Jump to content
SAU Community

Recommended Posts

A turbo simply because it is powered by what would otherwise be waste heat (exhaust gas). A supercharger needs to be powered by the engine making sufficient hp to drive it.

If its "wasted gases" why does it guzzle fuel so much once you put your foot down?

If its "wasted gases" why does it guzzle fuel so much once you put your foot down?

1. Because the only way you make horsepower is to burn petrol.

2. Because most tuners run motors on AFR's much richer than stoichiometric on WOT to keep the EGT under control.

a turbo/ supercharged car will always chew more fuel than a similar N/A motor. why? because you are forcing more air into the motor, so that you can put more fuel into it, and thus, make more power.

but what djr81 is trying to say is that a supercharger is run off the crankshaft. it takes power to run a supercharger.

heres an example. lets say my car has 200hp. if i just put a supercharger on it, but dont connect it, the car will make say 180hp. because you need to drive it.

if i did the same with a turbo, then the power wouldnt change, because its just the exhaust thats running it

a turbo/ supercharged car will always chew more fuel than a similar N/A motor. why? because you are forcing more air into the motor, so that you can put more fuel into it, and thus, make more power.

but what djr81 is trying to say is that a supercharger is run off the crankshaft. it takes power to run a supercharger.

heres an example. lets say my car has 200hp. if i just put a supercharger on it, but dont connect it, the car will make say 180hp. because you need to drive it.

if i did the same with a turbo, then the power wouldnt change, because its just the exhaust thats running it

Not that it was asked, but at full throttle there is no compelling reason for a turbo/supercharged motor to be any less efficient that its naturally aspirated counterpart. What is being discussed is not absolute power output, but specific fuel consumption, ie how much fuel you need to produce 1kW of power. With regard to part throttle a turbo motor will always be less fuel efficient than an atmo motor because its effective compression ratio is much less. As a rule the higher your compression ratio the better fuel economy you get.

What I was saying is that if your supercharger consumes say 20hp on full throttle the engine needs produce that 20hp to drive the thing. The power (20hp) would otherwise show up in rwhp. Put another way you waste 20hp worth of petrol just making the motor run.

With regard to the turbocharger being driven by exhaust gas it is not a free kick. There are pumping losses from the motor that result from the need to drive the turbine on the turbo. It can be likened to having a very restrictive exhaust. Nonetheless these are less than their equivalent for a belt driven compressor.

Superchargers are known as parasitic for a reason...

turbos are parasitic too, they cause backpressure in the exhaust which the engine has to push against.

however, they are still more efficient than a supercharger under most circumstances.

Ok I am gonna vote the supercharger for a few reasons.I have owned both at some stage...For overall power output the turbo wins hands down...However economy ...not so sure of...Yes the blower robs power however turbo cars drink juice in the sense that you get lag while building boost.My supercharged Commodore I modified would pull 9psi at idle if I floored it..So I only ever needed the smallest of throttle openings for a very short time to get it moving briskly..And once the foots off the blower was only recirculating air...But put the foot down and the bypass valve shuts and booom away it would go.Under maximum acceleration I would say the turbo would use less, but in the cut and thrust of normal driving...very hard to say...never right off supercharged cars, My one had throttle response as good or better than normally aspirated

a turbo/ supercharged car will always chew more fuel than a similar N/A motor. why? because you are forcing more air into the motor, so that you can put more fuel into it, and thus, make more power.

That is also a matter of perspective, not absolute reality.

Firstly, Saab went to a complete FI range (at least in Australia, not sure if they still sell NA Saabs overseas) for fuel economy reasons. If we're talking "similar to NA" in terms of power output, going FI allows Saab to run a physically smaller engine, which improves packaging and weight, while still maintaining performance.

If we're talking "similar to NA" in displacement, then once again its not necessarily the case. What's one of the major driveline differences between the NA and FI versions of cars that have both (like the Skylines for example)? The FI cars tend to have taller final drive ratios, which means they sit at a lower RPM for a certain speed in a certain gear. The extra midrange of the FI car allows the car to maintain good acceleration with this different FD, which improves economy.

Also, if we're talking about modern FI engines, with relatively high compression and low boost, the engine's internals don't cause the economy hit that old-school turbo cars have. So they're still tractable through the midrange but the little extra air + fuel is offset by the fact that the engine is doing lower RPM because they can carry a higher gear, even around town.

This also leads to the fact that if we're talking "similar in NA" to performance, then its definitely an advantage for FI. The FI guys can run smaller, lighter engines. However, they could also run different gearing. As anyone who's compared a GTS and a GTS-t knows, one of the big differences is the final drive in the diff. The turbos have a taller final drive, which means they can do the same speed at a lower RPM in the same gear. If you were to gear a FI car to accelerate as slowly as a NA car, it would be far more efficient as the engine wouldn't be turning as hard.

