Jump to content
SAU Community

Recommended Posts

  • Replies 47
  • Created
  • Last Reply

Top Posters In This Topic

a friend of the family used to have a pulsar ET turbo (FWD)

let me explain his dilemma... its wet turning across an intersection, mate turns steering wheel, car keeps going straight

$3000 later and it makes you wonder

if you lose it in a RWD car you can easily regain it. loste it in a FWD car and you better hope you have nothing within a 20m radius of where you are!

Link to comment
https://www.sau.com.au/forums/topic/25752-fwd-vs-rwd/page/2/#findComment-547523
Share on other sites

Originally posted by WazR32GTSt

if you lose it in a RWD car you can easily regain it.

That's an exceptionally dangerous generalisation. I've seen the opposite, and it's the very reason I don't drive 10/10ths on the road in ANY car.

Link to comment
https://www.sau.com.au/forums/topic/25752-fwd-vs-rwd/page/2/#findComment-547538
Share on other sites

Yeah same here. One day it was wet and I took a bend a little too hard in my Skyline and before I knew it, my car was facing the other way on the road. Now, normally I'm ok with handling the rear end sliding out, but this time it took me totally by surprise. Now, I never drive my car even slightly hard in the wet.

Link to comment
https://www.sau.com.au/forums/topic/25752-fwd-vs-rwd/page/2/#findComment-547641
Share on other sites

Originally posted by WazR32GTSt

if you lose it in a RWD car you can easily regain it. loste it in a FWD car and you better hope you have nothing within a 20m radius of where you are!

i wonder how do u drive as u can EASILY regain the lose of yr line, u must be a pro racer or a drift expert.

a rwd WILL understeering and a fwd can oversteering.

but in fwd usually won't oversteering, so u only have to look after the understeering when u drive hard.

Link to comment
https://www.sau.com.au/forums/topic/25752-fwd-vs-rwd/page/2/#findComment-547684
Share on other sites

If you are a slow sensible driver, FWD works fine. The handling characteristics are safe and predictable, and there will be more traction in the wet because most of the weight is on the driving wheels. The main disadvantage is chronic understeer, which is actually good. Even a poor driver will instinctively back off before the car goes totally out of control, so its safe for granny to drive. The main disadvantage is very high front tyre wear compared to anything else.

RWD is a better performance setup though. It will have more ultimate traction in the dry and better handling characteristics. For a young guy far better than FWD. But this assumes an IRS, rear disk brakes, and probably an LSD as well. It is going to be better for an enthusiast, but not so safe for a poor driver, especially in the wet with a lot of power.

4WD is by far the best overall package. Yes, it weighs about 80Kg more, but the drivetrain loss is very misleading. I can tell you for a fact that converting a FWD car to 4WD (Laser) resulted in an improvement in fuel economy and a massive reduction in tyre wear. I have read somewhere that driving all wheels consumes less power than trying to push or pull a pair of undriven wheels. It has something to do with the hysteresis losses in flexing the rubber in the tyres.

On a dyno, 4WD show lower power output than 2WD.

But if you put your 2WD on a 4 roller dyno and coupled the rollers somehow, so the driving wheels were forced to turn the loaded non driven wheels, net power output would be greatly reduced. And that is exactly what happens on the road.

You gain more from reduced tyre losses than you lose through a few more ball bearings and an extra diff. Few people realise this though.

Link to comment
https://www.sau.com.au/forums/topic/25752-fwd-vs-rwd/page/2/#findComment-547725
Share on other sites

haha... don't think i have seen one convincing argument why to go for the RWD over the FWD and its probably true.

Generally RWD cars just have the capacity for more power. I think its mainly because of the usual transverse mount and requirement for a smaller gearbox mean you don't get totally hyper FWD cars, but maybe if its your first car that isn't necessarily a bad thing.

Link to comment
https://www.sau.com.au/forums/topic/25752-fwd-vs-rwd/page/2/#findComment-547761
Share on other sites

Well the best of luck.

His dad was probably driving before he was even born, and as you grow older your perspectives change quite a lot. (I am an old fart myself).

While "junior" is probably getting all excited about power to weight ratios, and standing quarter mile times, "granddad" just wants to get there safely, and without breaking down, or having to completely refill the fuel tank every three days.

After a while you are just happy to sit on, or just below the speed limit, and watch the crazy hoons tear past, followed three cars back by the uniformed copper in the unmarked police car. Hehehe.

