Jump to content
SAU Community

Recommended Posts

Ok i have a power fc, i used paulr33 excellent faq and i know how i need to correct for the larger injectors i have (1000cc) but do i need a retune one i install them or no ? i am changing NOTHING AT ALL but the injectors, no more boostr nothing, i do have a larger turbo i will be installing, but right now i just need car moving any advice ? and of course once i install the larger turbo i will be getting it tuned !

Link to comment
https://www.sau.com.au/forums/topic/305905-pfc-larger-injectors-install/
Share on other sites

Hook up a wideband O2 and just keep an eye on the A/F, I find with larger injectors from factory it just richens heaps on full load.

but if you're driving the car under 4000rpm you should be fine provided it's not stupidly lean

just imagine the injectors are physically bigger. they work off the same voltage as your old ones so all that changes is pulse timing and width. so if you have gone from say 500s to 1000s, at the exact same tune state they will literally run twice as rich.

the most common mistake i see with injectors is people thinking that they could just put a bigger set and not need to do anything else, that and adding an FPR can fix anything.

its all a learning experience, your doing well mate :P just spend some time retuning em and it will all add to your experience.

Since you will have setup the PFC to cope with the new injectors, the tune should be fine for driving between workshops (no boosting). If cold start/cold running is not ok then something is amiss (for example you didnt enter the correct latency when updating the PFC)

You may even find its ok without a retune, but you need to verify that on the dyno first.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • You're not the first person that's said that about this car lol. A Touring wagon GT in Spark yellow mica would be the dog's danglies 馃槅 I will keep an eye out for a future purchase for sure. The seats are almost like the OEM Recaros... electric adjustment for fore/aft and tilt movements except reclining.   
    • Yes!! I love these! It's a shame its not the wagon though!   Thank everything that's holy that it doesn't have the interior of the Aussie delivered ones. Those seats are so much nicer.  
    • I'm both sorry and thankful that you do that. 
    • 2001 BE5D Subaru Legacy B4 RSK (3rd gen) EJ208 (pink injector) Twin Turbo 280PS 5-speed manual Full time 4WD "RSK" grade which means all of the above LQC option which means stock rear spoiler  I got it primarily to export to someone outside Japan who was interested. These BE5 Legacy B4 RSKs are going through a bit of a resurgence right know in Japan as they are one of the few cars from the "turbo, manual, RWD/4WD, 280hp gentleman's agreement era" cars that don't require stupid money to purchase. Which for some people might be a good opportunity to get as a base for restoration. If I can't find anyone to purchase it I will certainly be doing that myself over the long term. Why? Because it's properly fast in stock form, handles well enough for a GT sedan, there's still enough aftermarket and (if you can wait a while) genuine part support to make it a restoration candidate (<-- that will only get worse over time so it's a case of do it now or choose get a BL5 4th Gen). Mechanically it's fine, has only 89,200kms on the odometer. The problem with this car is that the body and exterior trims are weathered from at least the last 10 years being parked outdoors. I'm the 3rd owner, the first owner was the one that had it for 14 years and barely drove it, had a low-speed front impact (which didn't damage anything behind the radiator support) and got it fixed and sold it. The 2nd owner put most of the kms on it and parked it outside for the last 10 years, hence the door rubbers have seen better days but if you overlook those cosmetic details, it presents pretty nicely. There is some minor rust on the LH rear wheel arch which I'll have looked at too at some stage.  Also as you'd expect from a car this age, the clear top coat is gone, leaving a satin finish on the roof.  Mechanically it's fine (as you would expect from a car with less than 100K kms) but the steering does feel slightly vague around the centre position at higher speeds. So first on the list is to get the steering rack bushes looked at. There's also the Lock button on the remote which doesn't work, but the Open button does.... it means that the anti-theft system thinks it's always open? It seems like if you open the car and don't start the engine within 3 mins or so the anti-theft kicks in again without any beeps or signals. So if you got to start it after that, it won't. You have to push the open button again. That's how I understand it anyway. Just a small irritation but not a big problem to sort out. There's only one mod, the Wangan SPL muffler. Just a tad louder than stock. It's a really good mod for those who don't want to wake the neighbours but still want to hear a more prominent unequal length header EJ20 sound. Anyway I hope to get all those things done eventually, that is unless someone wanted to import it to their country from Japan (where I live). I'm open for negotiations as I really would like a Skyline... but this will definitely suffice in the meantime 馃檪 *Disclaimer: This is how I picked it up from the dealer, minus the stuff on the back seat. I haven't cleaned the engine bay or done a thorough exterior clean, aside from spray painting the wipers. 
    • Wow, even with the Audi logo centre caps. I love OEM wheel mismatches. 
  • Create New...