander Kurnell *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
×
×
  • Create New...