Jump to content
SAU Community

Recommended Posts

  • Replies 14.2k
  • Created
  • Last Reply

Top Posters In This Topic

Not driving a defectable car.

Hire car ftw.

got stuff on down there, plus do a bit of site seeing.

Why are you all haters down there?

We just hate politicians who hate modified cars

original_img452a3545c10f5.jpg

on a better note, take a look at this link, lots of car hotties (link off a carclub website in USA)

hotties

borderline work safe!!!

I am really annoyed :P , i buy new tie rod ends, get a tyre place to install them when i have new rear tyres done for the track day. I then get an exhaust leak at the track, drop the car off today to get it checked out/fixed and get told the tie rod ends were not installed correctly :ermm: . Luckily the tyre place is just round the corner from my mechanic, and i got him to call them about it, hopefully get them to fix it under some sort of warranty.

... i finished work in about 3hr 45min...HURRY UP, and then i have to work tomorrow :bunny:

Locky's dad just came to pick him up for his week and he started getting upset i asked what was wrong and he burst out crying so hard saying he didnt want to leave then his dad started getting mad with him. :D

Its so heart breaking i just wanted to cry with him and tell him he could stay and everything would be ok but i cant.

i gave him my old phone so he can call me when he wants

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • I don't care for these at all, but at least the underside looks straight and not rusty. A good basis for a long life. Many cars from Japan have been lifted with forklifts and f**ked almost irrepairably.
    • Yes, but it's not dumb or dodgy. You can build a perfectly good boost controller from a pressure reg, a relief valve (looks same same as a reg if all from Norgren or SMC, for example) and a check valve. I ran one for years. Only superceded with  EBC because I could get one for cheaps and wanted finer control.   THis mod is certainly not a sketchy boost mod, provided the boost is kept below the "spin to death" threshold of the turbos.
    • With ordering the belt, you're doing water pump and the idler and tensioner at the same time too yes?
    • This is just a dumb way of keeping the wastegate closed to make more boost. Undo it and either follow the factory setup or redo it properly. Manual boost controllers just use a spring preload to determine when to close in response to boost pressure so it no longer vents to atmosphere.
    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
×
×
  • Create New...