Jump to content
SAU Community

Recommended Posts

Hi Members of SAU,

I have recently overcome a few problems with my R33 GTR. And now another. The Never Ending Story. :-P

1st Cylinder Not Firing *FIXED*

Boost Cut / Revs Problem *FIXED*

CURRENT PROBLEM

Prior to both problems i was doing about 15L per 100kms which was abit over the mark for a standard GTR. (3 Fill-Ups @ 15L per 100km)

During the 1st Cylinder Not Firing and Boost Cut / Revs Problem i was doing about 22-23L per 100km. (2 Fill-Ups @ 22-23L per 100km)

After fixing all that i am now doing about 25L per 100km. (1 Fill-Up @ 25L per 100km)

25L per 100km in a stock GTR - WTF!!!

As i have overcome these hurdles the fuel consumption has seemed to be getting worse.

The only thing which i have changed from when it was about 15L per 100km to the 25L per 100km would be the spark plugs. Gap of 1.1mm down to gap of 0.8mm. Surely that wouldnt make the car drink another 10 litres of fuel over 100kms.

The car is due for a 5000km service in the next couple of hundred km's. Could the car nearing a 5000km service lessen fuel economy?

Any suggestions on a fix would be greatly appreciated.

Cheers

Link to comment
https://www.sau.com.au/forums/topic/213217-stock-r33-gtr-fuel-drinker/
Share on other sites

Hey Guys,

Here is an update...

A re-cap on things is that this was the fuel pattern:-

3 Fill-Ups @ 15L per 100km [no problems]

2 Fill-Ups @ 22-23L per 100km [1st cylinder not firing & boost leak]

1 Fill-Up @ 25L per 100km [fixed cylinder & boost leak]

1 Fill-Up @ 28-29L per 100km

Serviced & Cleaned Injectors

1 Fill-Up @ 21-22L per 100km

Stock R33 GTR should do 12.3L per 100km or there abouts. I have checked the right O2 sensor but its impossible to get the left/front O2 sensor off with out removing heaps of stuff.

*** DYNO TUNING TIME *** if its still drinking over the next few weeks.

The ECU has been reset many times after trying different things, does the ECU re-learn after things have been fixed and take time to settle.

The car did 28-29L per 100km then it dropped to 21-22L per 100km. That is quite a significant difference. Will the fuel consumption return to normal after some time???

No. There are only a few things that will cause that fuel economy. AFM's, coils causing missfire, coolant temp sensor, fuel leak, cam timing, o2 sensors(although i wouldnt expect it to be that bad) Jap ECU rom, blocked cat could cause it, but it wouldnt make any power. or possibly brakes dragging

  • 5 years later...

airfilter also, is there any temp differences where you are, up here it's hot and hot and hotter so fuel economy isn't the best, i'm freaking out how much fuel my stock rs260 is using! wheel alignment also ?

airfilter also, is there any temp differences where you are, up here it's hot and hot and hotter so fuel economy isn't the best, i'm freaking out how much fuel my stock rs260 is using! wheel alignment also ?

i'm going to guess based on the post is 5 years old, and the guy hasn't been on here since then, your not going to hear from him....

you cant "dyno tune" the stock ecu so be careful what you are asking and paying for

the 02 sensors (both of them) are solely responsible for giving the ECU valid feedback during closed loop (light cruise) on fuel ratio's from the engine

the ECU then uses these sensors to lean out the mixture on light cruise to save fuel. as soon as you flog it / bring it on boost this mode stops operating.

if one or both of the 02 sensors are dead then closed loop won't work well, ie waste fuel

id strongly suggest changing both 02 sensors

from memory the nissan service book said approx 100,000 or 150,000 for 02 sensors

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I got back to Japan in January and was keen to get back on track as quickly as possible. Europe is god-awful for track accessibility (by comparison), so I picked up a first-gen GT86 in December just to have something I could jump into right away. The Skyline came over in a container this time and landed in early January. It was a bit battered after Europe, though—I refused to do anything beyond essential upkeep while it was over there. The clutch master cylinder gave out, and so did the power steering. I didn’t even bother changing the oil; it was the same stuff that went in just before I left Japan the first time. Naughty. Power steering parts would’ve cost double with shipping and taxes, so knowing I’d be heading back to Japan, I just postponed it and powered through the arm workout. It took a solid three months to get the car back on the road. Registration was a nightmare this time around. There were a bunch of BS fees to navigate, and sourcing parts was a headache. I needed stock seats for shaken, mistakenly blew 34k JPY on some ENR34 seats—which, of course, didn’t fit—then ended up having the car’s technical sheet amended to register it as a two-seater with the Brides. Then there’s the GT86. Amazing car. Does everything I want it to do. Parts are cheap, easy to find, and I don’t care what anyone says—it’s super rewarding to drive. I’ve done a few basic mods: diff ratio, coilovers, discs, pads, seat, etc. It already had a new exhaust manifold and the 180kph limiter removed, so I assume it’s running some kind of map. I’ve just been thrashing it at the track non-stop—mostly Fuji Speedway now, since I need something with higher speed after all that autobahn time. The wheels on the R34 always pissed me off—too big, and it was a nightmare getting tires to fit properly under the arches. So I threw in the towel and bought something that fits better. Looks way cleaner too (at least to me)—less hotboy, less attention-seeking. Still an R34, though. Now for future plans. There are a few things still outstanding with the car. First up, the rear subframe needs an overhaul—that’s priority one. Next, I need to figure out an engine rebuild plan. No timeline yet, but I want to keep it economical—not cutting corners, just not throwing tens of thousands at a mechanic I can barely communicate with. And finally, paint. Plus a bit of tidying up here and there.  
    • Nope, needed to clearance under the bar a little with a heat gun, a 1/2" extension as the "clearancer", and big hammer, I was aware of this from the onset, they fit a 2.0 with this intake no problems, but, the 2.5 is around 15mm taller than a 2.0, so "clearancing" was required  It "just" touched when test fitting, now, I have about 10mm of clearance  You cannot see where it was done, and so far, there's no contact when giving it the beans Happy days
    • It's been a while since I've updated this thread. The last year (and some) has been very hectic. In the second-half of 2024 I took the R34 on a trip through Germany, Italy, France and Switzerland - it was f*cking great. I got a little annoyed with the attention the car was getting around Europe and really didn't drive it that much. I could barely work on the car since I was living in an inner-city apartment (with underground parking). During the trip, the car lost power steering in France - split hose - and I ended up driving around 4,000kms with no power steering.  There were a few Nurburgring trips here and there, but in total the R34 amassed just shy of 7,000kms on European roads. Long story short, I broke up with the reason I was transferred to Europe for and requested to be moved back to Japan. The E90, loved it. It was a sunk cost of around EUR 10,000 and I sold it to a friend for EUR 1,500 just to get rid of it quickly. Trust me, moving countries f*cking sucks and I could not be bothered to be as methodical as I was the first time around.
    • I assume clearances were all a-okay?
    • Shock tower brace is in +5Kw....LOL  
×
×
  • Create New...