Jump to content
SAU Community

Recommended Posts

Firstly, i love my car (s1 stag), dont get me wrong, but there are a few issues. Mainly due to my excitedness/haste (read: foolishness) in buying i suspect.

1. I dont have an original stag key. I have a craaapy mr minit looking cut key, and crappy little press in immobiliser. I'm assuming car wasn't shipped with the key or something?

2. My power steering pump is making an inordinate amount of noise. (noticable mainly due to 3.)

3. Left side speakers blown.

4. Rust on INSIDE of door mirrors

5. Drivers side door mirror requires manual assistance in folding in/out

6. Twice now, car has stalled driving in shopping centre car parks (will check out fuel filter this weekend)

7. After 30mins - 1hrs driving it bogs down when accellerating from idle (auto trans fuild hot maybe?)

8. Current auto issues are making me save for a manual s2 already.

9. There are water marks on the top of the visors, and the rear portion of the roof has begun to hang down at the join. i'm suspecting that there may have been a leak through the roof although there is no visible rust or anything there.

10. It's already been back to have a belt changed because it almost deafened me with its squeal while my head was under the bonnet

so, i'll call it personality, it sounds more positive that way :blink:

i have my work cut out for me i think :)

Link to comment
https://www.sau.com.au/forums/topic/230800-stagea-issues/
Share on other sites

Just remember you bought a 12 year old car and although most cars come from japan with low km's 12 years of sitting in the snow and rain will do damage,it could be worse you could of bought a 12 yr old commodore and be doing alot more repairing. Stick with it and be rewarded with a fun car im loving my stag and although it needs some attention i wouldnt trade it for the world atm.

Link to comment
https://www.sau.com.au/forums/topic/230800-stagea-issues/#findComment-4054416
Share on other sites

Firstly, i love my car (s1 stag), dont get me wrong, but there are a few issues. Mainly due to my excitedness/haste (read: foolishness) in buying i suspect.

1. I dont have an original stag key. I have a craaapy mr minit looking cut key, and crappy little press in immobiliser. I'm assuming car wasn't shipped with the key or something?

My car came with a key with built in locking/unlocking (maybe an optional extra?) if you can find someone to check via FAST (i Can't) you may be able to find out. I tried to buy another key but was quoted $300 from Nissan

2. My power steering pump is making an inordinate amount of noise. (noticable mainly due to 3.)

3. Left side speakers blown.

4. Rust on INSIDE of door mirrors

Rusty doors under the mirrors is a Stagea thing (but the ONLY rust on my car). The sooner fixed the better. Door panels off, mirror off (maybe time to o/haul or replace the motor) weld in steel and replace or dry foam and put waxy stuff (panel beater told me) to prevent further rusting.

5. Drivers side door mirror requires manual assistance in folding in/out

see above

6. Twice now, car has stalled driving in shopping centre car parks (will check out fuel filter this weekend)

7. After 30mins - 1hrs driving it bogs down when accellerating from idle (auto trans fuild hot maybe?)

Unlikely but see DIY section for installation of cooler - check fliud to see if its dirty and needs replacing

8. Current auto issues are making me save for a manual s2 already.

9. There are water marks on the top of the visors, and the rear portion of the roof has begun to hang down at the join. i'm suspecting that there may have been a leak through the roof although there is no visible rust or anything there.

10. It's already been back to have a belt changed because it almost deafened me with its squeal while my head was under the bonnet

so, i'll call it personality, it sounds more positive that way ;)

i have my work cut out for me i think :teehee:

Not just a car but a past-time!

Link to comment
https://www.sau.com.au/forums/topic/230800-stagea-issues/#findComment-4056881
Share on other sites

hahaha I get really embarrassed by it.. damn car making me blush hahahaha

heh, mine squeals no longer, the offending belt got replaced and my ears have finally recovered ;)

apparently you can get a de-glazing compound to sort out the squeak on the belts if they're not too far gone, where you'd get it from i have no idea though :)

heading back to the dealership with a list of things to have sorted out tomorrow, i imagine not many will be fixed, but even if its only 1 or two then thats 1 or two i dont need to fix :(

Link to comment
https://www.sau.com.au/forums/topic/230800-stagea-issues/#findComment-4059378
Share on other sites

6. Twice now, car has stalled driving in shopping centre car parks (will check out fuel filter this weekend)

http://www.skylinesaustralia.com/forums/Ca...vs-t230750.html

I found this issue to be my AFM but it may be different to yours

Link to comment
https://www.sau.com.au/forums/topic/230800-stagea-issues/#findComment-4059910
Share on other sites

Yeah bro,

Happened to me on my first stag with the standard factory bov and everyone has a theory on how to fix this issue.

It is common on autos but can occur with manuals aswell. This caused lots of probs and I couldnt pin point it and also changed the afm.

I had the same prob when I went open atmospheric with an Apexi dual chamber and had to plumb back the right air flow on deceleration.

A aftermarket computer engine management system or SAFC II can fix this or you need a full plumb back system, I had the same prob on my GTiR with a SARD R2D2 and chose a HKS Eids.

