Jump to content
SAU Community

Recommended Posts

yeah... and i think there is a XXX store around there or its where the XXX store used to be.

just go in there and ask for johnny.... if you tell him hamish sent ya then you'll get looked after :banana:

dunno bout you, but the 7m we had did 400,000km's without blowing a gasket. only reason it came out was cos my cuz went for a 1JZ swap. did blow an alternator, starter motor, and water pump tho. Just service it regularly and don't sit on the limiter all the time n she'll be fine.

The car was a hand me down from my old man, and then from me to my cousin. Who then wrote it off. Idiot.

You had a good one then. It's one thing they've been notorious for doing.

zomg... just like my cousins habibi's rears on da VN

i saw one of those horrible hyundai coupes, the rounded ones. it has interceptors with a polished lip and black centers

oh and that red thing is pretty sweet :)

should be in HPI soon... so i'm happy to let someone else pay :)

thats awesome!

well done on building a great car

i bet their intros gona be like

during the day, hamish hampton fries (insert foodstuff here) but during the night, he fries nothing but rubber bla bla etc etc

and is there a difference between HPI and PI? or is there just a name change?

Edited by GTR-boy
Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Possibly avoid using a Cometic one unless the deck/head surface are perfectly flat. I did have a look just then and forgiving gaskets such as Tomei or Nitto don't exist for the FJ20, however the Bar-Tek or Kameari ones look good and might do the trick.
    • Because pipe threads for pipe things. M threads for bolt things. Throw some teflon sealant onto it and dust your hands off knowing you did the right thing, instead of going twice around the block to achieve a result using the wrong things. Of course, all of these solutions are ignoring the fact that the minimum thread pitch we're talking about here is 1.25mm, with the 1/4" in NPT or BPS being out around 1.4mm. You will need to know that the boss you're tapping has enough thickness for at least a few threads. That's one of the reasons that 1/8" is commonly used - because the pitch is <1mm. And why would you look to use 1/4" NPT in a BSP country anyway? Ugh.
    • Just throwing around ideas, does it need to be in the compressor cover? Why not the hot side piping?
    • 1/8NPT drill size = 8.7mm. Since the hole got messed up by me, it’s probably around 9mm.    So 1/4” NPT would be next step. A drill size of around 11mm would be preferred there which is not way of my M12 (drill 10.5mm and tap M12 threads) 
    • 3 Kids are starting to hit that ages. I wanted to get them something special to learn on, put down the screens and have some fun. 4Door 2001 R34DE Black Pearl GV1 Jap Import, AU 2nd owner. Pre Work done. Suspension - Wheels Pedders SportsRyder Coilovers   Wheels TSG Spokey Boi 18'x9.5"+15 Body JASI Aero 4 door Type R Full Kit LED Conversion - Parker, Blinkers, & Reverse Exhaust Hurricane Headers 100 CPI high flow cat 2.5" Piping Cannon muffler Internal Bride low max stradia ii - front seats  Bride RO seat base and Rails (R/H) Cube short shifter LED Conversion - Interior   
×
×
  • Create New...