Jump to content
SAU Community

Recommended Posts

Had a blue R32 sedan with a cannon zorst behind me on the parkway this morning, but wasn't paying attention and didn't realise it was a 'line until it passed me in the right lane and I saw the taillights ^^;

May of been the same 32 id seen...

Blue with gold/Bronze wheels... i was heading the other way..

Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/344/#findComment-2594283
Share on other sites

Spotted a black R33 in Queanbeyan parked behind the car wash and also while putting petrol in my car I spotted a nice Marone R33 with a black 400R front bar driving and the driver waved and I waved back :dry:

Black 33 is mine :P Didn't see you, probably would have been at work. Spotted a black R33 S2 on the way to queanbo, Vic rego i think, driver didnt wave though. Also spotted a black 33 S2 on the way home, FMIC, that you Leigh? only caught a glimpse, driver waved i think i got a half assed last second wave in though. Looked tough!!

Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/344/#findComment-2595466
Share on other sites

Spotto'd a black S2 R33 on Parkes Way this morning into Civic, thought it was Leigh but upon closer inspection via the rear view mirror Leigh's car doesn't have mesh through the front bar & white mags :dry:

Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/344/#findComment-2595756
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • I'm with you here. It's either loom has an issue, OR, injectors are not functioning properly. It could even be they're just constantly dribbling, hence the wet, but not firing.
    • Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
    • Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
×
×
  • Create New...