Jump to content
SAU Community

Recommended Posts

Hi all,

I have had my car for over a week now and today have noticed, after cleaning the carbon build up from my bumper that there are small pin sized rust spots all over the car, i am pretty sure it is rust as it is the same color as rust, it is not paint. I can get these rust spots out with polish, but it will be a big job, to polish the whole car, I will get it professionally detailed, machine buffed, etc.. to get rid of them, seems the easiest way, has anyone had a similar problem, or know what causes this?

Also, i have a large rust area where the boot lid has been scratched, what is the best way to stop this from rusting further and cleaning it up?

thanks

Kris

Link to comment
https://www.sau.com.au/forums/topic/24785-small-rust-spots-all-over-car/
Share on other sites

are you sure they're rust spots? I mean, to see rust appear, the pin sized scratches would need to have cut through the clear coat, the base coat and the primer. Stone chips at the front of the car will do this, but all over the car? Not likely.

Check the bonnet - if you see any on there, chances are they're not rust as the bonnet is aluminium.

To prevent the rust spreading on the boot lid, you really need to clean the area up, apply an anti-corrosion liquid and have the damage repainted.

thanks, but it honestly has to be rust, i understand what you are saying but after getting second opinoins it appears to be rust spots, i honestly don't know why or how, maybe previous owner was a beach goer and the salt from the beach got to it, not too sure,

i will see if a detailer will get them out for me as for the boot, it is not serious as yet so i will stick to my plan and get my engine mods first

thanks

kris

hi if you live in or near coastal areas. open metal ie chips on your cars body are very sesitive to the salty air from the sea.

jetdat is correct, you have to get it back to bare metal ard prime it immediatly. if a fraction is left over, it will eat away the metal again.

also look for those areas that start to bubling up too.

ron

  • 2 weeks later...

skyliner33wa

i recently got the same shit on my car!

i just got a front pipe fitted and it had all this metal shavings in it, and i asked the guy who fitted it to blow it out with the air compressor before fitting it, but i think he forgot :(

now i have all these little orange specs on the back of my car, even on the rear BUMPER which is plastic. i think the metal particles must have blown out the exhaust and got stuck to my bumper, then rusted when it rained. pretty pissed off, they dont come off very easily.

Chris.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • When you crank your car, and hit it with a timing light, can you see a steady crank timing?
    • Oh, forgot to add, A few months ago I was getting mixture codes and the car was using crap loads of fuel. You could smell the unburned fuel in the exhaust, it was crazy strong. Economy was over 17.5 l/100 and usually around 19. I smoked the engine and found a leaky CCV hose which I replaced and then I replaced my two pre cat O2 sensors, I also replaced the MAF. This fixed my mixture codes and improved my exonomy but I'm still 14 - 15 l/100 when pottering about town so something is still amiss. Throttle response is much better and it has more pep but I'd like to know why it's still so thirsty (and I'm hoping that whatever it is gives me a bit more poke).    
    • Car is on factory injectors/z32 maf/ q45 throttle body/ z32 ecu with nistune 
    • Hello all, currently finishing up a rb25 swap into my s14. Having issues with starting, car has spark (confirmed by pulling a plug and watching it spark), has fuel(confirmed by checking pulse/voltage at injectors all spark plugs are soaked in fuel). Car cranks over and pops into the exhaust with a heavy fuel smell but no attempt to start or run, I have torn the timing cover off and triple confirmed timing, turned the CAS in multiple spots both directions, attempted to start with coolant temp and maf unplugged, checked my fuel lines and made sure they weren’t backwards, checked voltage at cas/injectors/coilpacks, made sure all the grounds in the harness are connected and added a few grounding straps (1 from chassis to block, 1 from chassis to head, and 1 from chassis to igniter chip) I am getting stumped here. As a last ditch effort I made a full grounding harness tonight that’s going to run from the battery and add an extra ground from the battery onto the coil pack harness/igniter chip/ intake manifold/ Wiring specialties harness ground/ and alternator. I’m hoping maybe the grounding harness will fix it here but posting here to see if anyone has any other ideas on what else I can check. My fuel pressure is unknown right gauge will be here tomorrow.  IMG_3206.mov
    • yeah I was shocked when I checked my spare OEM on and as below that's how they come from Nissan. (side interesting note new NEO gearbox and replacement park lack the brass bush on the tips and its just all alloy) unsure about damage to the box currently back at 1110 to be pulled down/inspected and selector fork replaced as he built it previously and given the never before seen failure on his billet forks he is replacing it under warranty. He said he has used always OEM the keyway tab without issue for years so it could be an unlucky coincidence. I did talk to him about the sharp corners and stress concentration too. Re: hard shifts i got 7+ years out of the OEM one and the fork itself failed not the keyway. so could be bad luck as I said or an age thing + heat cycles in box and during fabrication of billet?
×
×
  • Create New...