I have a few mates that have 350Zs with APS TT kits (which is only a bolt-on engine mod kit, no modifications to the internals or gearing). Their around-town economy improved after the installation. Having that much extra midrange torque meant they could drive it a gear higher than when NA, and since its boosting across a wide rev-band with stock NA internals that extra gain also happens at around-town engine speeds. I think that they were pulling around 12% (1/8th) better economy after the TT install.

The last time I went for a drive with a 350Z TT up Putty Rd, he used about half the fuel I did while maintaining a similar pace behind me. Where I was thrashing the car around in 3rd or 4th at WOT to keep it on the boil, he was in 5th and 6th at half to three quarter throttle. I can only imagine how far ahead he would have gotten from me had he used as much petrol as I did.

If you're driving the car "normally" (from an Average Joe perspective) with only light to medium throttle openings most of the time, then a modern FI car will generally be more fuel efficient. Of course, once you go wide open throttle the simple fact that more air goes into the engine means you need more fuel, and so economy suffers.

Edited by scathing

^^ seconded. FI is slowly overtaking NA as the fuel efficiency king. Just have a look at the latest Volkswagon engine "twincharger" puts a turbo AND a supercharger on to a piddly little 1.4 4 cyl, they get decent power out (for a 1.4) and it returns about 30mpg city and 48mpg highway!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Even more fun, leave all the ADAS stuff plugged in, but in different locations, hopefully avoid any codes!   And honestly, all these new cars with their weird electronics. Pull all the electronics out Duncan, and just shove an aftermarket ECU and if needed a trans controller in, along with a PDM. Make it run basic but race car styled!
    • To follow up a question from earlier too since I had the front bar off again (fking!) This is what is between the bumper and the drivers side wheel And this is the navigator side, only one thing but its a biggy! So basically....no putting coolers in the wheel arches without a lot of moving other stuff. Assuming I move to properly race prepping this car I'll take that job on and see how the computers respond to removing a whole bunch of ADAS modules
    • So I prepped the car for another track day on Wednesday (will be interesting to see coolant temps post flushing out and the larger reservoir, with a forecast of 3-14 being 20o cooler than last time I took it out). Couple of things to mention; since I am just driving the car and not taking a support vehicle, I took the rear seats out and just loaded the back up Team Trackday style. Look at all that space! To cover off removing the rear seat....it is weird (note the hybrid is probably different because it wouldn't have folding rear seats) Basically, you remove the lower seat base, very similar to a r series but it is a clip that pulls forward to release the base rather than it being bolted down. Easy Then, you need to remove the side section of the rear seat on each side. There is a 14mm head nut at the bottom of the side piece, the it slides upwards off a hook at the top to release; you also need to unhook the seatbelt from the loop at the top. Then the centre piece is weird. You need to release/fold the seats forward with the tab in the boot on each side From there, there are 2,x12mm headed bolts holding the rear of each seat to the folding bracket, under the trim between the rear seat and the boot (4x christmas tree clips there, they suck). The seat is out but you can see where the bolts attach to the bracket
    • As discussed in the previous post, the bushes in the 110 needed replacing. I took this opportunity to replace the castor bushes, the front lower control arm, lower the car and get the alignment dialled in with new tyres. I took it down to Alignment Motorsports on the GC to get this work done and also get more out of the Shockworks as I felt like I wasn't getting the full use out of them.  To cut a very long story short, it ended up being the case the passenger side castor arm wouldn't accept the brand new bush as the sleeve had worn badly enough to the point you could push the new bush in by hand and completely through. Trying a pair of TRD bushes didn't fix the issue either (I had originally gone with Hardrace bushes). We needed to urgently source another castor arm, and thankfully this was sourced and the guys at the shop worked on my car until 7pm on a Saturday to get everything done. The car rides a lot nicer now with the suspension dialled in properly. Lowered the car a little as well to suit the lower profile front tyres, and just bring the car down generally. Eternally thankful for the guys down at the shop to get the car sorted, we both pulled big favours from our contacts to get it done on the Saturday.  Also plugged in the new Stedi foglights into the S15, and even from a quick test in the garage I'm keen to see how they look out on the road. I had some concerns about the length of the LED body and whether it'd fit in the foglight housing but it's fine.  I've got a small window coming up next month where I'll likely get a little paint work done on the 110 to remove the rear wing, add a boot wing and roof wing, get the side skirt fixed up and colour match the little panel on the tail lights so that I can install some badges that I've kept in storage. I'm also tempted to put in a new pair of headlights on the 110.  Until then, here's some more pictures from Easter this year. 
    • I would put a fuel pressure gauge between the filter and the fuel rail, see if it's maintaining good fuel pressure at idle going up to the point when it stalls. Do you see any strange behavior in commanded fuel leading up to the point when it stalls? You might have to start going through the service manual and doing a long list of sensor tests if it's not the fuel system for whatever reason.
×
×
  • Create New...