Jump to content
SAU Community

CRD Dyno day - DATE CHANGED - Now Oct 12th 2003


Recommended Posts

  • Replies 240
  • Created
  • Last Reply

Top Posters In This Topic

People - We have a BBQ available to us for tommorrows Dyno Day so please bring all nessesary food and drink. This strictly BYO, no food/condiments etc will be provided

See all of you in the morning

Nick

Another things guys I have spoken to ASM (Auto Salon Magazine) who are interested in doing a story on the Dyno Day.

They are unable to attend unfortuantely but have asked that we get some nice hi res photos of the event.

We are therefore looking for volunteers who can take photos and email them through to me for submission to ASM.

If anyone out there can assist please let me know tommorrow

Cheers

Nick

A good morning, sorry i had to head off so early.

thought i would have made a bit more power than i did :(

good to meet some of the boys and i'll meet the rest of you next time, might possibly be coming to the big cruise next fridy.

big thanks to nick for organising.

:)

B-Man, unsure *shrugs*

I had a Bosch 040 fitted about a month ago and the car is deffinetly quicker than it was when i did the 203 at Unigroup. I don't believe that CRD ran in Shootout mode (doesn't say on bottom of the printout) so add around 8-10% to adjust for that.

Still happy though coz im only using the standard ECU and no other management :(




  • Latest Posts

    • Steam valve seals are usually responsible for cold start smoke, it goes away once engine warmed up. Disconnect it let engine breathers and let it breath freely, see if problem goes away after a short drive. Also check to make sure engine oil drain pipe is not blocked or kinked. 
    • Haha thanks! Yea I'm moving over from 2x 1000cc jets pre throttle over to 6x 190cc direct port jets and 1x 500cc pre throttle jet.  Direct port comes with all the advantages you would expect, except that pre throttle does cool down IAT'S more. That's why my direct port nozzle placement is closest to the plenum as possible in the runners to allow the air more time to cool before being sucked in. I'm also putting that one 500cc pre throttle jet to help with more cooling. It's a hybrid system. There's a lot more advantages to moving over to a PWM solenoid with a constant pressure system vs my old PWM pump setup, but I'll get more into that once I'm done converting everything over. The ricer in me is excited to see SS tubing all over my manifold though!
    • Very cool, see what I did there? 🥲 Wild WMI setup, first I've seen where it's on each cylinder runner, usually I see a single jet pre throttle.
    • Welcome mate. What type of work were you looking at getting done? Majorly of decent skyline workshops are in the SE.
    • Thanks mate, haha that's it ey, no more boosters and what not, should make for a good time
×
×
  • Create New...