Jump to content
SAU Community

Recommended Posts

  • Replies 95
  • Created
  • Last Reply

Top Posters In This Topic

i am close to pulling out.....only if the new clutch goes on in time then i would consider chucking it on the rollers as the current clutch is slipping 3rd 4th and 5th under load

i am close to pulling out.....only if the new clutch goes on in time then i would consider chucking it on the rollers as the current clutch is slipping 3rd 4th and 5th under load

just put the bloody thing in already! its not that big a job.

There will now be a cruise after the event also!

We've got a heap of spots still up for grabs (no min power required at the moment, and all entries will be accepted unless it's full)

Rough estimates for total power;

Domestics - 3100wkw

Imports - 2650wkw

And 5 entries listing more than 350wkw... should be good fun!

Vince, if you're in desperate need mate call me, I can get you a spot in a mates workshop for a bit so you can drop it :banana:

cheers, i have no worries getting it out as have just got the hoist in the new workshop installed. Just not really to keen to drive around in rwd. ah-well.

so when do we know if we make the cut????

Edited by momentum_gtr
  • 2 weeks later...

Not long to go now.

We are still seeking entrants, and have not closed the entries.

http://www.toyotacarclub.net/events/domvsimp/

Expected Average power so far;

Imports - 250 > 300

Domestics - 280 > 330

Event starts at 10:00 AM through till we run out of cars.

Not long to go now.

We are still seeking entrants, and have not closed the entries.

http://www.toyotacarclub.net/events/domvsimp/

Expected Average power so far;

Imports - 250 > 300

Domestics - 280 > 330

Event starts at 10:00 AM through till we run out of cars.

hasent been postponed or moved location??

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Thank you, 100% the intent. New coils were due and the 17" sixers look/feel loads better than the stock wheels. The aero options are so spot on.   Thanks for the warm welcome, all!
    • 98 r34 gtt Been rocking my latest setup and car running like never before. Have put a good 200 miles on it since all the latest changes and additions. everything is dialed in and have been driving it a bunch.   However, all a sudden last weekend as soon as I pushed throttle passed 4k and the engine stumbles, (slow or fast acceleration) hesitates and doesn’t go above 4100 or so, like a misfire. Everything else seems fine. I had a “good” set of coil packs that I removed from car when I first got it when I changed them over to new coils. I swapped out current ones for those, but no change. I also changed the plugs, no change. Seems to rev over 4 when out of gear with no load just fine no “misfire”, but as soon as its in gear with a load of any kind, it “misfires” as soon as rpm drop back below 4 k it runs perfectly, smooth, starts, restarts and drives fine as long as I keep it below 4 k while in gear. All readings look fine, no CEL   Any idea as to what could all a sudden cause an issue when pushing rpms passed 4 k?
    • When you say your cams are 272/262 is that 272in and 262ex?
    • We're arguing semantics. I am saying 45 accel and a 55 deccel ramp are "2 ways". Even a 45 degree ramp and an 89 degree ramp is "2 ways", because it is literally... two ways. The cusco 55/30 ramp is a 2 way. It's two ways. I get it though - in normal nomenclature a "2 way" would be 45/45 or 55/55 or 60/60 i.e the same locking in both directions. And something like 45/65 would be considered "1.5 way". I would then say if we're getting into the nitty gritty then every locking diff is a "2 way" diff and we should not speak in 1.5, or 2 ways but ramp angles instead. Which ofc if one of those ramp angles is 90deg, that side is not doing any locking. :p So Nismo don't obviously sell 3 things. The fact of the matter that they only sell two items really goes to show that there's a 2 way and a "1,5 way" which is really a 1 way. I believe the actual lockup for the 'adjustability' of the GT pro is really just setting preload for when the ramps actually start locking up. It's not changing how much 'wayness' there is. It is (somehow) horribly explained. People just buy whatever diff and go "locks up good bruh" and that's what ends up on socials forever.  
×
×
  • Create New...