Jump to content
SAU Community

Cnc Motorcross Helmet

VB-

By VB-,
in General Automotive Discussion

 Share

Recommended Posts

VB- Veteran

VB-

Posted
Posted

couldnt decide where to put this, but pretty sure i've seen similar stuff in here.

before i get hung/drawn/quattered, i put this here instead of the vid thread coz its not just something to pass the time, but its a sweet bit of engineering/tech.

link

waitstobehungdrawnandquattered

cheers,

Ben

Link to comment
https://www.sau.com.au/forums/topic/307152-cnc-motorcross-helmet/
Share on other sites
Basti Grand Master

Basti

Posted
Posted
the that helmet is probly harder than most surfaces you would hit anyway.

cost i imagine would be prety scary

and therefore pretty shit at cushioning your head in an impact. your skull will be mushed, but atleast you wont have to get a new helmet everytime :)

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Latest Posts

    • MBS206
      Duncan's V37.......race car?

      By MBS206 · Posted

      Did you take the MX5 for a Blat around the Track at all?
    • The Bogan
      Duncan's V37.......race car?

      By The Bogan · Posted

      LOL, "they said it might be slippery"..... 30 seconds in your off, 60 seconds in white twin backs into the corner That new track looks good, and the Datsun was chopping cars quite nicely     
    • CF.Panda
      R34 25GT Engine Light 21

      By CF.Panda · Posted

      I'll get one of these also just for giggles
    • CF.Panda
      R34 25GT Engine Light 21

      By CF.Panda · Posted

      I bought 6 new spark plugs to compare readings. They will be here tomorrow and ill see if meter is far off if it all. I know one is at least reading 0 so its best replace all anyway if one is bad, from experience. I still have to test the harness just to be sure its not a double issue and I waste my time haha-the old plugs are iridium I always thought those lasted more than 50,000 km.
    • feartherb26
      RB25DE NEO with Haltech ECU

      By feartherb26 · Posted

      If you take the top half of the intake off you can unbolt the flap off the shaft and leave the shaft in there blocking the hole. Then you can remove the little vacuum canister off from under the manifold and get a spare vacuum line to run to the ECU. I can take some photos of it later. Probably best to get the vacuum source to the ECU sorted first though. Mine all worked mint with the base map from the GTT an I've pretty much let the closed loop sort the fueling and took 1 degree out of the whole timing map.
×
×
  • Create New...