Jump to content
SAU Community

Recommended Posts

  • Replies 45
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

yeh I wouldn't think it would make that much more even if boost remained constant through out the rev range...

I'm seriously considering E85... going to have to look into bigger injectors and fuel setup... but might just wait till I see some more digits in the savings account :laugh:

thanks

nope.. motor is unopened besides the Injectors

Mods are the generic mods..

PFC

Profec B

550cc injectors

Full 3" Exhaust...

custom dump

custom intake

apexi pod

BOV

z32 AFM

walbro pump

etc

Nice power....

But I thought z32 AFM cant read anything after 260rwkw? And how much psi were u running to get that sort of power?

Nice power....

But I thought z32 AFM cant read anything after 260rwkw? And how much psi were u running to get that sort of power?

as per the dyno sheet attached on the first page of this thread, roughly 18-19psi fading down to about 17psi near redline.

.... GCG rekon this new rear housing is 'original' Garrett and much more efficient...

I would say this is the key ingredient for the better output you have now and is typical power for both the original Garrett Gt3071 with the .82 rear end and the Hks Gt2835..... with the extra 10kw or so just being difference in dynos

I thought and so have read, that the stock head gasket needed replacing when boosting over 1 bar or so?

and where have you read that? I smash 1.3bar into my motor day in and out, and it's unopened.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • I refer you to this thread on PF, by someone who knows what he's doing. Paints a good picture of the humble AD09.
    • Ha, I've never pressed the X in all these years incase it removed the notification for all Admins
    • I don't know, I've never done it that way, but 1. While it is an interference engine, there is still clearance between the valves and the piston at all points in the regular timing cycle 2. There is not a lot of distance before you can't catch the top of the valve stem any more I don't know if 2 is greater or less than 1. But 3. If it doesn't work out you are f**ked, engine is coming out to disassemble so it is a big bet.
    • Semi slicks are horrible for road use, just use a high performance road tyre unless you really need the maximum grip. Noisy, unpredictable (amazing, until they are not), expensive due to very high wear and not good in cold and particular wet. And yes, it is a thing to store cars on stands instead of tyres if you know they are going to be parked up long term.....but who ever realises that a short park is going to stretch into years before it is out again!
    • I know in Australia you'll definitely get above 30c. Parked in the shade in Summer you'll be above that. 😛 But in cooler climates, you might get that warm driving on the highway for a bit, but you'd never get to full heat temp. I'll try and find some of my historical tyre temps between Aus summer and winter (be aware immin the warmer area of Aus too.)
×
×
  • Create New...