Jump to content
SAU Community

Recommended Posts

Well it is still there... Very jealous mate. It really is a beautiful 32.

Edit: Went to get a pie because im fat and Sin goes past.. gave a wave!

Edited by Anfanee
Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/775/#findComment-6625737
Share on other sites

well i managed to spill some of the pie on my shirt -.- now i look like an idiot.

Remember Richard.... The offer is still there for us to swap 32's... I think its a fair trade!

p.s your car does sound lovely as well.

Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/775/#findComment-6625873
Share on other sites

same happend on my first rebuild, smoke throughout the workshop before I'd even been asked to pick it up.

my request to have N1 Turbo's serviced and lines replaced obviously fell on deaf ears :verymad:

left on workshop floors for over 12months and then put straight back on - FTW

Engine builder thought garage would do and workshop thought engine builder would do.

Result = 2 farked newish N1 turbo's

Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/775/#findComment-6626015
Share on other sites

Spotted a white r32 four door in queanbeyan looked nice waved but got a strange look lol probes cause I was in the soarer

Wasn't mine was it? With your black wing mirrors? Would have been my mate driving with me following in the crappy blue lancer, we had just got back from the nats.

Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/775/#findComment-6629363
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...