Calder Drags

[UNR33L]

stiff suspension just drifts down the track.. need the weight pushing the tyres down on the rear, or just buy a GTR 7000rpm launch gone

[Sandeep]

i read a post on the zed forums about suspension setup for drags (by a guy who ran 10.95 with stock turbos and engine) who said to run stock shocks/springs on the front and put higher damping on the rear since when the rear squats it induces negative camber and toe (it has something to do with the IRS and antisquat geometry, i am not too sure exactly) which reduces your tyre contact area. i had always though soft rear was best for drags but pretty much every other zed guy i have spoken to has said the same thing as this guy and said they ran better times that way. i figured r32 and z32 may have similar rear suspension setup.

anyway back on topic, yes you should go to calder ric. i would like to race again but the clutch did not like 4500rpm launches and it was still bogging down so need to upgrade clutch before I go again.

[Russman]

Just chuck a turbo back exhaust on it i recon, the rims are ok, maybe a pod / larger fmic if needed? and up the boost a bit for the drags.. would be nice

Do you have semi slicks / slicks for your r32? i assume so by looking at your sig

Yeah I run semi's on the 32 for circuit work.

It's quite suprising but standard exhaust is good for 320rwkw's apparently. Cat would probably have to change I imagine.

Sandeep. Drags is all about weight transfer but if that weight transfer causes negative camber then that's a problem. Standard susp is pretty good for 1/4 mile stuff.

(by a guy who ran 10.95 with stock turbos and engine)

I Highly doubt that!

[limpus]

i read a post on the zed forums about suspension setup for drags (by a guy who ran 10.95 with stock turbos and engine) who said to run stock shocks/springs on the front and put higher damping on the rear since when the rear squats it induces negative camber and toe (it has something to do with the IRS and antisquat geometry, i am not too sure exactly) which reduces your tyre contact area. i had always though soft rear was best for drags but pretty much every other zed guy i have spoken to has said the same thing as this guy and said they ran better times that way. i figured r32 and z32 may have similar rear suspension setup.

Exactly why you don't listen to everything you read on the forums...get your rear geometry right to account for some of the negative camber on the squat and have soft rears to get the weight transfer towards the back...a zed is a car like any other...the laws of physics still apply to it...

[femno]

Baha some of the stuff on the zed forums is bloody funny to read

Yes softer is better as prevously mentioned, and if you have adjustable UCAs, running positive camber is the way to go to account for dynamic camber on squat.

I cant wait to put some softer springs in and slide some slicks on, try and hit the 10 bracket

[nismo_GTST]

13.3 eh? Might take my XR to the next meet

[Russman]

13.3 eh? Might take my XR to the next meet

Yeah man. Is yours auto or man?

[nismo_GTST]

Yeah man. Is yours auto or man?

I ended up with the auto. I wanted a manual but after taking an auto for a test drive just for comparisons sake, I was hooked. They are so damn good!

Did you try using the launch control at all?

[Russman]

I ended up with the auto. I wanted a manual but after taking an auto for a test drive just for comparisons sake, I was hooked. They are so damn good!

Did you try using the launch control at all?

Yeah launch control every time. holds 3600 rpm.

Even though it's known as a launch control it's more of a static rev limit coz when you go over 10kph it disengages and you wheel spin starts. At calder I didn't have much of an issue with wheel spin coz it's pretty grippy.

[nismo_GTST]

Yeah launch control every time. holds 3600 rpm.

Even though it's known as a launch control it's more of a static rev limit coz when you go over 10kph it disengages and you wheel spin starts. At calder I didn't have much of an issue with wheel spin coz it's pretty grippy.

Ah yeah, I wasn't too sure on how it worked. Auto ones don't have LC. They just get a nice crackle throught the exhaust when you change gears. It's rather addictive actually

Definatly keen on taking it down to the next meet. A stock auto one running high 12's is very encouraging.

