Jump to content
SAU Community

Recommended Posts

  • Replies 14.2k
  • Created
  • Last Reply

Top Posters In This Topic

SH!t, just watch a mate i use to play footy with get layed out by sandilands.....

Kyle Sandilands? Kyle couldn't punch his way out a wet paper bag, let alone lay someone out. ;)

No, not that poof, Aaron sandilands, the Fremantle ruckman

Footy player? They're fairies aren't they? You just touch them and they hit the ground holding a limb and crying!

Hey Steve i hear that you have that engine running. Good to hear that it was all good.

Do you have the Engine Lifting Strap? (The one made out of seat belt material). I tried to find it the other day but i think i may have lent it to you?

Edited by D_Stirls
if they were 8s and 9s, perfect offset for a 31 streeter actually

but they're not, so agreed ;)

hence why i said the widths where shit...

8s-9s with more dish would be win..but then the price would be higher id say :P

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • ..and forum.r31skylineclub has been down all week....anyone know why?
    • I thought it could be an issue because the standard plate was flexing when stressed. Maybe the original gear set will hold a bit better without flex? Last time on the dyno it made around 670nm at the hubs. Now it have bigger turbo and better intake but have not been on a dyno yet. The car is being used from family trips to drag race events. So the shifts can be a little violent. It is grinding if I shift to fast so was thinking I should overhaul it soon.
    • From the factory on RB26s there's a fitting on the intake manifold collector/"plenum" that provides pre-throttle boost signal. That's how they did it back in the day, I figure it's fine to replicate it.
    • I would be surprised if that wasn't the issue. It's probably telling you, that even if you remove the plastic liner, you may have some other clearance issues that may occur too in some scenarios. IE, tyre to guard. It looks like someone has already rolled the lip, but you may still have issues in the future IE, turning and hitting a bump etc. The fact it changes how bad it makes the noise when you are going backward vs forward is highly indicative that it's the tyre rubbing. They do make a terrible sound, even if you're only pushing a project car that has a liner hanging down on a tyre!   Has the car been lowered? If it has been, what is the measurement from the centre of the wheel hub to the lip of the guard straight up?
    • Summernats cruiser?
×
×
  • Create New...