Jump to content
SAU Community

Recommended Posts

  • Replies 14.2k
  • Created
  • Last Reply

Top Posters In This Topic

hot week next week, unfortunatly my aircon compressor bearing is siezed, any ideas on cost for repairs?

My aircon compressor clutch is fecked, been like it ever since I bought it. Got quoted roughly $450 for a s/h compressor, fitting and gassing from Jaustec.

My aircon compressor clutch is fecked, been like it ever since I bought it. Got quoted roughly $450 for a s/h compressor, fitting and gassing from Jaustec.

thats who i was thinking of going through, how long ago was that quote done?

think i might go without it for a while longer then, haha.

10933_172226729215_656279215_2648386_5721898_n.jpg

ITS ALIVE !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

Finally good to see Mitch...i am guessing that you haven't hooked up the stock boost gauge line either?? and as far as i know there should be a connection for the oil pressure....ahh well just get aftermarket gauge that will prob be more accurate

My aircon compressor clutch is fecked, been like it ever since I bought it. Got quoted roughly $450 for a s/h compressor, fitting and gassing from Jaustec.

took my R31 to a place in lonsdale on o sulleys rd near the old ASV building who fixed the leak , new condenser and swapped out the compressor for about 300 all up including regas,top work for cheapest I could find around the south.

gotta love the ole UFC Damo......NOT for the faint hearted though (I know Carl - Bezender would agree with me)

I'd love to go toe to toe with a couple of the serial pests on these boards....may even teach them a little respect for the old fellas, lol :)

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • The filter only filters down to a specific size. Add to that, the filter is AFTER the pump. So it means everything starts breaking your pump even if its being filtered out.
    • Just like in being 14mm too small (296mm) makes it not fit, being 14mm too big (324mm) it also won't fit. You want to find the correct rotor.
    • @GTSBoy Ok so that was the shops problem...they showed R33 rotors on R34 page and i did not know 296 do not fit(and are for R33) Yes i bought "kit" with rotors and pads. Pads are ok(i have GTT calipers front and rear). They have some 324mm but no 310mm. So i dont know if they would fit. I have 17inch LMGT4s So another question. Can i fit those in the rear or they are just "too" big for that?
    • I started removing the tank a while back with the intent to give it a proper clean. Got to a bolt that I couldn't undo completely due to a diff being in the way, so just said f**k it and siphoned the gluggy old fuel out and called it a day. Looking it the tank it looks less corroded than the one in the pics for that billet hanger from Frenchy's anyway. Isn't it the fuel filters job to worry about this stuff? I scraped off most the crusty shit of the hanger but will give it another go before reinstall coz maybe the fuel and return pipes are also full of gunk  
    • Pretty sure it is a common fault. I believe this is the only part you need, but don't quote me as I don't have a V36.  I also believe it is a bit of a pain to change and the device needs to be encoded to the car once it is replaced, so may need someone with the right tools. Buy Genuine Nissan 48700JF00D (48700-JF00D) Lock Set-Steering. Prices, fast shipping, photos, weight - Amayama
×
×
  • Create New...