Jump to content
SAU Community

Recommended Posts

Spotted a grey? 32 on limestone ave about half an hour ago...if its someone on here your far right tail light is out!

that was me. is my suspention it so stiff it keeps knocking the bulb slightly out the socket. so i have to keep poping it back in all the time, drives me nuts

Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/358/#findComment-2722486
Share on other sites

spotted a few today all at lunchtime

gunmetal 32 near oxley

purple 34 in erindale near servo (got a small wave :P)

yellow 32 in servo

grey S1 33 in woden

gunmetal S1 33 on athlon dr

black S1 33 on athlon dr (about 2 mins after the first)

dark S1 33 on the bridge at tuggers

all within 2 hours :X

Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/358/#findComment-2722653
Share on other sites

So.....

Who on here has a dark blue R32 GTS-t that may or may not have been involved in a little comparison of acceleration with a red HSV GTO this afternoon coming off the parkway onto Hindmarsh Drive?

Cos if it's anyone on here - nice work :laugh:

I didn't expect to see a 32 GTS-t pulling away from a big V8 (297kw model? it had the twin exhausts)

Edited by Bluprint
Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/358/#findComment-2725391
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Thanks MBS206, i got that PDF but got abit overhelm with all the connections and tracing of wires. I wasn't expecting to plug the dash harness anywhere. i was just going to use my electronics jumper wires to plug into the right pins like ECU power, ecu ground, ignition trigger etc... I do have a few ratchet straps locking it down tight. Fire extinguisher ready and only a small amount of fuel at a time, enough to submerge the pump.
    • Thanks GTSBoy, i will do abit more digging. I am missing a blue relay near the ECU connector... so i will chase that up in the next few days as well  
    • https://yariksteel.ru/manual/R33/Skyline_R33_elektroprovodka.pdf   Page 18 should be what you want for the Dash Cluster wiring. Though, you don't need the dash plugged in to get the motor running. What you want is power as how GTSBoy said. You need to power the ECU. Find in the above link the ECU pin outs (Verify them before just connecting them up from things written on the internet). Find anything needing power, give it power, find anything needing ground, give it ground. Then give the starter motor power through a big cable, and bridge the solenoid on the starter straight to power too.  ECU will be on, and when you give the starter power, it'll spin the starter motor, and it should start. I also hope you have a proper stand, and not just the engine sitting on some wood. You will want it bolted down properly.
    • Hello everyone, I am happy to join you.
    • Whereabouts are you, that looks exactly like Akira's old car....
×
×
  • Create New...