Jump to content
SAU Community

Recommended Posts

Very nice black 32 GTR with a black 34 GTR rear wing on it near Bay St in Port Melbourne. Looks really good and havent seen that done before. :)

Hmm, interesting. That was me... Cheers :P

On that note, I always see a black r33 gtst parked on liardet st in port melb everyday. Once saw a black r34 gtr with no plates parked in the same street.

Looked tough.

Edited by GT32

Thursday

White EVO X on Greensborough Hwy at 4:15pm

my 1st Nissan GTR, Silver on the Eastern Fwy at 4:30pm, plates [KIRUY]

BMW M6 on Hoddle St at 4:40pm Plates were [bMV-10]

Friday

Silver/Bluish EVO 9 near botanical gardens

Today

Black R34 following me in my daily(White Civic) on Rosana Rd/Greensy Hwy

White S2 R33 on Greensy Hwy and a few other Skylines out and about

Only saw it for a second or two but I believe it was a Millenium Jade R34 GTR (Vspec NUR) around 2:30pm today driving along bay st in port melbourne. Everyones heads turned when it drove by. Sounded hot.

Edited by GT32

saw a nice silver r34 gtt turning onto heaths road from derrimut road today at around 12-1pm in hoppers crossing with black with red lip advan tri spokes i think. looks nice and clean. i was in the white r33.

spotted yesterday around 10:30ish blue R34 GTR parked ont he side of the road on ferntree gully road across the roads from bunnings with a white AU parked behind it and no one in the car. car looked nice and clean. too clean to be left on the side of the road.

Spotted a nice looking black R32 GTS-T at my work today at around 10:30 (Dan Murphy's Cheslea)

Also spotted the owner in the store then a cop following him inside and asked if its his skyline.

They went outside. Cop takes off its rego plates (probably expired or car wasnt registered). Bonnet was popped.

I think he got reamed hard...

pearl orangey/mustard r33 gtr dropped on black centered VSKFs in the cbd last night. porn

did have a black bonnet? saw an orange 33 gtr with black centred rims going down pasco vals road the other day with a blakc bonnet

the rims were sticking out quite wide from the standard guards/quarters to

Spotted a nice looking black R32 GTS-T at my work today at around 10:30 (Dan Murphy's Cheslea)

Also spotted the owner in the store then a cop following him inside and asked if its his skyline.

They went outside. Cop takes off its rego plates (probably expired or car wasnt registered). Bonnet was popped.

I think he got reamed hard...

:(

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Update all   thanks to the workshop manual, it lead me back to checking fuses as mentioned central locking and door open lights worked when acc was switched on. diagram attached shows two points of power 1. ACC and 2.  Batt with the later being fused (#28) I did check the fuses using a multimeter but I must have stuffed that up also. Went back and checked the batt fuse in interior fuse box and you wouldn’t believe it… a blown fuse. replaced fuse and everything is now working as it should including the climate control   thank you all with your positive insight and knowledge.    
    • Where is the warning "That this thread is super old"   I just went into a 5 year old thread, went to do a reply, and couldn't see anywhere obvious a warning of it being super old
    • Duncan is correct. Pitwork (and Toyota's own cheap brand "Drive Joy") were primarily created as brands to sell other manufacturers car parts. It would be weird if Nissan sold parts for Toyota vehicles with a Nissan logo on it, so they created Pitwork to sell parts for other brans Toyota, Honda etc. They are not the same as Nissan genuine parts, although they *do* meet Nissan's standards for replacement parts. They aren't supposed to be a substitute for genuine parts, but a cheaper alternative that is better than Ebay fake parts from you-know-where.
    • Thanks GTSBoy, much easier to work with it now it's free!  
    • I _think_ that one has a christmas tree or some other retainer spike into a hole in that panel under it. Come in under it with thin scredrivers and just pry it gently up. If you rip the ears off the retainer pin....so what? Just stick it back down after with a bit of race tape and carry on with life.
×
×
  • Create New...