Jump to content
SAU Community

Recommended Posts

Hi!

There will be snow i Norway soon, so now im going to do a oilservice before i put it away for a couple of months.

My brother works at a local benz dealer, so I`ll get 50% off castrol oils.

What do you recomend i use in the gearbox and in the reardiff?

Im going to use castrol edge 0/40 in the engine.

I have seen that redline if often recomended, but i dont have an 50% discount on redline. And if im going to use it i have to order from us og england (expensive)

Link to comment
https://www.sau.com.au/forums/topic/238914-gearbox-and-reardiff-oil/
Share on other sites

Straight out of the Castrol website using their lube selector. This is for a R32 GTR btw, I don't think the 33 GTST is listed there. Faily sure they are the right ones, but you may want to call Castrol to confirm.

Engine:

CASTROL EDGE SPORT 10W-60

Gearbox

CASTROL VMX 80

Power Steering

CASTROL PS FLUID

Diff

CASTROL EPX 80W/90

4WD Transfer

CASTROL TRANSMAX Z

Edited by __PhaseShiftDown
  • 2 years later...

syntrax for gearbox and diff. GT-T with the standard viscous LSD will be fine as viscous is a sealed unit. If you have A-LSD then you need a diff oil with friction modifiers in it.

definitely go synthetic. I had motul gear 300 in my diff and after 80,000km and a couple of texi days I dropped the oil and it was still honey coloured and smelled great.

syntrax for gearbox and diff. GT-T with the standard viscous LSD will be fine as viscous is a sealed unit. If you have A-LSD then you need a diff oil with friction modifiers in it.

definitely go synthetic. I had motul gear 300 in my diff and after 80,000km and a couple of texi days I dropped the oil and it was still honey coloured and smelled great.

ok thanks but the LSD fluid is slightly thicker would that matter

ahh and also how can i tell if i got a LSD or a viscous LSD ?

  • 1 month later...

for 32R diffs, is there a difference in oil used between front and rear diff

i see CASTROL EPX 80W/90 is recommended by Castrol however other threads also recommend Castrol SAF-XA Limited Slip Rear Axle Oil - 80W-140 (apparently due to different conditions between Jap and Aus)

Hi!

There will be snow i Norway soon, so now im going to do a oilservice before i put it away for a couple of months.

My brother works at a local benz dealer, so I`ll get 50% off castrol oils.

What do you recomend i use in the gearbox and in the reardiff?

Im going to use castrol edge 0/40 in the engine.

I have seen that redline if often recomended, but i dont have an 50% discount on redline. And if im going to use it i have to order from us og england (expensive)

can you get Motul Ow 30 or say Agip 5W 30

on the topics of gear oil, I just had my GTR gearbox rebuilt with new synchros and seals. It has a OS Giken gearset in it and I am still contemplating which gear oil to use . . .

I am deciding out of Redline Shockproof Light and Royal Purple Max Gear Oil. Any recommendations on these two??

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Power steering is probably because someone has nuked the HICAS CU and you no longer have the variable power asist doing what it is supposed to. How much boost are you running? You are aware that any more than 10 psi on the stock ECU is just asking for it to go to full R&R (that's Rich & Retard, which is effectively Retarded and Retarded!) which kills all the power. Depending on the exact conditions, it can just be runnign on the fat and stupid end of the maps, then the conditions change, you make a little more boost and the ECU goes into panic.
    • @BuiltNotBought Just as GTSboy said.   If you want driveabilty and more low down torque..keep the stock runners. They are VERY good from a factory. I have them too on my RB25DET NEO and as a GTSboy i have fmic but with stock piping route(i have Blitz intercooler) Iam making around 320 BHP and the car pulls "hard" from like 2,5k all the way to 7k. I have it dyno tuned to mimic N/A power curve and making little less max torque due to the smallbox tranny. But driveability is very great. I had 350Nm below 3k so car feels very quick.
    • Looking to sort out a couple of issues on my skyline  It recently was rebuilt, however rebuilder long story short did not give two flying effs about the work he did. So moving forward it's running but I have two persistent issues 1) it has a misfire / lag type of issue (was at higher RPMs but I had a dead piggy back ecu removed which improved it) now it's not as bad but still does it at random, I thought it may have been a boost issue I'm running an older turbosmart dual stage controller, turbosmart told me to try running off gate pressure however it still has a lag at random times. It has New MAF, maf plug, coil packs, sparks, CP harness.. injectors tested and cleaned. Factory ECU. 2) Power steering issue. It is tight as anything. Flushed power steering, rebuilt my pump because the bearing was shot. Flushed again still tight (mainly when parking and going slow into my driveway etc)  No kinks in hard lines, replaced the lines I could see had cracks. Still tough to steer.  I was told to shim a coin and place into the solenoid plug? Is there anything else. My steering angle sensor also has a issue. It's a used one I replaced, does it need to be calibrated? I feel like I've tried everything and this car is my voodoo doll.   
    • Holy shit... wow!!! I totally missed this
    • One main filter. Each tank has a prefilter to keep rocks and small children out, then the big main filter that also does water separation. Clogged the first one so bad it was like a rev limiter at 3200rpm. Literally just like dropping the throttle off and maintaining rpm!
×
×
  • Create New...