Jump to content
SAU Community

Recommended Posts

seen a white R34 with carbon fibre bonet behind me ....turning from James Ruse Drive to Hassall Street ...I turned into the BP service station at the intersection ...couldn't get the number plate ...but the guy beeped a horn ... and i waved him back...Nice car dude...

Sounds like ED34, nice car and good bloke

Saw a very clean gunmetal grey R32 GTR with an aftermarket cooler, Kaotic Chrome wheels and custom plates (started with an S, I think) at the lights on Mortley Ave at Dobroyd Pde, Haberfield this morning at 9:30am. Nice car.

spotted GTR-8OY somewhere in sydney where i didnt know where i was on the way to randwick, had a quick chat at the lights, good to see you again bro

Lozz really gets around, hes like the SAU mascot whore :P

i saw this hot chick with a silver 33 gts-t at a maccas carpark on paramatta road, stopped in to say hello :D hehe

there was this other cool :( haha guy there too who said he had a 33 as well with half a dozen or so rwkw lol

i spotted wilchy.... well no i didnt but i was tryin to i drove past some IBM buildings just in case but didnt see any white 33 GTS-ts around them... i was tryin wilchy !!!

next time for sure :)

i saw this hot chick with a silver 33 gts-t at a maccas carpark on paramatta road, stopped in to say hello :D hehe

there was this other cool :( haha guy there too who said he had a 33 as well with half a dozen or so rwkw lol

i spotted wilchy.... well no i didnt but i was tryin to i drove past some IBM buildings just in case but didnt see any white 33 GTS-ts around them... i was tryin wilchy !!!

next time for sure :)

oo!!! that must have been the same guy i saw!!!! he claimed to have a fully sik skylines!!! then drove away in a bora.... :

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...