You see the poor young guy pulled up a mile down the road, with the bonnet up, and the copper with his foot on the front bumper, busily writing on his clipboard. Been there, done that.

You become very philosophical in your old age.

Link to comment
https://www.sau.com.au/forums/topic/25752-fwd-vs-rwd/page/2/#findComment-549813
Share on other sites

It would be hard to convince your dad (since he's buying) to get a RWD over a FWD....

It is true that FWD will tend to understeer when pushed hard around a corner, but do you know that frontal hit is much more safer than a sideway? The whole bonet area in modern cars will act an impact absorber, so the shockwave is not as great. As the matter of fact, car manufacturers design their cars to induce initial understeer to promote hitting a "target" with the crumple zone, even in RWD cars like Skyline (unless suspension has been modified).

On the other hand, RWD will tend to oversteer, which means you'll be facing either sideways or backwards towards what you're about to hit. If you spin 180 degrees and hit it backwards, it won't be too bad as the boot area also acts as a crumple zone

However.... the scary stuff...

If you hit whatever it is sideways.... occupants are more likely to get injured if their car is wrapped against a pole.

Not all FWD 2003 models are crappy... some are quite nice indeed. Get something in the hot hatches family, Golf R32 (coming soon), Focus, Clio, Astra... I wouldn't mind to get one if someone is buying me...

I've been driving on the road for 15 years, and most cars I saw in the news wrapped against a pole and badly injured (or killed) its occupants are RWD... I have no statistics to prove this but this is from my memory recollection watching TV news so far... I agree FWD is safer for city driving, and RWD is best left for sport/performance driving.

Link to comment
https://www.sau.com.au/forums/topic/25752-fwd-vs-rwd/page/2/#findComment-550065
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Pressure when IDLING, is meant to be 51PSi... So that amperage value needs to go up a fair chunk... I'd personally be factoring for more like 12amp at least on those runs, and at that point you need to hope the already there wiring doesn't drop you a volt or two, as that's a lot of fuel pressure flow drop off from 13.5 to 12V! Taking idle pressure of 51psi, means the pump will be drawing a MINIMUM of 9amps all the time based on your reading of the graph (3bar base, then allowing an extra 0.5bar for boost = roughly 51psi)
    • Hi all,  I am in the market for an R200 longnose diff out of a Z31 300ZX, or S12 RSX, DR30 skyline, or similar, in a 3.9 ratio.  Preferably a late model one with the M12 crownwheel bolts.  The only easy to find advert for one of these was my ad back in 2007 when I sold it on this forum.  I sold the diff as I had sold the car it goes to, but as it turns out, after 18 years I got the car back late last year, so now I'm looking for the diff !  If anyone knows where to find a longnose R200 LSD with the M12 crownwheel bolts, drop me a line at [email protected] - Bonus paid if soomeone comes up with the original diff (stranger things have happened !).  Cheers   Ben D    
    • Hi everyone, I used to post here a bit from 2004-2013, when I owned various Nissans, in particular my S12 RSX gazelle, which was sold in 2007.  As luck would have it, after an 18 year hiatus, the car found its way back to me last year, and over the past 11 months I have had the pleasure of restoring it with my kids.  One thing that I am after in particular is a 3.9 ratio R200 LSD for it.  I actually sold the one out of the car here back in 2007 , and it would be incredible if I could track down who I sold it to, so I can see how they have progressed over the years (and to be honest, to see whether I can get the diff back !).  Anyways, hi all and let me know "where are the R200 Longnose diffs all at these days ?  Cheers Ben D  
    • Arms will be the same as the G35 or 350Z, but as above, there was a change in the lower control arm where it connects to the ball joint.  That said, you can remove the ball joint cone from your old ball joints and fit them to the new ball joints.  To be honest, I didn't think the ball joints themselves were different. The main ball joint is a bit awkward to replace, you really need to remove the steering knuckle to press out the old one.  Some people have used tools to remove it in place, but it just seemed too hard to get to. If you are going to press out/in that ball joint, then you may as well just replace the bushings in the LCA and the compression rod.  You can buy the compression rod bushing from Nissan, but the LCA bushes, you will need to go aftermarket. Much cheaper than buying the whole arm.
    • Ha, well, it's been.... a bit of a journey. Things have taken much longer than I'd hoped. I'll probably put up a thread at some stage. Hopefully soon. The car's not done any kms since my update in June though, put it that way.
×
×
  • Create New...