Jump to content
SAU Community

Rb25 Blowing Heaps Of White/blue Smoke

nizmo_freek

By nizmo_freek,
in Engines & Forced Induction

 Share

Recommended Posts

nizmo_freek Experienced

nizmo_freek

Posted
Posted

Hey guys

Big problem, drove to work today and all was fine, parked up and my car started puffing out tons of blue/white smoke, there was literally clouds of it pouring out my exhaust,the car has never smoked once since i have owned it and it is still running perfect, went to see my mechanic/engineer and see what he thought it could be, he said problally turbo, so went home and took off the exhaust dump and intake pipes, both sides are dry as, there is only a tiny bit of oil in the dump pipe, went back to my mechanic and showed him the dump pipe, he was a bit shocked to be honest, he thought it was very weird that it would all of a sudden start smoking, he suggested it could be ringlands or valve stem seals.

I will be getting a compression and leakdown test done tommorow hopefully, hopefully this will atleast give me an idea of what is happening :D

Any suggestions/thoughts on what it could be, i just blew most of my money on a hks 3037 turbo kit so am now stuck in a bit of a corner lol, any help would be great.

Cheers

nizmo_freek Experienced

nizmo_freek

Posted
  • Author
Posted
I know that this sounds a bit rough, but if the turbo is fine, then there is nothing you can do if the ringlands are gone.

Rebuild time, and be prepared to spend over $5k.

The thing that i find weird is if it is the rings, how did they let go? the car still runs perfect and has run perfect ever since ive owned it, gets regular 4000kms oil and filter changes, hardly gets thrashed, i never hit the rev limiter the car has only done 87xxxkms etc etc, i just dont see how all of a sudden a ring/ringland can let go, my mechanic was also very suprised about it, he said it is very weird.

Angus Smart Grand Master

Angus Smart

Posted
Posted

mine still runs fine and i have similar problems.. loads of smoke from rear turbo and on backing off smoke out of pod rear filter.

first suspected turbo but now after compression and leak down test my number 6 cylinder isnt looking hot

with 0 compression and alot of leak...

:D

you could very well be in the same boat as me.

but i am happy about rebuild time! atleast now i will know whats done to my motor instead of guessing

nizmo_freek Experienced

nizmo_freek

Posted
  • Author
Posted
mine still runs fine and i have similar problems.. loads of smoke from rear turbo and on backing off smoke out of pod rear filter.

first suspected turbo but now after compression and leak down test my number 6 cylinder isnt looking hot

with 0 compression and alot of leak...

:(

you could very well be in the same boat as me.

but i am happy about rebuild time! atleast now i will know whats done to my motor instead of guessing

I would be happy about doing a rebuild , if i had the funds lol, but i just blew most of my money on the turbo kit :laugh:, was going to go for around 280rwkw on stock internals, but i guess thats not going to happen now, seems like im cursed at the moment lol.

nizmo_freek Experienced

nizmo_freek

Posted
  • Author
Posted (edited)

At the moment i am runing the stock turbo, but i have a HKS 3037 Pro S turbo kit ( theres is tons of pics in my car link) sitting in my room waiting to go on my car, looks like it will be sitting in my room for a little while longern now.

Edited by nizmo_freek
nizmo_freek Experienced

nizmo_freek

Posted
  • Author
Posted
how do u know the stock turbo hasent gone to the gods? is it still making boost?

Yup still making plenty of boost, there is no oil in the intake pipe and the compressor wheel and exhaust wheels are dry as a bone, turbo has hardly any shaft play either.

nizmo_freek Experienced

nizmo_freek

Posted
  • Author
Posted

Just checked all the spark plugs, every spark plug is nice and clean, none of them are covered in oil, the tops of the pistons are all nice and clean from what i can see (there is a little bit of black soot ofcourse but not much)

nizmo_freek Experienced

nizmo_freek

Posted
  • Author
Posted
Check and clean your PCV valve and make sure thats working.

