Jump to content
SAU Community

Recommended Posts

  • Replies 145
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

that looks awesome.. is that a 25 or 26 head.. and does that say 3.0L on it?

Yip I have used a R33 RB25 head. And yes I had custom sticker/decal made for the cover to read

NISSAN 3.0

24 VALVE TWIN CAM

I sell the decals on Trademe.co.nz in the parts section for Nissans

(Pic below is earlier than original pic above while the engine was fitted to spare R32 Skyline. It was while I was sorting battery relocation, intake setup and plenum-to-bonnet clearances)

Nigel

post-45877-1254873680.jpg

Edited by Nigel Nichols

i dunno didnt think there was enough room to go down through the inside of the bay..... Mate has a washer bottle mounted on the front of his car so it sits between the engine bay and front bar kinda deal. Looks nice with just the cooler pipe going through the bay.

Im getting mine put on soonish so just workig out the last couple of things.

Ive often wondered wether you can still use a plazmaman plenum and still keep the washer bottle position??

any one know for sure?? (PM-R33???) Looks like its an easier fit with the Greddy style ones?

i kept it with mine, so yes you can

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Well the install is officially done. Filled with fluid and bled it today, but didn't get a chance to take it on a test drive. I'll throw some final pics of the lines and whatnot but you can definitely install a DMAX rack in an R33 with pretty minor mods. I think the only other thing I had to do that isn't documented here is grind a bit of the larger banjo fitting to get it to clear since the banjos are grouped much tighter on the DMAX rack. Also the dust boots from a R33 do not fit either fyi, so if you end up doing this install for whatever reason you'll need to grab those too. One caveat with buying the S15 dust boots however is that the clamps are too small to fit on the R33 inner tie rod since they're much thicker so keep the old clamps around. The boots also twist a bit when adjusting toe but it's not a big deal. No issues or leaks so far, steering feels good and it looks like there's a bit more lock now than I had before. Getting an alignment on Saturday so I'll see how it feels then but seems like it'll be good to go       
    • I don't get in here much anymore but I can help you with this.   The hole is a vent (air relief) for the brake proportioning valve, which is built into the master cylinder.    The bad news is that if brake fluid is leaking from that hole then it's getting past the proportioning valve seals.   The really bad news is that no spare parts are available for the proportioning valve either from Nissan or after market.     It's a bit of a PITA getting the proportioning valve out of the master cylinder body anyway but, fortunately, leaks from that area are rare in my experience. BTW, if those are copper (as such) brake lines you should get rid of them.    Bundy (steel) tube is a far better choice (and legal  in Australia - if that's where you are).
    • EMU Classic. For what I need it to do I see no reason to upgrade. Link and Haltech would both cost an extra chunk of money for a lot of unutilized features
×
×
  • Create New...