Jump to content
SAU Community

Recommended Posts

ok so i tried to start my car yesterday i unlocked it thus turning off the immobliser, as i tried to start the car the reds came on but as i turned the key to start everything went dead, the lights and my boost controler all still work but the car its self is dead and the alarm button doesn't unlock/lock the car.. I tried rermoving the battery still nothing so i left it and went out came home 5 hrs later the car unlocked and started..

Tried to use the car today same thing ive replaced the batterys in the key still nothing.. help any ideas would be great.

the car is a stagea rs260 with the stock immobliser that it came over with..

Thanks in advance for any help.

Link to comment
https://www.sau.com.au/forums/topic/331803-car-wont-start-help/
Share on other sites

clean your terminals..

actually reading that again - clarify dead?

lights on no start?

lights on turn key and lights out nothing happens?

bit more info.

two situations therer both with different solutions.

Edited by Chris Rogers

Ok i tried to start it today first go it started, i then removed the battery cleaned the terminals and tried to start again nothing.. By dead i meen no reds, no radio, when i turn the key to start it therse only a click in the passanger footwell and the headlights only go to parkers..

My boost controler will light up but as i try to start the car it goes dead aswell, the interia light works as does the beep when i put my key in..

When it started the first time my turbo timer counted down like i had turned off the car and then reset to zero all with the car still running..

most likely a dead cell in the battery or low current on it. or bad wire on the ground of battery, power fuse-able link wires on the positive side of battery

loose terminals ?

if the battery is older then a few years most likely shot. jap battery, most likely dead.

most likely only 9-10volts on it, or the current output is too low.

Edited by sapphiregraphics

Thanks for all the help guys she starts i checked all the connections and the battery voltage all good then an old nrma mate of my dads told me to chase down the immboliser module and disconect it and she started first go..

My question now is if i drive the car with the module disconected will it damage any other electrical components on the car..

Thanks again for all the help it saved me a lot of money :laugh:

So just by disconnecting an Immobilizer the car can start?

Whats the Point of an Immob?

So if i just go to my car and disconnect the wires to my immob (autowatch) the car can start? :)

doesn't sound like much of an immobiliser ..

So just by disconnecting an Immobilizer the car can start?

Whats the Point of an Immob?

So if i just go to my car and disconnect the wires to my immob (autowatch) the car can start? :woot:

Ok so ive done some digging as to why the car would start with the immboliser disconnected........

In the 90's the laws came in that most cars need a immboliser so car companys hired alarm campanys to fit the cheapest nastiest units to their cars with most only just making the standards and most not making the aus standards, all immbolisers that comply to our standards are safe..

Thus the jap immboliser in my car being cheap and nasty is why my car started when disconected....

my immboliser now is a club lock and a dirty big chain from the steering wheel to the brake pedal :) until i get an aus standard immboliser fitted..

Hope that put your mind at ease..

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hi...so a "development" here aswell The swap is "done" and car went "test drive" BUT it seems the clutch(maybe gearbox?) is a little bit sad? I bought this clutch kit https://justjap.com/products/xtreme-heavy-duty-organic-clutch-flywheel-kit-nissan-skyline-r31-r32-r33-push-type "Problem" is that the first gear is hard to put into and it seems that the clutch is not disengaged. It was not the problem with the old clutch...(or like sometime the first gear would not get as easy specialy when the fluid was cold) So? Can it be like...bad "install" or is the clutch wrong ((it should not have been) i done research to get the right one) Or is this "normal" with new clutch and needs to be break in? 
    • @Duncan I can try  and thanks i did not thought about VIN and part numbers for 33/34. @GTSBoy yeah it looks like iam gonna do that  
    • Forgot to include this but this is the mid section of my steering rack that looks like it has a thread/can be turned with that notch mentioned in the post:
    • Hey everyone, Wanted to pick some brains about this issue I'm having with rebuilding my 33 rack (PN is 49001-19U05). All of the tutorials/videos I've seen online are either R34 or S Chassis racks which seem to be pretty straightforward to disassemble but this process doesnt carry over to my rack. Few of the key differences that I've noted The pinion shaft on the other racks bolt on with 3 torx bolts: Whereas my rack bolts on with 2 allen head bolts: These changes are pretty inconsequential but the main difference is how you pull the actual rack out of the housing. The other skyline/s chassis racks can be taken out by tapping the rack out of the body with a socket and it just slides right out. I'm unable to do that with my rack because there's a hard stop at the end that doesn't let the seal/shaft be tapped out. Can also see a difference in the other end of the rack where mine has a notch that looks like you're able to use a big wrench to unthread 2 halves of the rack whereas the other racks are just kinda set in with a punch. My rack: Other racks: TLDR; Wanted to know if anyone has rebuilt this specific model of steering rack for the R33 and if there were any steps to getting it done easier or if I should just give this to a professional to get done. Sorry if this post is a bit messy, first one I've done.
    • I would just put EBC back on the "I would not use their stuff" pile and move on.
×
×
  • Create New...