Jump to content
SAU Community

Recommended Posts

Stock Injectors and AFM run out of safety margin / resolution at what.... like 210-220rwkw?

I wanna see this graph :P

will be lean as f**k and injectors being soooo stretched i'd be surprised if 270rwkw is genuine, could get close to it though.

AFM can be tuned around when beyond resolution with some creativeness, however your idle and low revs get pretty messy

creatd had a GTT that was making 370rwkw on c16 with a standard AFM

no problems Hamish I bought the car 18 months ago pretty well built up to were it is now

and was shown a dyno sheet before bought car and thought it was stretched to the limit

have some adjustments to boost dropping it to 12 psi & I am taking all tips on board

if you guys have any more tips that will help out

I would be happy take any help I can get.

have thought seriously about joining a club for idea's and general help from other people

no probs man... basically you have a 300rwkw turbo but no supporting mods, which means that the car wont be getting enough fuel. this will result in cylinder temps getting too high, and parts failing under load.

for a 300rwkw RB25 you should run a minimum of:

full standalone ECU (PFC, nistune, link, vipec, etc etc)

Z32 AFM

500cc injectors (however if you want to use e85 in the future think about getting 1000's

fuel pump (single intank you mentioned will be fine)

a good tuner

+ the other shit you already have...

i'd also look at getting a 1.5 way diff if I were you :)

have a look through this thread for a good idea of what people have done to manage unopened 300kw setups

http://www.skylinesaustralia.com/forums/topic/389417-300kw-unopened-25-club/

  • 2 weeks later...
  • 3 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Hey guys Long time lurker, I daily a nm35 stagea 250t rs four and I've had it for almost 2 years (very reliable 👌). Issues or just looking for information ill always find myself here having a read, so thought id join.  3inch stainless intake, pod filter, AM performance turbo dump pipe, 3inch hotdog, 3 and half inch stainless to 3 and half inch AM performance blast pipes. Bc racing coilovers. 18inch rims Hdi intercooler and trans cooler soon.  Here's my car
    • thanks for the advice on the box... i was thinking the 6 speed was better for cruising on the highway but on closer inspection and comparison the Rb 5 speed box was not too different...  So the choice is going to be the RB25 box... if I can save up and find one at the right price  
    • Thanks Matt, yes that's what i am aiming for. Just going to apply the right voltage and grounds to the dash connector. Hence my search for these pins... any chance you know if these pins are in the same spot as the ones on the S15 Dash connector? as mentioned above on page 8?
    • Yes, unfortunately that's the one. Signal was noisy to begin with; after driving once and looking back at the logs I saw pressure constantly swinging between 0-200psi, or staying at 0 randomly for a few seconds. There's a lot of good sensors that share the same look and feel, so don't presume they're all bad. I bought mine for 20$ off Amazon and I should have read the reviews prior, as it's clear they're junk.  I purchased a lowdollerr motorsports sensor. 
    • wedding eh.....I seem to get to more funerals than weddings or christenings these days....
×
×
  • Create New...