Jump to content
SAU Community

Recommended Posts

I saw this dyno sheet before. This is comparing to a Hypergear's highflowed R33 turbo not a OP6 R34 turbo. So the OP6 rear housing would have picked up better power and torque and the R33 turbo is better in response.

Pretty nice-looking dyno sheet there Warlord... would love to get my stagea's dyno sheet looking like that. What stopped you from going higher than ~15 pounds?

running stock FPR man. with stock injectors i was making 230rwkw but with a fair bit of pinging and maxing out the injectors. the 500cc injectors fixed that but didnt wanna max them out so to keep it all safe its been tuned to 247rwkw.

Ah ok cheers. I didn't know 230rwkw was possible on the stock fuel pressure *and* injectors :happy: What was the limiting factor with your last tune on the 500's? Surely not engine internals yet...? :blink:

I take it back Im sorry. It does lose boost like a freight train (so does mine) but ive never seen a highflow pull such high figures on such low boost.

Out of interest what could it run up to 19psi-20psi I expect?:

The turbo was purchased by me

It has made 274.2 rwkw tuned by 'Femno' at AceWorkshop on a 2008 Dyno Dynamics

on 16 psi

Rb25DET (standard internals)

Stock injectors

Stock AFM

Nismo Fuel reg

Bosch pump

Exhaust

Power FC

Cooler

The afrs were extremely safe

We believe that the turbo is roughly at its max potential

Thanks a heap Matt

Top Bloke

Cheers

post-18581-1256383588_thumb.jpg

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Put a fuel pressure gauge on it. Replace the turbos. Probably completely separate issues.
    • What copper washer do you guys use on the bleeder bolts? The existing one I have I had no idea where to find it in a local store, I did buy some online but that are only 1mm thick whereas my old one is 2mm+ thick and when I put the new washer out and squeeze the top radiator hose I can hear a bit of air but not with the old one. Does this matter? The new one doesn't leak, but the inner diameter is a bit loose whereas the old one threads on the bolt.
    • Howdy all, after being out a few weeks ago on a spirited drive in my GTR I have 2 issues that oddly have appeared at the same time. Whilst accelerating quickly through the gears all of a sudden i’ve lost power at the top of third gear (below redline around 6000rpm) for no obvious reason.    From that point onwards the car has been running rich on idle, won’t really rev under load without a ton of black smoke and the odd backfire, and dying as a pull up to a set of lights unless I keep the revs up around 1500rpm. In addition when shutting down the car that same night (I was 10 minutes from home) I noticed one of the turbos was significantly noisy on wind down when shutting off the engine. After letting the car cool down overnight it starts up fine, although once it gets to temp the revs start to creep up and down, the exhaust is darker than it should be and it also sounds like it’s running rich (fat note) I’ve put a new set of plugs in it - no change, the old plugs all seemed OK with two of them being somewhat richer/fueled up than the other 3 with 1 being borderline. I’ve smoked tested the intake system via the front of the Turbos, found a split vacuum hose going to the factory boost gauge sender, which I have since replaced.  Also found another leak on the gasket coming off the rear turbo outlet, have also replaced this. After fixing both of these leaks - still have the running rich issue. I’ve also tried another pair of AFM’s - no change here After pulling off the front turbo intake pipes, there is obvious shaft play in the front turbo, which now hisses loudly on light revvs although I can’t see why this would make the car run funny even under idle. I’m curious to know why it’s running rich before I potentially replace/rebuild turbos. The car is completely stock <50,000kms  other than an exhaust. Oil and coolant are all clear. I haven’t bothered with coil packs as it looks like they won’t be the issue due to condition of the plugs. Any help appreciated as I cry myself to sleep!
    • No probs at all. I used to love trying to dig up obscure info for those in need where possible going back 20+ years on SAU.  I did have another look and couldn't come up with any closer match. I'm leaning towards those skirts in your first pic are custom fitments, cut down/extended or from another car entirely and modded to fit an R34 sedan. I would've thought someone in Japan had them and taken a photo at some stage over the last 2 decades but there's nothing. Someone out there must know surely.
×
×
  • Create New...