Jump to content
SAU Community

Recommended Posts

Hey guys.

Am upgrading my whole engine, and so the turbo and manifold has to go.

Its on a RB25/30, so 25 head, but has the same bolt pattern for an rb26.

The manifold has a extreme turbo manifolds 6 into 1 collector, but i built the rest of it.

Reason for upgrade is am going T4 style turbo, so the T3 flange won't do.

The turbo is a GT3540r aka GT35r with a .83 ex housing which has been ceramic coated. The compressor cover has been polished. The turbo is tops and is extremly streetable!!

The wastegate is a Innovative Turbo Systems, 40mm

It is awsome. holds boost well and cost a fair bit at the time.

I managed 271rwkw through a high stalled auto with 18psi boost.

I want $2500 for the lot.

Yes it includes the dump pipe too as well as the screamer pipe thats attached to the wastegate.

Pics are attached.

I will be removing it from the car tomorrow.

Please PM me or call/sms 0412957329

Caringbah area

post-3804-1245405945_thumb.jpg

post-3804-1245405967_thumb.jpg

post-3804-1245405978_thumb.jpg

Added

Am upgrading the head to GTR head, so head available

Its a RB25 one, not entirely sure which one, though the front oil gallery has been modified for direct bolt on to an RB30 block. Its non VVT.

The ports have also had a little tickle and polish.

Stock cams and has coil packs also covers inc valley cover which says 'RB POWER'

Looking for $700ono

or $3000 inluding manifold and turbo.

Thanks

Rob

Not sure of the K's, i'd say around 5000-7500k's

Yah can sell just the turbo for about $1500. Don't forget its been polished and ceramic coated.

  • 1 month later...
is this stil for sale"

Hey guys, turbo and wastegate still for sale. Don't get on here very often to check.

head, manifold, all gone.

Best to PM me if you want anything.

How big is the inlet on the wastegate 46mm?

and got any pics of it?

thanks

I think its a 40mm

It might seem small, but it works damn well!!

post-3804-1249195143.jpg

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • What copper washer do you guys use on the bleeder bolts? The existing one I have I had no idea where to find it in a local store, I did buy some online but that are only 1mm thick whereas my old one is 2mm+ thick and when I put the new washer out and squeeze the top radiator hose I can hear a bit of air but not with the old one. Does this matter? The new one doesn't leak, but the inner diameter is a bit loose whereas the old one threads on the bolt.
    • Howdy all, after being out a few weeks ago on a spirited drive in my GTR I have 2 issues that oddly have appeared at the same time. Whilst accelerating quickly through the gears all of a sudden i’ve lost power at the top of third gear (below redline around 6000rpm) for no obvious reason.    From that point onwards the car has been running rich on idle, won’t really rev under load without a ton of black smoke and the odd backfire, and dying as a pull up to a set of lights unless I keep the revs up around 1500rpm. In addition when shutting down the car that same night (I was 10 minutes from home) I noticed one of the turbos was significantly noisy on wind down when shutting off the engine. After letting the car cool down overnight it starts up fine, although once it gets to temp the revs start to creep up and down, the exhaust is darker than it should be and it also sounds like it’s running rich (fat note) I’ve put a new set of plugs in it - no change, the old plugs all seemed OK with two of them being somewhat richer/fueled up than the other 3 with 1 being borderline. I’ve smoked tested the intake system via the front of the Turbos, found a split vacuum hose going to the factory boost gauge sender, which I have since replaced.  Also found another leak on the gasket coming off the rear turbo outlet, have also replaced this. After fixing both of these leaks - still have the running rich issue. I’ve also tried another pair of AFM’s - no change here After pulling off the front turbo intake pipes, there is obvious shaft play in the front turbo, which now hisses loudly on light revvs although I can’t see why this would make the car run funny even under idle. I’m curious to know why it’s running rich before I potentially replace/rebuild turbos. The car is completely stock <50,000kms  other than an exhaust. Oil and coolant are all clear. I haven’t bothered with coil packs as it looks like they won’t be the issue due to condition of the plugs. Any help appreciated as I cry myself to sleep!
    • No probs at all. I used to love trying to dig up obscure info for those in need where possible going back 20+ years on SAU.  I did have another look and couldn't come up with any closer match. I'm leaning towards those skirts in your first pic are custom fitments, cut down/extended or from another car entirely and modded to fit an R34 sedan. I would've thought someone in Japan had them and taken a photo at some stage over the last 2 decades but there's nothing. Someone out there must know surely.
    • Welcome mate. Any pics? Even with a DE I'd be well happy if I had that as a 1st car. 
×
×
  • Create New...