Jump to content
SAU Community

Recommended Posts

Hi I just bought a GTR34 vspec, and want to make sure everything is safe.

now the car currenly run 380kw on wheel 21psi, boost by t517z*2. the turbo lag is really big, full boost around 6000rpm. and the AFR is look a bit lean, 4000rpm about 12AFR 7000-8000 around 13AFR.(I don't know about GTR, but my evo is allways under 12) the owner told me is very safe, no need retune. and the injector is nismo 600cc. if i don't want tune up the power do i need some bigger injector???the highest injector duty is about 90%+. but i'm sure its not 100%

the car only done 2500kms after engine rebuild. so i may need change to full syn engine oil when its up to 3000kms.

and the car doesn't have power fc hand controller. do i need one???

can you guys give me some suggestion, what should I do next??? retune it?? bigger injector?? etc....

the car running really good, its not like a 10 years car. and many nice mods. easy daily drive. I just don't like the big turbo lag.

please help thanks guys!!!

  • Replies 40
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

My advice is to park it in my shed and give me the keys........................lol

When does you boost begin? If its 3,000 -3500 then thats normal. Your injectors could be beginning to lean out at top revs, 90% duty cycle is close to too much, little head room.

You don't need a hand controller, it can be tuned and driven without one.

take it to a reputable tuning shop and get them to check it out, wont cost much considering how much you have already spent buying it.

If you didnt like the lag why did you buy it, would have been plenty of other good powered options to buy that are more responsive.

if you wanna push it harder, you will need bigger injecors. the tune may be alright, just have less margin for crap fuel etc.

what was your last ride before this? an R34 GTR with 380rwkw would be an absolute weapon, if its a street car, stick with what you got, as your just going to add more lag with gains that probly arent all that great, and you may find that the car is actually *slower* in most typical 'street' situations

if u wanna race it, strip it bare (coz its free) and go run some numbers

if you wanna push it harder, you will need bigger injecors. the tune may be alright, just have less margin for crap fuel etc.

what was your last ride before this? an R34 GTR with 380rwkw would be an absolute weapon, if its a street car, stick with what you got, as your just going to add more lag with gains that probly arent all that great, and you may find that the car is actually *slower* in most typical 'street' situations

if u wanna race it, strip it bare (coz its free) and go run some numbers

yeah thats right, I even can't catch up a DC5-R when the boost not coming up. when the boost come up, the DC5 just like stoped.

My advice is to park it in my shed and give me the keys........................lol

When does you boost begin? If its 3,000 -3500 then thats normal. Your injectors could be beginning to lean out at top revs, 90% duty cycle is close to too much, little head room.

You don't need a hand controller, it can be tuned and driven without one.

yes, the boost start around 3000, full boost on 6000.

take it to a reputable tuning shop and get them to check it out, wont cost much considering how much you have already spent buying it.

If you didnt like the lag why did you buy it, would have been plenty of other good powered options to buy that are more responsive.

I like it, maybe I just not used to it.

if you wanna push it harder, you will need bigger injecors. the tune may be alright, just have less margin for crap fuel etc.

what was your last ride before this? an R34 GTR with 380rwkw would be an absolute weapon, if its a street car, stick with what you got, as your just going to add more lag with gains that probly arent all that great, and you may find that the car is actually *slower* in most typical 'street' situations

if u wanna race it, strip it bare (coz its free) and go run some numbers

thank you for reply, my last ride is a 135i and a evo9. the 135i like NA, no turbo lag at all. :)

13 is too lean at the top end.. if it is actually that lean at 7-8000rpm you will kill your engine very quickly. get it on a dyno asap.

OK, the engine just finish rebuild. 13 is very lean I think, but my friend saw a lot black smoke when i push hard. and the 13 is for 410kw tune, I haven't see the 380kw dyno chat yet, but i guess they should be simily. maybe the 380kw's tune is richer.

OK, the engine just finish rebuild. 13 is very lean I think, but my friend saw a lot black smoke when i push hard. and the 13 is for 410kw tune, I haven't see the 380kw dyno chat yet, but i guess they should be simily. maybe the 380kw's tune is richer.

