Jump to content
SAU Community

Recommended Posts

  • Replies 14.2k
  • Created
  • Last Reply

Top Posters In This Topic

does anyone know a good place to get some webbing strap sewn?

ie: a tarpaulin or canvas place?

there is a place on o sullivans beach rd in lonsdale , just up past the round about heading towards the beach on the left hand side. nice old couple owns it. they do a lot of work on boats,sails, truck tarps etc.

dammit.........

i just polished of 3/4 a pack of tim tams....

pretty sure im just gonna tell the missus i dropped them on the floor and had to put them in the bin...

eheheh

so what is really stopping ya from polishing the rest of......going down to the shops and getting another pack :rofl:

there is a place on o sullivans beach rd in lonsdale , just up past the round about heading towards the beach on the left hand side. nice old couple owns it. they do a lot of work on boats,sails, truck tarps etc.

That's a bit too far south for my liking haha

I should have said, im up North East and work the City and North areas

Truuuust me, yours would be far more exciting to drive haha

...I highly doubt that at the moment, the most driving i might be doing in mine will be on Saturday as i may drive it on/off of Matt's Car Trailer, as my clutch is fried. Having HUGE withdrawals from boost. I will be going to AJD to have a look see anyway, so up to you.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Working through possible solutions of converting my mechanical speedo.    Anyone know what type of speedo sensor the factory r34 gtr getrag has ? what the output is ? I assume its not a VSS and more a voltage like earlier speedo sensors ? Can an ECU read it ?  
    • roof rail delete used to be a thing, they were made locally for a while too
    • I can get more photos of it here soon and I plan to make a thread detailing the process. I received the car this way and it sorely needs refinishing. That is probably the most appealing photo of it. Up close it is fading, cracked, and needs to be re-glued. Depending on their condition I'm on the fence between refinishing or making a new set.  Another angle hiding the pimples and razor pumps  
    • According to this thread the RS4V with build plate RC40 comes with the R200 diff @ 4.083 ratio as well (mine has said RC40 denotation). We may need to check if the axle stubs are the same pattern as well. The auto subframes have longer axles. However I think yours being a later Series 2 as well, we should have the same bolt pattern for the diff stubs. Unless your upgraded rear also has upgraded axles. Either way, I would not be opposed to pulling the covers to check so I can inspect that  fancy rear core  Also I don't have HICAS. I don't believe that should change things but I hope the people here with heaps more experience than me can correct me if I'm wrong   Let me know if you want to attempt to make this work and I can get some pictures of mine from under the car. 
    • It's not that straightforward. For example I have had this code because my ignitor/power transistor wires were unplugged. It knows something is wrong but has no idea what it means. If you want to actually diagnose this I recommend following the service manual flowchart for code 21. Ohm out the harness, coilpacks, inspect the ECU, etc. And again, it's entirely possible for there to be no problem at all but if you're running a different coilpack it'll trigger the code because it doesn't like what it sees.
×
×
  • Create New...