Jump to content
SAU Community

Recommended Posts

Silver 33GTR with CL ### plates... headed down Mt Ouzley into Wollongong very sedately, stuck behind a slow truck, I gave you some room but you decided to wait...

one very clean ride!

I've also seen a yellow 33 and a black 33 GTR (i think) coming down there too

And a Black 33GTST stopped next to me at the lights in Wollongong near Masters Rd, chick driver, older guy in the passenger seat.

I didnt think to catch the plates.

Edited by B. J.

Spotted a Maroon 33 GTR with huge "Buddy Club" stickers all over it

Also spotted a grey 33 GTST boosting past Chatswood station..series one i think.

Also spotted an S15 with the "Ikeya Sequential" H pattern convertor thing. Man that thing looks chunky....i like it

Spotted a silver and two black R33's (all GTSt's) and a silver R34 GTt sedan heading down the F3, Pennant Hills Rd and the M2 on their way to Friday night drags at EC.

All Central Coast and Newcastle people, apparently...

Spotted Primordial on Monday just leaving just jap!!!

;)

o o o and B-mans Cosmo outside Hitman on Monday night! Looks good! Man those brakes, they are MASSIVE!

Hey! What car were you in? I remember seeing an S15 going the other way when I came out..?

Spotted a silver and two black R33's (all GTSt's) and a silver R34 GTt sedan heading down the F3, Pennant Hills Rd and the M2 on their way to Friday night drags at EC.

All Central Coast and Newcastle people, apparently...

Hey,

I was the R34 GT-T Sedan - I actually live in epping but I work on the coast so hang with them mostly.

Thought it was Goldzilla car but on the two ways the others were thinking of someone else, till that talked to ya.

Drew.

Hey! What car were you in? I remember seeing an S15 going the other way when I came out..?

I was in the car behind the s15..... which was the Proton :( lol

I must have missed you by less than 3 mins!!

Hey,

I was the R34 GT-T Sedan - I actually live in epping but I work on the coast so hang with them mostly.

Thought it was Goldzilla car but on the two ways the others were thinking of someone else, till that talked to ya.

Drew.

Hahaha, hey Drew. I was driving, and my cousin (his username is "blukie") was talking on the UHF CB's. Didn't get to chat for long because the batteries went dead on the CB - I think I've had the same batteries in there since I bought the thing years ago (it must be at least 4 years)...

Who was it that said my car was the "green Camry-looking thing..." over the CB's? :(

Even worse is that someone didn't know what a Stagea was - there are a few up Newcastle way, and they are on the forums too! :ninja:

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • 9" wheels are a little too wide for a RWD 32. They can fit. People have put R33 GTR wheels on 32s for years and years. But they are a very tight squeeze. This has been known for about 30 years. As I said - there is no difference between a 17 and an 18 in terms of what will fit. The rolling diameter needs to stay about the same as stock - not very much larger. If you increase that, you will start to have problems. If you increae rolling diamater at the same time as yo increase width, you will have problems earlier. as 9" wheels are pushing the boundaries already, you would need to be careful with tyre choice. I would put 8.5s on the front of mine, but would expect problems with 9s.
    • post up screen shots of your injector tables
    • Diagnostic flow for a code 21 says check signal at the ECU pins, on a voltmeter of some kind it should read 0.1V at idle, 0.12V cranking, 0.15-0.25V at 2000 rpm. Check each coil such that +1, -3 is infinite or very high resistance, -3, +2 should do the same. (-1, +3), (+3, -2), (+1, -2), and (-1, +2) should all be somewhere between 0 ohms and high resistance. If you trace the path from the coil pin all the way back to the ECU in the diagram the resistance you measure at the coil vs connected to the harness should be pretty much the same. 
    • I have an elite 2500 running an adapter harness on an rb25de neo r34. I took the butterfly out and removed all that junk. But I also went Plus+t at the same time. The butterfly thing works in reverse to the boost solenoid on the Gtt if that makes sense
    • yeh they are 235/45/17 up front and 255/40/17 in the rears. I still didn't get my answer if i can fit a 18x9 up front. I want to get 4 of this and see if they will fit before committing as they didn't see an 18x8 as an option but there is a 18x9.5 also.   Enkei RS05-RR 18x9 35mm ET 5x114.3 75.0 Bore Matte Gunmetal Wheel
×
×
  • Create New...