410rwkw on 600cc injectors.. :)

Dont flog it until a retune. Before you retune it though, get some bigger injectors.

Enjoy!

some hard push on street should be allright I think. but of cause no track work, I will definite take it to retune before any track work.

sounds fine to me, 13 is ok and 90% duty is ok

plonk it on a dyno for $50 insurance, but sounds fine

i wouldnt mess with the tune, unless something horribly is shown on the dyno check

Wrong.

:):blink:

Bye bye engine.

You can and will do some major damage unless it's fixed up.EG track day.

Either clean up the tune on the 600cc injectors with less boost etc.

Or upgrade your injectors and fuel system if it needs it.

Mine ran in the high 12's-low 13's a/f when I got my car, as it still had the jap tune. Drove it round for 6 months.

Ignition timing/detonation will do more damage than a leaner a/f.

Just my 2 cents (not worth much lol)

Cheers

:):blink:

Bye bye engine.

You can and will do some major damage unless it's fixed up.EG track day.

Either clean up the tune on the 600cc injectors with less boost etc.

Or upgrade your injectors and fuel system if it needs it.

Mine ran in the high 12's-low 13's a/f when I got my car, as it still had the jap tune. Drove it round for 6 months.

Ignition timing/detonation will do more damage than a leaner a/f.

Just my 2 cents (not worth much lol)

Cheers

thank you, i really confuse about the AFR, like my evo, its run 13-12 afr and 227awkw on SJ's dyno). but when I move to QLD, I did a dyno check, its run low 11 and high 10 afr and 195kws on Chiptorque dyno. same tune, different number.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • I couldn't agree more. I should have started from the get-go with a NEO or solid bucket conversion. I started looking into converting over to solid lifters yesterday. Now for some reason I was always under the impression that when using the Tomei solid lifter conversion, you would also require new valves (Longer or shorter stems, I can't remember which).  But I see no mention of this on any of the Tomei documentation. It just states I need the Tomei solid buckets, solid lifter cams and upgraded springs. As my head is already built, all I would need is another set of 1000$ Kelford cams, 500$ buckets and about 4H hours of my time installing and I'm off to the races!?!? There's no way it's that simple, I must me missing something? 
    • BRUH, one of the biggest mistakes of my life..... and i've had plenty ;[)
    • @Murray_Calavera iam just considering options 🙂 of course it is very expensive so that why i ask here 🙂  @joshuaho96 I looked at that GCG hybrid(i remember looking at it few weeks before) So this is "that" hybrid where i send them my turbo and they upgrade the inside to Garrett stuff and then they send it back. It cost around 1200-1300 USD which is FAR cheaper than the HKS and it is what iam looking for(i just do not have experience like this...to send something off to "upgrade" ) @tylink720 that is like 150 USD turbo no? 😄 I dont think i have the "ease on my mind" with this kind of turbo. I just put over 7000k USD to "LINK" up my engine...dont want to blow it up with cheap turbo 😄     EDIT: https://www.cj-motor.com/gcg-turbo-charger-for-nissan-rb20det-rb25det-high?srsltid=AfmBOooVeOZ6CZ6r1AIv5m-KPaa6BvudIPJTY8LW78khkd-gQlsaCht9 I looked at this and it seems ok? It is that CGC hybrid and it costs around 1250 USD (with back shipping). Do any of you have experience with this hybrid on NEO turbo? I quickly look thru the forum/web and it seems very good.
    • Echo the awesome sentiment 👍 Definitely a car worth saving. Looking forward to seeing updates as well. 
    • Scenic roads, stunning skylines, and Chickos to finish it off! Join SAU NSW as we cruise through the Royal National Park and along Lawrence Hargrave Drive to Figtree! Sunday 26th October 2025 4:30PM Meeting Waterfall Station Parking 5:00PM Cruise Departure Royal National Park > Lawrence Hargrave Dr > Memorial Dr > Sid Parrish Park 6:15PM Arrival at Sid Parrish Park Figtree Meet Location: Waterfall Station Parking Final Destination: Sid Parrish Park RSVP: https://forms.gle/E4s5SiRKQfDdypky8 *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
×
×
  • Create New...