Jump to content
SAU Community

Flutterdump?

Ninja gts25t
 Share

Recommended Posts

Benzino33 Experienced

Benzino33

Posted
Posted
What is flutter dump? the otherday a r33 blew past me and did this i wana know how to do this

thanks :)

Are you referring to the blow off valve noise or "turbo dose" noise?

If so here's a thread all about it.

http://www.skylinesaustralia.com/forums/st...Tu-t276031.html

Link to comment
https://www.sau.com.au/forums/topic/282335-flutterdump/#findComment-4754663
Share on other sites
lineskee 33 Community Regular

lineskee 33

Posted
Posted

i didnt think it was even possible to get wastegate flutter. I think you may be meaning an external wastegate? if the car was really loud going past while on boost, it would be that. its a screamer pipe that goes onto the wastegate. this is illegal to have, but on the right setup it sounds good.

Link to comment
https://www.sau.com.au/forums/topic/282335-flutterdump/#findComment-4754718
Share on other sites
bradsm87 Proficient

bradsm87

Posted
Posted

Flutterdump is when the BOV is a cheap POS or the spring in the BOV is too stiff and U back off and it starts fluttering then the BOV vents. It's considered a problem and can be fixed with a much softer spring. As long as the BOV is plumbed back like it should be, it can be soft enough to stay open on idle without and probs. As soon as U give it the tinyest bit of throttle, it slams shut.

Link to comment
https://www.sau.com.au/forums/topic/282335-flutterdump/#findComment-4754998
Share on other sites
Guest
This topic is now closed to further replies.
 Share
Go to topic listing


  • Latest Posts

    • GTSBoy
      Looking for someone with a R34 front bar

      By GTSBoy · Posted

      Surely, if you have the indicator in hand and a pair of verniers, you can measure it up and draw your own cut template? I mean, it's got to pretty clear what has to pass through the hole, what has to sit on the outside face of the hole, and what has to be able to pass through and perhaps clip into place on the back side.
    • Steal01
      Torana Lx Gtr Hatch, Lots Of Pictures

      By Steal01 · Posted

      Man, I hope this one gets finished  i just randomly remembered it the other day and thought I’d check in. 
    • Roy
      A Boy's Love For His Rb20

      By Roy · Posted

      Started sifting thru my brakes to decide which ones I will run on Clem   Made me think I should just put them all on Silver...for when brake fade just isn't an option   Should be able to bump rotor up from 343x32 to 348x36 off Supra. Not sure if the Supra annulus is right for the Alcons or APs but trying g to find a used Supra\M4 rotor to test fit The Alcons seem to gain 1-2mm clearance which all helps  
    • Roy
      A Boy's Love For His Rb20

      By Roy · Posted

      So car is getting a few mods to the cage and some jacking points welded in Meantime Ol Silver gets a new gearbox and shiny clutch.  Old Box is being set aside for Clem  
    • joshuaho96
      HR34 GT speedo issue

      By joshuaho96 · Posted

      Probably speedometer itself if the odometer is ticking. If the needle is stuck from a bit of grease or something that can cause it to stay at 0. Or a cracked solder joint in the speedometer can do it too.
×
×
  • Create New...