[(OO)SKYLINE(OO)]

i read a post on the zed forums about suspension setup for drags (by a guy who ran 10.95 with stock turbos and engine) who said to run stock shocks/springs on the front and put higher damping on the rear since when the rear squats it induces negative camber and toe (it has something to do with the IRS and antisquat geometry, i am not too sure exactly) which reduces your tyre contact area. i had always though soft rear was best for drags but pretty much every other zed guy i have spoken to has said the same thing as this guy and said they ran better times that way. i figured r32 and z32 may have similar rear suspension setup.

anyway back on topic, yes you should go to calder ric. i would like to race again but the clutch did not like 4500rpm launches and it was still bogging down so need to upgrade clutch before I go again.

What the Fuck?!

I assume they are talking about a Z32..?

A stock Z32 can run a 10.95 with modified rear suspension?

I would like to see the quarter mile time sheet.

[Sandeep]

stock unopened engine and turbos but more boost, tuned + bolt on mods. did some more reading and turns out he was running 80 shot of Nos too which i didn't know before. still an impressive time though, best stock turbo/stock engine zed i can find in australia is high 11's without nos. and yeah have been doing more reading and all the guys who drag zeds say to run stiffer on the rear. i think it is more due to the design of the irs on the zed which is not suited to drag racing, not just camber on squat like femno said but also toe changes. and yeah as limpus said you can change the mounting points for the control arms to fix this, which is what UAS have been doing, but pretty expensive so I guess this is why everyone just ups the damping on the rear.

What the Fuck?!

I assume they are talking about a Z32..?

A stock Z32 can run a 10.95 with modified rear suspension?

I would like to see the quarter mile time sheet.

[(OO)SKYLINE(OO)]

stock unopened engine and turbos but more boost, tuned + bolt on mods. did some more reading and turns out he was running 80 shot of Nos too which i didn't know before. still an impressive time though, best stock turbo/stock engine zed i can find in australia is high 11's without nos. and yeah have been doing more reading and all the guys who drag zeds say to run stiffer on the rear. i think it is more due to the design of the irs on the zed which is not suited to drag racing, not just camber on squat like femno said but also toe changes. and yeah as limpus said you can change the mounting points for the control arms to fix this, which is what UAS have been doing, but pretty expensive so I guess this is why everyone just ups the damping on the rear.

I see...

The VG30DETT had more potential then I thought.

Well at least you cleared that up

LOL! @ NOS.

You don't need that Sandeep.

[silva33]

Yeah launch control every time. holds 3600 rpm.

Even though it's known as a launch control it's more of a static rev limit coz when you go over 10kph it disengages and you wheel spin starts. At calder I didn't have much of an issue with wheel spin coz it's pretty grippy.

Hey buddy,

Good to see you have tried the XR6 at Calder, I have a manual FG XR6 Turbo ute as well, the launch control is sooo good but I am having the same problem as you. It launches really well but as soon as it gets going it starts to spin the wheels in the mid rpm range.

Even second gear is a little tail happy unless you ease it into gear.

[UNR33L]

i'm sure some better or wider tyres or more weight at the back will help fix that up a little bit

[Russman]

Hey buddy,

Good to see you have tried the XR6 at Calder, I have a manual FG XR6 Turbo ute as well, the launch control is sooo good but I am having the same problem as you. It launches really well but as soon as it gets going it starts to spin the wheels in the mid rpm range.

Even second gear is a little tail happy unless you ease it into gear.

Haha. So many FG's! post up a pic

this is mine.

[nismo_GTST]

Nice one mate! The only pic I have is this crappy one I took on my phone the day I picked it up from the dealer.

[silva33]

I love the colour!

[Russman]

I love the colour!

They are all good colours! The lux pack 19's are nice too but I couldn't justify the extra considering I would probably change em anyway.

Where did you get yours? Strapp ford? Our number plates are only 6 numbers apart!

[silva33]

hahaha yeah Strapp Ford buddy... I got the tech pack and luxury pack as for the extra money it came with heaps of extras!

For the money and a stock car they are pretty bloody quick on the move thats for sure.