Either of these will fix the idle/stalling prob, just depends on how much you want to spend and how far you want to go with later tuning and cost.

The SAFC II was the way to go when on the cheap, just up to +1 deceleration air.

Also leetom is right about the squealing alternator belt, just adjust, a new one will do it aswell.

Stageas are hard to find without rust and doors are usually common, its more along the lines of least amount of rust, mine is pretty clean though.

All stags need a full major service and overhaul when bought considering wear and tear on the usual items, it cant be avoided on a 10 year+ car.

As I said my second stagea..lessons learnt and still could maintain full open atmospheric venting..PSSSHHHTT!!

Edited by nismokid
Link to comment
https://www.sau.com.au/forums/topic/230800-stagea-issues/#findComment-4060482
Share on other sites

  • 8 years later...
On 05/08/2008 at 11:47 PM, 96RS4V said:

heh, mine squeals no longer, the offending belt got replaced and my ears have finally recovered ;)

apparently you can get a de-glazing compound to sort out the squeak on the belts if they're not too far gone, where you'd get it from i have no idea though :)

heading back to the dealership with a list of things to have sorted out tomorrow, i imagine not many will be fixed, but even if its only 1 or two then thats 1 or two i dont need to fix :(

Super Cheap sells a spray to fix squealing belts. Saw it in the shop today when I was looking for dielectric grease for my coils. 

 

Shit this is an old post. Ha ha ha so tired.....

Edited by TMLP
  • Like 1
Link to comment
https://www.sau.com.au/forums/topic/230800-stagea-issues/#findComment-7787108
Share on other sites

18 hours ago, TMLP said:

Super Cheap sells a spray to fix squealing belts. Saw it in the shop today when I was looking for dielectric grease for my coils. 

 

Shit this is an old post. Ha ha ha so tired.....

Blast from the past ;)

Link to comment
https://www.sau.com.au/forums/topic/230800-stagea-issues/#findComment-7787271
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • You can’t see much on the other side as the lcd is there I don’t think it’s the same as the m33 beside it as the markings on top is not the same was hoping someone had a good quality photo or if they just happened to have the unit in hand, quickly take the cover off and take a photo to clearly show the marking on top to identify the diode   the unit is currently with an electronics repair shop so I can’t take another photo at the moment hopefully they are smart enough to know if it’s a zener diode or not
    • I'd be very surprised if you can buy new OEM mats. But if you can, I want some too!  Do you have links to the variations you found? Also, where are you located? I found that Nengun is happy to list items to purchase but when you do buy them you'll get an email that it's actually discontinued. As far as I know the variations in floor mats are different colour schemes as well as automatic and manual having a slightly different shape. The automatic ones fit into a manual car without issues, but I think you'd have trouble fitting the other way around. I have photos that show the shape difference if you care. FWIW I bought sets of used floor mats in decent condition at yahoo auctions.
    • Hi 🙋‍♂️. Just bought my Unicorn but the interior need some minor work so it would match my expectations ;). I noticed it is hard to get used oem floor mats in good condition so i started to dig if there's any chance to buy set of new ones. I found two websites - nengun and amayama and it looks like one can still buy factory new floor mats in Japan, but thers a small issue. Some mats (i assume genuine, oem ones) are marked as G4900 and these are "discontinued". The ones you can buy are marked as G4911 but i have no idea if these are also oem, made by other producer or some lower quality replacements that looks entirely different. Can anyone help? 😃  P.s. there is also some strange indication - 0V005, 0V015 and 0V505. Any idea what does it mean? Would appreciate any help with this 🙏
    • Hi, Marek here 🙋‍♂️. I finally fulfilled my longtime dream - recently bought Stagea and now waiting for it to arrive in Poland. There's only few of these in my country, and one of the owners  recommended mi this forum as a source of all the info i'd need since now i own one  so here i am.  
    • Version 1 aluminium airbox is.......not acceptable No pics as I "didn't like the look.....alot" Even after all my "CAD", and measurements, the leg near the fusebox just didn't sit right as it ended up about 10mm long and made the angle of the dangle look wrong, the height was a little short as well, meh, I wasn't that confident that Version 1 was going to be an instant winner I might give Version 2 another go, there's plenty of aluminium at work, but, after having in on and off a few times, and laying in the old OEM airbox without the new pod filter and MAF, there may be an option to modify the OEM air box and still use the Autoexe front cover and filter.... maybe This >  Needs to fit in here, but using the panel, and not the pod, the MAF will need to fit in the airbox though> I'm thinking as the old OEM box and Autoexe cover that is sitting in the shed is just sitting around doing nothing, and they are relatively abundant and cheap to replace if I mess it up and need another, it may well fit with some modifications to how the Autoexe brackets mounts to the rad support, and some dremiling to move it get in there, should give me some more room for activities, as I don't want to move the MAF and affect the tune Sealing the hole it requires to stick it in the air box is simple, a tight fit and some pinch weld will seal it up tight  I am calling this a later problem though
×
×
  • Create New...