Jump to content
SAU Community

Recommended Posts

Hi Members of SAU,

I have recently overcome a few problems with my R33 GTR. And now another. The Never Ending Story. :-P

1st Cylinder Not Firing *FIXED*

Boost Cut / Revs Problem *FIXED*

CURRENT PROBLEM

Prior to both problems i was doing about 15L per 100kms which was abit over the mark for a standard GTR. (3 Fill-Ups @ 15L per 100km)

During the 1st Cylinder Not Firing and Boost Cut / Revs Problem i was doing about 22-23L per 100km. (2 Fill-Ups @ 22-23L per 100km)

After fixing all that i am now doing about 25L per 100km. (1 Fill-Up @ 25L per 100km)

25L per 100km in a stock GTR - WTF!!!

As i have overcome these hurdles the fuel consumption has seemed to be getting worse.

The only thing which i have changed from when it was about 15L per 100km to the 25L per 100km would be the spark plugs. Gap of 1.1mm down to gap of 0.8mm. Surely that wouldnt make the car drink another 10 litres of fuel over 100kms.

The car is due for a 5000km service in the next couple of hundred km's. Could the car nearing a 5000km service lessen fuel economy?

Any suggestions on a fix would be greatly appreciated.

Cheers

Link to comment
https://www.sau.com.au/forums/topic/213217-stock-r33-gtr-fuel-drinker/
Share on other sites

Hey Guys,

Here is an update...

A re-cap on things is that this was the fuel pattern:-

3 Fill-Ups @ 15L per 100km [no problems]

2 Fill-Ups @ 22-23L per 100km [1st cylinder not firing & boost leak]

1 Fill-Up @ 25L per 100km [fixed cylinder & boost leak]

1 Fill-Up @ 28-29L per 100km

Serviced & Cleaned Injectors

1 Fill-Up @ 21-22L per 100km

Stock R33 GTR should do 12.3L per 100km or there abouts. I have checked the right O2 sensor but its impossible to get the left/front O2 sensor off with out removing heaps of stuff.

*** DYNO TUNING TIME *** if its still drinking over the next few weeks.

The ECU has been reset many times after trying different things, does the ECU re-learn after things have been fixed and take time to settle.

The car did 28-29L per 100km then it dropped to 21-22L per 100km. That is quite a significant difference. Will the fuel consumption return to normal after some time???

No. There are only a few things that will cause that fuel economy. AFM's, coils causing missfire, coolant temp sensor, fuel leak, cam timing, o2 sensors(although i wouldnt expect it to be that bad) Jap ECU rom, blocked cat could cause it, but it wouldnt make any power. or possibly brakes dragging

  • 5 years later...

airfilter also, is there any temp differences where you are, up here it's hot and hot and hotter so fuel economy isn't the best, i'm freaking out how much fuel my stock rs260 is using! wheel alignment also ?

airfilter also, is there any temp differences where you are, up here it's hot and hot and hotter so fuel economy isn't the best, i'm freaking out how much fuel my stock rs260 is using! wheel alignment also ?

i'm going to guess based on the post is 5 years old, and the guy hasn't been on here since then, your not going to hear from him....

you cant "dyno tune" the stock ecu so be careful what you are asking and paying for

the 02 sensors (both of them) are solely responsible for giving the ECU valid feedback during closed loop (light cruise) on fuel ratio's from the engine

the ECU then uses these sensors to lean out the mixture on light cruise to save fuel. as soon as you flog it / bring it on boost this mode stops operating.

if one or both of the 02 sensors are dead then closed loop won't work well, ie waste fuel

id strongly suggest changing both 02 sensors

from memory the nissan service book said approx 100,000 or 150,000 for 02 sensors

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...