Jump to content
SAU Community

Recommended Posts

hey guys,

i was simply wondering from opinions the power that my car should be putting out.. i have an r33

mods:

3 1/2 inch exaust

3 inch dump pipe

high flow cat

high mount manifold

t04e garrett turbocharger

hks front mount intercooler

turbosmart bov

bosche 040 fuel pump

greddy profec b spec II boost controller ( 14.5psi )

blitz pod filter

exedy single plate heavy duty clutch

just wanna see some ideas on the power this hsould push... cheers guys

Link to comment
https://www.sau.com.au/forums/topic/217830-power/
Share on other sites

  • Replies 42
  • Created
  • Last Reply

Top Posters In This Topic

Ugh... t04e... the good ole poor mans turbo :bomb_ie:

Either way, totally dependant on the spec of the T04e you have.

There are probably 100 different combinations.

Be prepared for poor power delivery, and poor response... i know, i had one (.82 rear, 500hp front end)

Link to comment
https://www.sau.com.au/forums/topic/217830-power/#findComment-3849495
Share on other sites

Ugh... t04e... the good ole poor mans turbo >_<

Either way, totally dependant on the spec of the T04e you have.

There are probably 100 different combinations.

Be prepared for poor power delivery, and poor response... i know, i had one (.82 rear, 500hp front end)

:bomb_ie:..thats sad.... im thinkin about dropping in a gt35r??... or a hks gtr-s??... and get this thing under some serious power.. what psi can i push this t04e to??

Link to comment
https://www.sau.com.au/forums/topic/217830-power/#findComment-3849538
Share on other sites

^ as above.

You've mentioned a 450/500hp turbo and a 700hp turbo... i think you need to research what your doing

i understand thy are very different..... but im struggling to decide...whether i want my car to be just big horse power... or i still do what ive been doing for drift...

ill start at injectors.. atm its pushing 212 rwkw... with the injectors they should unlock a little more power as the stockies are only at about 75%.... r31 nismoid... whats your suggestion on this whole thing... cause i really dont know what is better and what not

Link to comment
https://www.sau.com.au/forums/topic/217830-power/#findComment-3849724
Share on other sites

Well its generally determined by cost.

GT35 = rebuild plus a lot of other stuff, 15k i reckon is a good number to match with 350rwkw.

GT-RS, bolt on, still within the motor limit and good response... less than half the GT35 route too

It wont look as flash though as its not a big donky cover like the t04e probably has on it (.7AR front), but will do the job a fair portion better.

Link to comment
https://www.sau.com.au/forums/topic/217830-power/#findComment-3849851
Share on other sites

Well its generally determined by cost.

GT35 = rebuild plus a lot of other stuff, 15k i reckon is a good number to match with 350rwkw.

GT-RS, bolt on, still within the motor limit and good response... less than half the GT35 route too

It wont look as flash though as its not a big donky cover like the t04e probably has on it (.7AR front), but will do the job a fair portion better.

hhey r31!!.... ive been looking around and im thinkin of a t04z hks.... whats that compared to the gtrs

Link to comment
https://www.sau.com.au/forums/topic/217830-power/#findComment-3860866
Share on other sites

t04z is bigger again & a great turbo. I got a gt3540 and once it was too expensive to go back i reslied i really should of got a t04z. My turbo is the biggest draw back in my whole system. Only thing is tho on a built 2.5l engine it will be laggy. I guess it just depends on what your application is.

Link to comment
https://www.sau.com.au/forums/topic/217830-power/#findComment-3863439
Share on other sites

t04z is bigger again & a great turbo. I got a gt3540 and once it was too expensive to go back i reslied i really should of got a t04z. My turbo is the biggest draw back in my whole system. Only thing is tho on a built 2.5l engine it will be laggy. I guess it just depends on what your application is.

what if i decided to get the exaust houseing change to like a .61.... wouldnt that reduce lag... cause i wanna drift on track....and with a laggy turbo its not much fun.. godl..turboz are so ridiculiously over priced!! :D

Link to comment
https://www.sau.com.au/forums/topic/217830-power/#findComment-3865272
Share on other sites

godl..turboz are so ridiculiously over priced!! :D

Turbo's when properly taken care of, should end up being cheaper then your engine oil.

their service life exceeds that of most engine rebuilds in the diesel world i hear.

Have you checked the cost of a modern, internally lubricated supercharger?... :D

Edited by GeeTR
Link to comment
https://www.sau.com.au/forums/topic/217830-power/#findComment-3865308
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Newbie here, proud owner of an Autech 260RS. I'm on the hunt for wiring diagrams specific to the 260RS, particularly S1. I've ran my eyes through R33, R34 Diagrams, there are some similarities, however continue to find incorrect wire colours and pins on connectors in the 33,34 diagrams.   I was hoping someone could point me in the right direction? I'd be happy to pay for the originals in Japanese. I can translate them, at least they would be accurate.   Any help please would be greatly appreciated, never heard an RB26DETT before let alone driven one, and I've got a spaghetti monster of goodness to sort out.   Cheers Benny  
    • Hey all  im wondering if you can help me please I have put a rb20 box in my r34 gtt as my auto packed up and a friend had a spare box I know it’s not ideal but it will get me up and running for now. we have done the conversation and everything is working great but my Speedo we got a s13 speed sensor but my Speedo reads double now and I bought a speed converter but still not having any luck.  so I thought I’ll reach out and pick your brains  any help would be appreciated please as I wanna drive my car again 
    • Drain it. I got official Matic D but you can get whatever is listed as Matic D compatible.
    • Thanks guys,  Yeah I should at least have them dynoed, at least then I know what I've got as a starting point.  The springs on these are hard as rocks. I vaguely remember Russman saying he was going to sell the shocks to me with the rocks fitted, as he was keeping the softer springs for his new setup.  I didn't click at the time but of course that was to let me know the shock/spring wouldn't be matched.  I also remember pricing up new springs around 2014-15, but, house, money etc. it never happened. So that was another reason to have them rebuilt. I have rebuilt the forks on many motorcycles so I think I could handle the seals on these easily enough, but getting the valving right would be a rabbit hole I cbf exploring.  Duncan, interesting to hear RP was tuning these back then. I might give them a call.  In the mean time I have been busy fitting sway bars. The Whiteline rear sway bar I purchased 15 years ago finally got fitted, along with the Whiteline front bar that showed up last week. Just waiting on new links for the front sway bar to finish that off.  And my spare set of advan AVS VS5's should be back from the powder coaters in a Pearl White finish sometime this week, with a set of Hankook RS4's lined up for fitting.  And then I just have all the suspension bushes to do. A comprehensive kit is on the way... Lots to do before the Ararat hill climb. Cheers guys 🍻   
    • Nice car! I’m glad folks in the US have gotten past the FnF and are buying real cool cars like the 260RS I was with a bunch of mates in Portland about a year ago and spotted a green Stagea (just a regular 2.5T AWD) parked about 2 blocks away and they were like “a what?” So I made a bet with them for a round of beers and said “ok one of you run down there and tell me if the steering wheel is on the correct side” 5 mins later the American comes trudging back up the hill and goes “he’s right guys. Ok what beer do you want?”
×
×
  • Create New...