Jump to content
SAU Community

Recommended Posts

What is flutter dump? the otherday a r33 blew past me and did this i wana know how to do this

thanks :)

Are you referring to the blow off valve noise or "turbo dose" noise?

If so here's a thread all about it.

http://www.skylinesaustralia.com/forums/st...Tu-t276031.html

Link to comment
https://www.sau.com.au/forums/topic/282335-flutterdump/#findComment-4754663
Share on other sites

i didnt think it was even possible to get wastegate flutter. I think you may be meaning an external wastegate? if the car was really loud going past while on boost, it would be that. its a screamer pipe that goes onto the wastegate. this is illegal to have, but on the right setup it sounds good.

Link to comment
https://www.sau.com.au/forums/topic/282335-flutterdump/#findComment-4754718
Share on other sites

Flutterdump is when the BOV is a cheap POS or the spring in the BOV is too stiff and U back off and it starts fluttering then the BOV vents. It's considered a problem and can be fixed with a much softer spring. As long as the BOV is plumbed back like it should be, it can be soft enough to stay open on idle without and probs. As soon as U give it the tinyest bit of throttle, it slams shut.

Link to comment
https://www.sau.com.au/forums/topic/282335-flutterdump/#findComment-4754998
Share on other sites

Guest
This topic is now closed to further replies.


  • Latest Posts

    • Photo quality is terrible, but there's a few things on that board that give me suspicions it has some issues. Add to that, I'm hoping the cut and exposed wires under the dash were not exposed or touching each other before you pulled that all apart.
    • Stories like this are why the immobilizer installs I've done are 100% reversible. No harness cuts.
    • update; Replaced oem starter motor with a Jaylec 70-61111 car still didn't start, moved over to the alarm system unraveled the spaghetti checked the solder end points, PCB board burn smell, wiring ends, capacitors, water damage everything looked fine restarted car vroom. restarted 5 to 6 time over an hour started put every thing back together only to not have it start any more. looks like i will be removing the alarm system next weekend.      
    • Lots of people. Could be a lot of things like people have said. Either the heater hose/pipe, the turbo coolant return that wraps around the back of the engine, or a core plug. I have seen all three. If you want me to guess wildly though I would bet it's one of those hoses for the turbo coolant return. Or the brazing/welding for the Y- section has failed. Get a borescope down there to be 100% sure.
    • FWIW, I've aerated oil, and cams snapped. You can figure out the rest 🥲
×
×
  • Create New...