Jump to content
SAU Community

Recommended Posts

Spotted a black 33 at Regency (3.30pm inspection session). Unfortunately, yes I was in there to be able to spot him! :P I went for a recheck (defected obviously) but :P all good now! I'm back on the road! But the other guy still has to go back.. hmm... hope to see him back on the road soon.... :P Good luck mate!

Edited by bixby

Spotted last night a black R32 GTR turn from south road onto sherriffs road, looked stock with rims, gave it abit from the lights :P had XCP xxx on the plate.

Then this morning a white stag parked in colonnades near the round about off beach road, was just down from a green 200SX, had 5 spoke rims, said to mum she should have bought one of them instead of her micra haha. Nice looking car.

spotted a nice stag at the BP kilburn had a little chat with the fella :P

spotted a few other lines today taking Jema to soccer

spotted my self being flashed this morning dang speed camera @ traffic lights not 100% sure if i was doing 78kph or 76kph

spotted something else but will Let Heslo say when he gets home from melbourne

spotted hurryup r32 on marion rd earlier, also a heap of skylines at villies :D

was good to meet u Craig, thats a nice clean 33 you have there :3some:

was also good to meet you sam!

thats a nice...errrrrrr daily you got there lol :D

i look forword to seein your 33, :D !bring on kadina!

Yep, that was Jenkies and me, thought that was your car going the other way

yeah i was bootin around looking for some fun then saw you go past and im like , yeah i wont catch up to him so i turned up belair road and went for a run up to blackwood and back down lol

spotted a silver stag, pretty much out the front of the dog&duck on hindley street, at like 3am??

and a black 33 on O'Connell street aswell...was in steve's silvia :/ that was earlier in the night though, like 10:45ish?

Spotted last night a black R32 GTR turn from south road onto sherriffs road, looked stock with rims, gave it abit from the lights :/ had XCP xxx on the plate.

Then this morning a white stag parked in colonnades near the round about off beach road, was just down from a green 200SX, had 5 spoke rims, said to mum she should have bought one of them instead of her micra haha. Nice looking car.

woo. my first spot. waas havin my 21st brekky with the olds

Spotted us leaving cop shop last night...

Charmaine apparently Joe saw you last night at the servo, that was when we were at the station. I think they were on their bikes or maybe on of our mates silver Laser?

Also spotted on the way home a fresh burnout, drove through the smoke and followed the nearest car (dirty as Falcon). Caught up and noticed a middle ages couple in the front...

spotted last night at reading cinemas Damo RBR034, a white s2 33 with gtr copy front bar with sau sticker and next to that a blue 32.

Fred, that was me, Bunny 33 and scott "inheaven32". his car is black btw :/

spotted tons of skylines last night. Spotted Shaz at BP west Terrace, DR34MER, Ryan firing on 5 coilpacks, Cara, black 34 on west terrace, etc etc.

Charmaine apparently Joe saw you last night at the servo, that was when we were at the station. I think they were on their bikes or maybe on of our mates silver Laser?

Haha yeah that was me. I was in Steve's silvia :/

I think i saw a laser there....don't know if it was ya mates or not. Prob lol.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
    • I wanted to try and preserve the front bumper as long as possible, they're not cheap and are made to order in Japan. Taking inspiration from my previous K11 Micra build where I made an undertray for the Impul bumper, I did the same for this BN Sports bumper but a little slimmed down.  This time round I only made a 'skid plate' (if that's the correct wording/term) for just the bumper surface area, the Micra version covered the gap like an undertray. Starting off with a sheet of mild steel approx. 0.9mm thick 4ft x 2ft in size. I traced around the bumper, cut it out and cleaned the edges. Luckily I was able to get two halves from one piece of metal In the video I installed it as is, but I've since then I've removed it to spray and add a rubber edging trim. The rubber trim is suitable for 1-2mm and it's a really nice tight fit. The bolts had to be loosened due to the plates being too tight against the bumper, the trim wouldn't push on I used some stainless M6 flat headed bolts for a flusher finish (rather than hex heads poking down), I believe this style fastener is used for furniture too incase you struggle to source some. The corner's are a little wider, but this may be an advantage incase I get close to bumping it  The front grill got some attention, finally getting round to repairing it. Upon removal one fixing pulled itself out of the plastic frame, one side is M8 that fixes inside of the frame, where as the other side is M5. Not knowing I could get replacements, I cut down an M8 bolt, threaded it inside the frame along with a decent amount of JB Weld.  The mesh was replaced to match the bumper. One hole on the bonnet/hood had to be drilled out to 8mm to accommodate the new stud, once the glue had set it could be refitted. I think the reason the grill was double meshed was to hide the horn/bonnet latch (which makes sense) but I much prefer it matching the bumper Bumper refitted and it's looking much better IMO The Youtube video can be seen here: https://www.youtube.com/watch?v=bVZP35io9MA
×
×
  • Create New...