Jump to content
SAU Community

Recommended Posts

Hey guys i started to notice recently when i drive flat out and at high revs the car stuttered/hesitated a little i thought it was the sparks so i change the shitty ones that were in there to nice new NGK iridiums :/ it didnt fix it per say but the problems changed now it feels like im hitting the rev limiter at 4-4.5K for a moment then goes fine again, but i havent been able to get on the freeway to really give it a go yet. Im thinking it might be the packs but i wanted to get some input before i blow a wad on splitfires, also could it be the fuel pump? Maybe ill change the fuel filter and see how that goes first

Link to comment
https://www.sau.com.au/forums/topic/318677-stutteringhesitant-at-high-revs/
Share on other sites

coilpacks.

easy way to check is take out all coilpacks and give them a good clean. look carefully for hairline crack. usually looks like white powdery cracks. if you see then that means your coilpacks are gone. if you can do a DIY repair on them with some clean silicone sealant.

i did that to my R34 and it handled 240rwkw daily for over a year and still going strong.

coilpacks.

easy way to check is take out all coilpacks and give them a good clean. look carefully for hairline crack. usually looks like white powdery cracks. if you see then that means your coilpacks are gone. if you can do a DIY repair on them with some clean silicone sealant.

i did that to my R34 and it handled 240rwkw daily for over a year and still going strong.

Hmmm that might make sense, I noticed on the 4th sparky that it was the only one covered in a small amount of white powder, I was wondering what it was but I was in a bit of a rush to get them back in so I didn't take much notice. Do you think that's the problem?....splitfires time?

well it could be that or anything really. thats just the first and easiest thing to check. and if faulty cheapest to fix. try the DIY method out first or borrow somones coil packs. then if that fixes the problem you can make you mind if you should get splitfires or not.

well it could be that or anything really. thats just the first and easiest thing to check. and if faulty cheapest to fix. try the DIY method out first or borrow somones coil packs. then if that fixes the problem you can make you mind if you should get splitfires or not.

Just did the whole tape DYI fix, not sure, it seems like it reduced the symptom but I'm also thinking it could be placebo effect. I didn't see any cracks or anything on my packs though....

take it off and clean it. Get the MAF sensor cleaner from Bursons etc. it works a treat!

When you say you did the Tape DIY fix, wht did you tape? If it was the coils themselves then maybe do the whole loom as well, I did the loom on mine and it fixed all stuttering issues I had, after cleaning the MAF's and doing the solder joints on them too. Oh and make sure your spark plugs are gapped down to .8mm

take it off and clean it. Get the MAF sensor cleaner from Bursons etc. it works a treat!

When you say you did the Tape DIY fix, wht did you tape? If it was the coils themselves then maybe do the whole loom as well, I did the loom on mine and it fixed all stuttering issues I had, after cleaning the MAF's and doing the solder joints on them too. Oh and make sure your spark plugs are gapped down to .8mm

mmm might have to have a look into that, I only taped up the actual packs and not the rubber part if thats what you mean. I was thinking about the gap. I thought it was 1.1 for stock boost?

nooo not the packs themselves, you don't need to tape them up. Pull the loom off (the wires with all the plugs) and check it for any splits, (mine had several and could see bare wire on a couple) then tape the whole thing up with some decent electrical tape (nitto FTW) then you should be right, if that's your problem

nooo not the packs themselves, you don't need to tape them up. Pull the loom off (the wires with all the plugs) and check it for any splits, (mine had several and could see bare wire on a couple) then tape the whole thing up with some decent electrical tape (nitto FTW) then you should be right, if that's your problem

I just followed this guide

yes, but dit you have any cracks in the epoxy or not? If no then you wasted your time. Try doing the loom as well, you'll probably find it has a split somewhere, otherwise I rekon it's dry solder joints in the MAF Sensor. Fix it by resoldering the joints Tutorial Here

As far as I know James is still running the standard boost solenoid so boost cut is out. I still place my bet on coilpacks.

Kirs is right standard boost :(, gonna order new splitfires I think

Have you checked your Loom and done the MAF joint with fresh solder yet? That's a LOT cheaper than new Splitfires. If it's not your coils then when you get your new ones you will have the same problem.

The above 2 fixes will take bugger all time to do and will cost you all of $5 for tape and solder a little more if you need to buy a soldering iron too but still a lot less than the Splitfires will sting you :)

I had this problem after a quick squirt on the track.

Checked everything, sparks, coils, intercooler piping etc.

Turned out to be the Vac hose on the Fuel Pressure Regulator, felt kinda stupid once I noticed the little hose dangling.

Chances are yours isn't this, but yeah.

Good luck.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • For these last 7 years of ownership, I've always had to use a small scissor jack under one of the front tow hooks to raise the front just enough so my low-profile jack fits under to reach my subframe jack point. I'm beginning to get annoyed of always having to do this. Are there any lower low-profile jacks that fit under the gtr lip on a dropped car?
    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
×
×
  • Create New...