Jump to content
SAU Community

Recommended Posts

Spotted a silver R33 this morning at about 9am on the Princes Highway in Tempe. Number plates were Ax-xx-xx I think?

Also spotted a silver R34 last week on King St in Mascot doing a reverse park into a spot across the road from the school there.

Yep. White n14 with a pushed in rear end hahah.

Today spotted a white R33 GTR near Chatswood.

Also spotted a blue R32 GTST or GTR parked at BP near the airport, big chrome impuls.. looked really clean from a distance.

That was me :-) Finally spotted!

Doof were you strolling around chatswood westfield carpark after work yesterday? Spotted a nice tidy white r33 rock up about 5:45 and then some well dressed bloke strolled past my r34 as i tried to run him down (not seriously) But hey could of been another bloke in the r33 heaps around these days

And Moei I was in KFC getting mad discounts for mums day, used to manage that kfc h

spotted Sn-33-ze

aka Andrew and stuck my finger up to get you back from last time ... but you didnt even see me :spank:

and there was a black 32 infront of you

spotted a black r33 on enterprise drive , tumbi umbi tonight at about 7pm.. got and gave a wave.member?

Hey i know its a bit late t i only just found this thread :spank:

Possible me as im always on enterprise drive around that time coming home from work..

i have a 400r front bar.

Spotted a white R33 this morning. It was parked behind the flats on the corner of Wentworth Ave and Botany Rd, Mascot. Rego was XPG-260, from memory.

Also spotted a black 32 leaving the Eastern Distributor last night about 6:15pm. You were in front in the traffic a bit, so didn't get a good look.

lol i swear i've seen you a while ago driving through chatswood...got a picture somewhere too :) Niice car mate.
Yeah I'm pretty sure I've seen you around chatswood too a few times... once while I was enjoying company at Big Fish Little Fish

thx mates, coz I live in chatswood :thumbsup:

make sure give me a wave or horn next time :)

Edited by spikey
Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...