Had a similar problem with mine ages ago and thats what it was

The PCV valve has been removed, all the stock beather setup has been blocked up and i just have the 2 beather pipes venting into a catch can which vents via a beather filter

SABBAi Grand Master

SABBAi

Posted
Posted

Still sounds like oil seal in the turbo. My 20 turbo did the seals. You couldn't see the oil in the housing though. I threw on a 25 and the problem went away. The old turbo still boosted fine and had no shaft movement either. Do a compression test too.

nizmo_freek Experienced

nizmo_freek

Posted
  • Author
Posted

Took the car into nissan today for them to have a look, straight away they said probally the turbo, they told me to take it off and check if the oil drain was blocked at all, went home after work and got started on taking the intake piping off, straight away i noticed that the piping from the turbo to intercooler were covered in oil, took off the intake pipe and there was oil sitting on the bottom of the compressor inlet, i didnt really check that properly yesterday as i just removed the pod and had a look, so that pretty much confirms it in my mind the the turbo has shat a seal.

Have just removed the turbo and have found another problem thanks to the previous owners not running antifreeze, one of my frost/welsh plugs in the block have started to rust pretty bad and now has a pin hole leak in it, looks like im going to have to replace those before bolting on my 3037 and getting it tuned.

  • 2 weeks later...
Simon-S14 Grand Master

Simon-S14

Posted
Posted

yeah front seal let go on the old turbo.

which is why if the smoke symptoms happen, the first thing you do is pull off the cooler pipes to look for oil pooling, in some case the intercooler gets a decent coating of oil in it also.

good to hear the new turbo is on... should be an animal

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • GTSBoy
      new 1.5 LSD issues/concerns

      By GTSBoy · Posted

      A 1.5 way is a 2 way. It is just a 2 way with a less aggressive ramp on overrun.
    • GTSBoy
      Boost cut after swap(RB25DET NEO) R34

      By GTSBoy · Posted

      The ABS and/or TCS being missing/broken will not cause the engine to misbehave. It just casues CEL to come on and annoy you. The CEL is useless if it is always on, so you have to do the things you have to do to get rid of it, so it can be useful. Being a Stag ECU, then yes, it will not expect TCS to be present. But it will expect ABS to be present and working. You will need to either make the ABS CU talk to the ECU (don't ask me what that will take on an NA R34), and make sure the hardware is working....or, you just need to blank it out in Nistune. Do not persist with the stock ECU. You will just have problems. Gte it Nistuned. Start from there. DO YOU HAVE A BOOST SENSOR? The ECU's boost sensor that it. It is connected to the loom at the rear of the coil cover. Usually rides on the firewall on an R34, but is usually bolted down to a bracket along with all the other crap at the back of the coil cover when a Neo is dropped into another car. If you do not have it, the ECU will shit the bed. So, do you have one?
    • Kapr
      Boost cut after swap(RB25DET NEO) R34

      By Kapr · Posted

      So sadly the fuel pump etc was not it. The pump and filter is new and it is still cutting around 4000 rpm. A read something about ABS/TCS (engine is from stagea and ECU too so no TCS) and i dont know for 100% that my car has ABS. It has ABS "cube" in engine bay but i dont think it works(or at least from my braking experience). Can be something like that?  I will be driving the car next week to Nistune tuner to properly see what is wrong...  
    • JC71
      new 1.5 LSD issues/concerns

      By JC71 · Posted

      the Tomei LSD fluid with lsd kit. frustrated that it was shaking the car to crap and affecting everything else negatively, I pulled the diff last night, and removed the lsd carrier, could not find anything wrong, however it seem to be 100 locked up acceleration, and deacceleration, wondering if they sent me a 2 way not a 1.5??  either way I installed the stock open carrier back in place. test drove everything smooth as butter again. no shake, shutter, random, what felt like clutch slip and grab or drive shaft play, etc. something differently wrong in side the lsd. I might bother taking it apart (if possible) to figure out what's going on inside this carrier, as bought too long ago to return.  only draw back is its back to a one wheel wonder.
    • TurboTapin
      Most women will agree that parking is the most taxing part of driving

      By TurboTapin · Posted

      What a time to be alive!!
×
×
  • Create New...