Jump to content
SAU Community

Recommended Posts

What is flutter dump? the otherday a r33 blew past me and did this i wana know how to do this

thanks :)

Are you referring to the blow off valve noise or "turbo dose" noise?

If so here's a thread all about it.

http://www.skylinesaustralia.com/forums/st...Tu-t276031.html

Link to comment
https://www.sau.com.au/forums/topic/282335-flutterdump/#findComment-4754663
Share on other sites

i didnt think it was even possible to get wastegate flutter. I think you may be meaning an external wastegate? if the car was really loud going past while on boost, it would be that. its a screamer pipe that goes onto the wastegate. this is illegal to have, but on the right setup it sounds good.

Link to comment
https://www.sau.com.au/forums/topic/282335-flutterdump/#findComment-4754718
Share on other sites

Flutterdump is when the BOV is a cheap POS or the spring in the BOV is too stiff and U back off and it starts fluttering then the BOV vents. It's considered a problem and can be fixed with a much softer spring. As long as the BOV is plumbed back like it should be, it can be soft enough to stay open on idle without and probs. As soon as U give it the tinyest bit of throttle, it slams shut.

Link to comment
https://www.sau.com.au/forums/topic/282335-flutterdump/#findComment-4754998
Share on other sites

Guest
This topic is now closed to further replies.


  • Latest Posts

    • Hi All,    I have my BW EFR 8474 with a T4 split 1.05 rear housing. Rear housing is ceramic coated and drilled and tapped for EMAP take off.  Supported 520awkw at 35psi through the 8HP with ~5k rpm spare on the BW 127k limit. Ran a 9.98.    Turbo is one of the first that was released but only done ~3k kms.    Asking $2800 happy to negotiate. Only selling to upgrade.   Located Gladstone QLD happy to ship. 
    • Hi is the Toshiba sceeen still available?
    • Just wondering how come the hood was grinded down? 
    • I have no hard data to report, but I have to say, having driven it to work and back all week, mostly on wet roads (and therefore mostly not able to contemplate anything too outrageous anywhere)..... it is real good. I turned the boost controller on, with duty cycle set to 10% (which may not be enough to actually increase the boost), and the start boost set to 15 psi. That should keep the gate unpressurised until at least 15 psi. And rolling at 80 in 5th, which is <2k rpm, going to WOT sees the MAP go +ve even before it crosses 2k and it has >5 psi by the time it hits 90 km/h. That's still <<2.5k rpm, so I think it's actually doing really well. Because of all the not-quite-ideal things that have been in place since the turbo first went on, it felt laggy. It's actually not. The response appears to be as good as you could hope for with a highflow.
    • Or just put in a 1JZ, and sell me the NEO head 😎
×
×
  • Create New...